Answered: Find the charge q(t) and sketch its… | bartleby

Related questions

Question

Find the charge q(t) and sketch its waveform when the current entering a terminal of an element is as shown in Figure P1.2-7. Assume that q(t) = 0 for t < 0.

i (A)
3
2
1
1
Figure P 1.2-7
2
3
4
t (s)

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

Please answer only b
Take into account a wire made of aluminium with radius 0.001m. If there is one conductium electron per atom in aluminium, calculate the current density corresponding to the 0.001A of current. Find the drift speed of conduction electrons for this current.
A student measured the potential difference between two ends of a straight wire of length 0.50 m and diameter 2.0 mm for different electric currents running through the wire. The student plotted the potential difference (in volts) as a function of the electric current (in ampères) with the goal of calculating the resistivity of the material. The graph, including the trendline, is shown in Figure 2b. Based on this experiment, the resistivity of the material is: 1.68 x 10-6 Q m 4.19 x 10-5 0 m 1.68 x 1052 m 0.00419 2 m 4.19 x 10-7 o m O 0.00168 Q m 1.33 x 10-7a m 1.33 x 10-8 o m AMoving to th e poxt question provopts cha ngos te this answor
A cylindrical rod of semiconducting material with length L and cross-sectional area A is doped so that its resistivity varies with position along the rod as ?(x) = ?0exp(-x/L) where x=0 is at one of the rod's ends. If the rod has a voltage drop of V = 23.3 V across it, evaluate the current I through the rod and fill in the missing numerical factor below. I = ( )A/(?0⋅L)
IF a alloy containing a resistivity of 1.1 × 10−6 Ωm. From a roll of wire of 2 mmdiameter, a length 1.5 m long is taken. if a secon piece containing the same length being 1.5 m is connected parallel to the first. A what would its resistance be but also the conductance of the pair.
a a 151 L'ingl b с C Fig. 2-1 ↑ B wond
Problem 5: A nichrome rod of length LN 58 cm is connected in series (end to end) to a carbon rod of length Lc 8 cm. Both rods have cross-sectional areas of A 55 mm2. At T0 20° C the restístivity of nichrome is ρΝ-1.50 x 10-6 Ω-m and the resistivity of carbon is pc 3.50 x 10-5 Q-m. The temperature coefficient of nichrome is positive with value a-0.4 x 10-3 °C-1. The temperature coefficient of carbon is negative with a value ac--0.5 x 10-3 °c1. The nonlinear dependence of the resistivity on temperature T can be written as ρ ea(T-To) .odu @ theexpertta.com - tracking id: 2N74-2F-82-4A-BAAB-13167. In accordance with Expert TA's Terms of Service. copying this information to any solutions sharing website is strictly forbidden. Doing so may result in termination of your Expert TA Account. A Part (a) Write an expression for the total resistance of the nichrome-carbon combination as a function of temperature in terms of quantities given in the introduction. Simplify your answer as much as…
A cylindrical, non-ohmic, uniform conductor is placed in a uniform electric field that points from bottom to top along the axis of the conductor, which is aligned with the z-axis. Which of the following statements is correct (select all that apply)? O The current density is proportional to r (the radial distance from the axis) The current density is proportional to the cube of the conductor's radius O The current density is proportional to the conductivity O The current density is inversely proportional to the cross-sectional area of the conductor
A tungsten wire at with length, L = 1.83 m, carries a current with density, J = 1.35 x 107 A/m², at a temperature of 20°C, where its electrical conductivity is a = 1.80 x 1072-1.m-1. (a) Write a symbolic expression for the electric field strength in terms of J, σ, and L (as needed) then calculate its numeric value. J E = J = 0.75 o Getting Warm (2 of 3) The resistance of the wire at 20°C is determined to be R = 0.196 2. | = 0.75 V/m ✔ (b) Write a symbolic expression for the current in terms of J, 0, L and R (as needed) then calculate its numeric value. A
What is the resulting current (in A), if 0.6 C of electrical charge is transferred in 64.2 ms? Provide a numerical answer without unit to at least 2 decimal places.
Suppose the current in a conductor decreases exponentially with time according to the equation I(t) = I,er, where I, is the initial current (at t = 0), and t is a constant having dimensions of time. Consider a fixed observation point within the conductor. (Use the following as necessary: I, and t) (a) How much charge passes this point between t = 0 and t = t? (If applicable, round any coefficients to 3 decimal places.) Q(t) = (b) How much charge passes this point between t = 0 and t = 10t? (If applicable, round any coefficients to 5 decimal places.) Q(10t) = %3D (c) How much charge passes this point between t = O and t = o? (If applicable, round any coefficients to 3 decimal places.) Q(0) =
The resistivity of a metal increases slightly with increased temperature. This can be expressed as p=po [1+ a(T-To)], where To is a reference temperature, usually 20°C, and a is the temperature coefficient of resistivity. For copper, a=3.9x 10-3 °C-1. Suppose a long, thin copper wire has a resistance of 0.25 at 20°C. Part A At what temperature, in °C, will its resistance be 0.25 ? T= Submit 5 ΑΣΦ V Request Answer ? °C

SEE MORE QUESTIONS