Find a single equivalent damping constant for the following cases: a) When three dampers are parallel. b) When three dampers are in series. c) When three dampers are connected to a rigid bar in the figure and the equivalent damper is at site c1.

Q: ses an oscillator motion as shown in the Figure.8. Your manger asked you to v our analysis for the…

A:

Q: Classify structure shown in Figure as statically determinate, statically indeterminate, or unstable.…

A: Find the structure is statically determinate, statically indeterminate or unstable.     Compare with…

Q: Figure Q9 shows part of a system with many degrees of freedom. Write the equation of motion for mn.…

A:

Q: D. Figure P1 below shows a block of massm that is attached to two ideal orings and viscous damper.…

A:

Q: Consider the following spring system. Assume down is the positive direction. Write the stiffness…

A: Given Data: c=1341f=-1-1   To Find: (a) The stiffness matrix. (b) Displacements caused by the…

Q: Consider the system shown in the figure below. The mass Ma=1 Kg, the mass Mb=2Kg. k1 =1N/m and…

A: To obtain the velocities of masses A and B, we must calculate the acceleration first, and then…

Q: 1. A planar mechanism is designed to have two branches symmetrical to the centerline as shown.…

A:

Q: An eyebolt is subjected to four forces as shown in figure. F_{1} = 12kN F_{2} = 8kN F_{3} = 18kN ,…

A: Given DataF1=12kNF2=8kNF3=18kNF4=4kNα1=45α2=100α3=205α4=270

Q: For the spring assemblage shown in the figure above, obtain the global stiffness matrix by the…

A: The direct stiffness technique is a matrix approach that uses members' stiffness relations to…

Q: You have to design a structure of a thin rectangular beam supporting a lamp with a mass of 20 kg as…

A: Given , Mass of the lamp ,m = 20 kg Modulus of elasticity of the beam  , E =200 GPa. Length of the…

Q: Solve it correctly and fast please. I will rate and review.

A: GIVEN DATA - A spring system is given in question with constant K=23N/m We have to find Equivalent…

Q: Two masses m are attached to opposite sides of a rigid rotating shaft in the vertical plane. Another…

A: **According to the guidelines we can answer one question at a time please resubmit to get the answer…

Q: A planar closed kinematic chain is formed with rigid links PQ = 2.0 m, QR = 3.0 m, RS = 2.5 m and…

A: Given data: PQ=2.0 mQR=3.0 mRS=2.5 mSP=2.7 m Need to find that which link should fixed to obtain the…

Q: Speed of rotation of the conical pendulum is increased from 75rpm to 90rpm. Find the difference…

A: Initial Speed of rotation of the conical pendulum = N1 =75 rpm  Final Speed of rotation of the…

Q: Q.1 Develop an analytical reasoning to prove that the mechanism as shown in Figure.1 have mobility.…

A: To determine:To calculate the mobility

Q: Fo sinot

A:

Q: A hydraulic pump mechanism is modeled as shown in the Figure 2. Consider the motion of the mechanism…

A: A0A=a1=20mmA0B0=a0=140mmAG3=b1=80mmG3C=b2=20mmm2=2kgm3=1kgm4=1.2kgk=100N/m

Q: Consider the mass-spring system in Figure 1. For the system shown in Figure 1, suppose that k₁=k,…

A:

Q: Derive the equivalent spring constant for the system in the figure.

A: Given data: Length of beam=b Need to determine the equivalent spring constant.

Q: Assume zero initial conditions and no damping and solve for the response of a mass-spring system to…

A: using the principle of superposition

Q: A mass, m, is supported on a light beam, which is free to rotate about the pivot at O as illustrated…

A:

Q: Q1: Classify the structure shown in Figure (1) as statically determinate, statically indeterminate,…

A:

Q: chanism shown in the figure r2 = 30mm, r7 = 110 mm, r3 = 120 m P = 100 mm, AC = 60 mm and r5 = 130…

A:

Q: Q1: The system shown has two masses. Beam of mass (Jo#m L² kg.m²) rotates about fixed point (O) and…

A: The mass moment of inertia of the beam is The mass moment of inertia of the disk is,To find the…

Q: Identify the following systems shown below: Picture Answer Picture Answer 1. 2. 4. 6. 3. 5.

A: On its rim, a pulley holds a flexible rope, cord, cable, chain, or belt. Pulleys are used to convey…

Q: Consider the set – up where glycerin is poured in this U- shaped tube. It oscillates back and forth…

A: Given: The mass of glycerin for 1 cm glycerin column, m = 20 g

Q: Derive and compute the value for equivalent spring stiffness and equivalent force, F as shown below.…

A:

Q: roblem B-8-8 A mass of 20 kg is supported by a spring and damper as shown in Figure 8-28(a). The…

A:

Q: 1. Consider the system shown in the Figure P1, where ky is torsional stiffness. Assume that the…

A:

Q: Find the values of a₁, 02 and as for the semidefinite system with J₁ = J₂ = J3 = Jo, kt1 = k₁, and…

A:

Q: Calculate the damping rate for the system shown in the figure. Friction effect on supports will not…

A: Answer: Option B is correct.

Q: ) Find the equation of motion of the system in terms of the given parameters. b) Since M=4 kg, m=1…

A: For solution refer below images.

Q: Figure 1.1 shows a crank, OA = 72 mm long which rotates anticlockwise about 0 at w = 150 rev min A…

A: Refer the answer in the next page.

Q: Question A & B (2 Parts) Solve carefully and label both parts (circle final answer(s) (Use image…

A: The mass displacement is proportional to the spring force. The viscous damping force is related to…

Q: 4 = k = k

A: Given

Q: the equivalent spring constant for below if the constant spring is 80 ?N/m 1/11 k1 m3 k3 k6 m1 k4 m2…

A:

Q: Q2/Derive the equations of:( free undamped + free dampe d +force ( undamped + forceundamped Q3// The…

A: As per given Question  Mass=40kg Spring constant =800N/m We have to determine damping coefficient…

Q: 6. Consider the set – up where glycerin is poured in this U – shaped tube. It oscillates back and…

A:

Q: em as shown below. Assume that all free nodes undergo translation in x (1 DOF at each node) and…

A:

Q: ! Required information A helical compression spring is wound using music wire of diameter, d, 2.16…

A: k =135.42 N/mmExplanation:k =135.42 N/mm

Q: Determine the following given the figure below: a. Equivalent stiffness b. Angular frequency c.…

A:

Q: The system is now modified, with different values of spring stiffness and damping coefficient…

A: Given:To find:Steady state amplitudePeak amplitude

Q: Degree of Freedom - Free Undamped Vibn ostant. Car mass X2 k Car spring 2k M2 M2 Tyre mass 2m k2 X2…

A: For 11 problem, the answer given for 2nd mode shape is not correct. I solve that correctly in below…

Free Damped Vibrations

Free vibration is a type of vibration in which the external force is removed after giving the initial displacement to a body/system. In other words, in this type of vibration, force is applied at the initial displacement of the system, and after the initial displacement, force is removed, and the system vibrates at the natural frequency.