For the spring assemblage shown in the figure above, obtain the global stiffness matrix by the direct stiffness method. Let k(¹)= 4 kip/in., k(²) 6 kip/in., k(4) – 7 kip/in., k(5) – 8 kip/in. = = = [K] = = kip in. : 5 kip/in., k(³) =

Q: LESSON: AUTODESK AUTOCAD Choose from the choices:

A: The broken line is used to draw the large drawings which are not possible to draw on the sheet,…

Q: Draw the following using the given figure: 1. 45-degree CAVALIER 2. 45-degree CABINET OBLIQUE 3.…

A: Find 1. 45-degree CAVALIER 2. 45-degree CABINET OBLIQUE 3. Isometric Drawing

Q: solve and show every step with right answer

A: Data given - Rectangular cross section 225×75 mm2 Torsional moment = 20kN Axial Compressive force =…

Q: 2 Constraint indicated the name and where it should be

A: Given: To find: Where the constraint should be

Q: 3. if you had to lift a truck and had a pole, a rope and a fulcrum, you could do it! A kid could do…

A: for third kind of lever fulcrum lies at one end and object other...

Q: Given the front, top and side views of the drawing add the missing lines (center, object, and…

A:

Q: 2 ft 2 ft 3 ft A 6 ft

A:

Q: Can you show the work but written out please so I can see the steps better.

A:

Q: What is Line J? ARROWHEAD .35mm A 7.0 В

A: Solution:

Q: Draw an orthographic(three-view drawing) of the four objects including front, top, and right views

A:

Q: A2.1 Please help. Written on paper not typed on computer or keyboard please. Need help both…

A:

Q: Use the image below to do the following  i.  draw 3 positions on a piece of paper. ii.  Chose a…

A: Find three positions and corresponding distances based on the reference point.Alos find linear…

Q: What is Line G?

A: Solution:

Q: Interpret the significance of the letters shown in the illustration

A: Instruction given at tail of the welding symbol is "See detail A".Here detail A will have the…

Q: many hours did the carpenter work on the job? 6. What is the area of a rectangular floor that is…

A: Q.6 Given data as per question Length of floor = 7’-3” Width of floor = 4’-2”

Q: Q1: Use scale (1:1), draw the front, top & side views of shape shown below. (50 M)

A: Orthographic Projection It is a form of presenting a three-dimensional object into Two dimensional.…

Q: Please turn this into 3d drawing, measurements are not important.

A: According to the question We need to find 3-D model of the drawing

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.