Find the height of the free surface if 0.8 cu.ft. of water is poured into a conical tank as shown in the figure. The cone is 20 in. high with a base radius of 10 in. (a) How much additional water is required to fill the tank? (b) If the tank holds 30.5 kg of salad oil, what is the density of the oil?

Q: displaces 1.0 cm², and the stem area is 0.1 cm². Find cht of the hydrometer. A = 0.1 cm² z = 5.3 cm…

A:

Q: There are four liquids that are to be poured in a single vessel that is located in an atmosphere…

A: The liquids will be arranged in such a way that the heavier liquid will be at bottom and lighter one…

Q: Oil flows through a 200 mm diameter pipe A at 2 m/s and through a 250 mm diameter pipe B at 1 m/s…

A: Given  Diameter of pipe A =200 mm

Q: . For the tank shown in figure below, determine the depth of the oil h if the reading of the bottom…

A:

Q: A liquid with a density of 900 kg/m³ flows straight down in a 6-cm-diameter cast iron pipe. Estimate…

A: Density of liquid, ρ=900 kg/m3 Diameter of pipe, D=6 cm=0.06 m Length of pipe, L=20 m Average…

Q: Determine the pressure required to reduce the given volume of water by 1 % (Bulk modulus or…

A: Given data in question  Bulk modulus 2×108 N/m2 Reduction volume ratio 1% = 0.01 To find out…

Q: A 400-gallon capacity tank initially contains salt solutions consisting 150 gallon of water and 25…

A:

Q: What is the volume flow rate of oil in gallons per minute

A:

Q: please solve

A: Step 1:Step 2:Step 3: Step 4:

Q: If a certain liquid weighs 6.80 kN/m³. Compute the following: 1) Mass density in kg/m³ . 2)…

A:

Q: vertex. 1. Find the volume of its content in m³.  a. 0.318 b. 0.357 c. 0.453 d. 0.678 2. Find the…

A: Step: 1 Cone: - It is defined as a structure whose shape tapers smoothly from base to vertex. Cone…

Q: a) What is the volume flow rate of oil in the channel? b)What is the mass flow rate?

A: Given data, Rectangular channel Width B = 1.5 m Depth z = 30 mm = 0.03 m For SAE 10 oil at 20°C…

Q: 2. A cylindrical tank 1.5m in diameter contains a column of 3 immiscible liquids with SG 0.8, 1.0,…

A:

Q: A cylindrical tank contains 810 liters of solution, with 58 kg of solute A dissolved in it. A…

A:

Q: 2. Determine the height of the water from the right leg if the liquid added in the left leg has a…

A:

Q: An oil of sp. gr. 0.9 is contained in a vessel. At a point the height of oil is 40 m. Find the…

A: Specific gravity of oil = 0.9Height of oil = 40 mCorresponding height of water =?

Q: For the same condition as the previous problem (After a solid block is put on a scale in the water…

A:

Q: find the force ate.

A: To find : Force exerted by oil upon gate  Given: pipe line which is 6 m in diameter contains a gate…

Q: Determine the mass density, specific weight, and specific volume of the oil acting on a plate.

A:

Q: 2. Given: Process tank shown below Find: (1) total surface area and (2) volume 3m3 m- 6m 4 m

A: Consider the given tank which has two shape i.e. cube and cone a=side of square =6 mh=height of…

Q: A hydraulic jack contains 2.0 litres of oil as the working fluid. The compressibility of the oil is…

A: Finding out absolute decrease in the volume of the oil.

Q: Consider a vertical pipe of diameter 3.136 mm. Through this pipe kerosene (density 963 kg/m3 and…

A: Given data in question  Pressure at below point Diameter  Discharge  Density of oil To find out…

Q: A circular vessel 2 m in diameter and 3 m high is filled with three liquids standing 1 m high each.…

A: Given data in question  Diameter and height of vessel Relative densities Area of orifice Constant…

Q: As shown in the accompanying Carbon Tetra Chloride (Sp. Gr. 1.594) figure, pipe M contains carbon…

A:

Q: 6. A tanks initially holds 100 gallons of salt solution in which 50 bs of salt has been dissolved. A…

A: Let  Q = Amount of salt in the moisture 100 + (3-2)t = 100 + t = Volume of mixture at any time t…

Q: An clectrostatic precipitator is being designed to operate at an efficiency of 97%. Using the…

A:

Q: diameter = 60 cm height = 60 cm The open cylindrical tank is two-thirds full of water.…

A: Use general equation of pressure

Q: Problem 2 For the closed tank with Bourdon-tube gages tapped into it, what is the specific gravity…

A:

Q: a) A gasoline with a kinematic viscosity of v = 5 x 10-7m2/s flows in a 200- mm-diameter smooth…

A:

Q: B-A thickener is designed to separate suspension containing 15 Kg of water/Kg of solid is to be…

A:

Q: Oil (density = 846 kg/m³ and kinematic viscosity = 6.2e - 4 m²/s) is being discharged by a 49 mm…

A: Dynamic viscosity is defined as that the resistance that is provided in the movement of the one…

Q: A tank contains 200 liters of fluid in wich 30 grams of salt in dissolved. Brine containing 1 gram…

A: ASKED: To determine the amount of salt (in grams) in the tank at any time t.   Given, Initial volume…

Q: Solve and Draw the figure completely labelled with all the notations used in your solution. A 100…

A:

Q: Q3/ A) Five Liquids of different specific gravity G are put in an open Tank shown in Figure (3). The…

A: Top to bottom order 1.Liquid Number 2 heavy oil G=0.9 2.liquid number 4 river water G=1 3.liquid…

Q: e second is kerosene (ρ=1.591 slugs/ft3), the third is castor oil (SG=0.959), and the last liquid is…

A:

Q: SITUATION 4. AN OIL WITH SG = 0.86 FLOWS THROUGH A PIPE 30in. IN DIAMETER AT 700gpm 5. Determine the…

A:

Q: ight solid hemispherical blocks each of diameters 4 cm are dropped into a hemispherical vessel…

A: Given data: hemispherical vessel radius: 8 cm solid hemispherical block diameter: 4 cm 8 number of…

Q: Oil (SG=0.8) discharges from a 250mm diameter pipe through a sharp-crested orifice whose dia is…

A:

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?