Find the transfer function X (s)/F(s), then substitute for "s" a value equal to 0.5, and give your calculated value in 2 decimal places. Let M=14.9. *100 LARA 5 N-s/m M 2N/m 0000 An

Q: Simplify the following expressions to cd (w) (2 sin(2w)) S(w), what is the evalue

A:

Q: (Note: this is the same circuit as the previous question) Which of the following is the correct…

A: Given circuit,Asked to find the transfer function

Q: Q Find transfer function for the Electrical Cirruit below LI CI Ho Vilt) i(t) ² R₁ Ult)

A: In this question We need to determine the transfer function of the given circuit.  We know Transfer…

Q: → XCF) = SCf - 2000 +56(f+200) + [6(F-300)+ S(F+30) > XE) = 2-56(F-2000) +2-5 6CF+2000) + 1-5 6(F…

A:

Q: Problem 1 Determine the Nyquist rate for Continuous time signal s(t) = 5cos(50mt) +20sin(300mt) -…

A: Function is given as, st=5cos50πt+20sin300πt-10cos100πt.

Q: Q: Design ADC circuit for 0 to 3 amplitude signal with 256 output, use flash circuit.

A: Analog to digital converter (ADC): It is electronic equipment that converts analog signals like…

Q: Q3: Find the transfer function of the following system -7 1 19 u 1 X2 -43 -2 -5 -4 立, X1 + 2u Y= [1…

A: to find the transfer function for the given state space model

Q: Derive the transfer function for the circuit shown below R₁ Å} iz eo Gro e₁ E1(s) Eo(s) (Voltage…

A:

Q: Determine the power of the following digital sequence: x(n)=u(n)

A: It is given that: xn=un

Q: To produce a digital audio bit stream of an audio signal that contains tones at 350 Hz, 1000 Hz and…

A: Note: Relation between Sampling Frequency and Maximum analog Frequency Outcomes after…

Q: Determine the power of the following digital sequence: x(n)=u(n)

A: The solution is provided in the following section.

Q: Calculate the transfer function of the second order system whose unit step time response is shown in…

A: For the given step response of the system the second order transfer function needs to be calculated.

Q: dv(0+)/dt Which of the following is the dt value for the circuit below?

A: current througth capacitor = C dv/ dt where C is capacitance of capacitor and  V is voltage across…

Q: Question 2 Determine the input signal x2(n) if the convolution output is Y(u) with x1(w) (Hint do…

A:

Q: Aşağıdaki sistemin transfer fonksiyonu G(s)-X,(s)/F(s)%=? K1 = 4 N/m 0 K2 = 5 N/m fv1= 3 N-s/m M =1…

A: The detailed solution is attached with.

Q: a) C(s) =? R(s) G(s) b) E(s) =?

A: The above question is based on finding transfer function using block reduction technique. Transfer…

Q: Write the MATLAB program required to generate each of the following signals: 41 3.5 3 3 2.5 2 2 1.5…

A: 1 n=100;x0=3;y0=4;x=linespace(0,20,n);for…

Q: Determine the power of the following digital sequence: x(n)=u(n)

A:

Q: Find the transfer function, θ1(s)/T1(s) , for the fi- figure 2.32

A:

Q: In a 4-bit magnitude comparator with first input A= 1101 and second input B-1110, the output A> Bis…

A:

Q: e; R www C₁ C₂ R Co

A:

Q: A signal is given as x(t) = looks like this: = 4 cos(27800t + 6). After sampling and reconstruction,…

A: We are  given from the grapha) to determine the highest sampling rate fs b)

Q: OFDM is characterized by overlapped carriers none non-orthogonal carriers low spectral efficiency

A: The given question is a mcq type question and the detailed answer is solved below according to the…

Q: G1(s) R(s) + C(s) + G2(s) G5(s) G6(s) 니G3(s) G4(s) G7(s)

A: The solution is given below

Q: Input, u(t) G(s) = 4 s² + 2s + 10 Output, y(t)

A:

Q: Step Response System: 2 Time (seconds): 5.78 Ampitude 15 1.6 14 1.2- 1 0.8- 10.6- 0.4 02 10 15 20…

A:

Q: 1. You do not need to find the transfer function. 66 Ro G₁ Find all loops, Pk's, Ak's, and A for…

A:

Q: The hexadecimal equivalent of the signed magnitude representation of the decimal number -12 is

A: Given, Hexadecimal number is, -1216

Q: Determine the power of the following digital sequence:

A: In this case, the power of the signal xn=un is to be determined.

Q: Find the transfer function H(s). 10mH 10µF m VOUT 10Ω

A:

Q: Find the transfer function,ignoring all other capacities.Vout/Vin(s)=?

A: The amplifier circuit is given as AC parameter is also given as…

Q: Find the DFT transformation of the following signal. 1.1 x[n]= n , N= 4 1.2 x[n]= 2e?m (u[n -…

A:

Q: What is the fundemantel period of x[n], and what is the energy/ power of x[n], respectively x[n] =…

A: Here it is asked to get the energy or power of the mentioned signal. Here this is the periodic…

Q: Consider the analog signal xa(t) with spectrum: X₂(F) F (Hz) -40 40 This signal is passed through…

A: Given:Analog signal xa(t) with spectrum and its passed through the system below,we need to…

Q: signal systems

A: Conclusion:The value of the integral I is 0​.  Thank you

Q: Please answer in typing format

A: Step 1:Step 2:Step 3:Step 4:

Q: if q and c is constant what happens to delta t when q is doubled? (when using the equation q=mcAt

A:

Q: find The m and Draw The output signal of AmpsB Vc (t) = 8 cos2πxist Ac pm(t)

A: Given: vct=8cos2π×105t  and Ac=8 Volts.

Q: Question) x [n] and y [n] two discrete time signals of length 4, which are shown in fique Are those…

A: Given:Two discrete time signals x[n] and y[n] as, To find:Whether the given signals are orthogonal…

Q: For g(t)=4sin300rtt sin 700tt the Nyquist sampling rate is

A: The Nyquist sampling rate is two times the highest frequency of the input signal.