Filamentous bacteria 1. Proliferate in low F:M ratio 2. Proliferate in high F:M ratio 3. Enhance settling in the secondary clarifier 4. Cause bulking of sludge resulting in high solids concentration in the effluent O 2, 3 and 4 O 2 and 4 O 1, 3 and 4 1 and 4

Filamentous bacteria 1. Proliferate in low F:M ratio 2. Proliferate in high F:M ratio 3. Enhance settling in the secondary clarifier 4. Cause bulking of sludge resulting in high solids concentration in the effluent O 2, 3 and 4 O 2 and 4 O 1, 3 and 4 1 and 4

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

• Q-3. Settling characteristics of a conceritrated suspension C = 3000 mg/t were deterrmined in a laboratory study. The suspension was settled in a colurmn 100-centimeters high, aind thé height of the interface h, was recorded with tirme Time, minutes 100 79 60 10 15 38 20 25 23 15 30 12 35 40 50 7.5 Calculate the area required to achieve clarification and to yield a thickeried sludge concentration of 25,000 mg/f- for an inıfluent flow rate of 5 mgd.
A UF system reduces turbidity from 121 to 11 NTU. Which one of the following shows rejection? - 90 O 90.9 O 0.90 0.909
A PFR is not meeting effluent requirements so baffles are going to be added to the tank toincrease contact time. The tank is 12 ft deep, 40 ft wide, and 120 ft long. The engineer isgoing to add long baffles to the tank. The baffles will be 90% of the tank length. If thecurrent HRT is 0.5 d, and the influent concentration is 9 mg/L with an effluent limit of 1.5mg/L, how many baffles need to be added? Assume k=1.98/day
Medium oil having a sp.gr. of 0.90 flows through a 120mm diameter pipe with a mean velocity of 5.3m/s and friction factor of 0.01. Oil has an absolute viscosity of 0.04 Pa.s. Ccompute the shear stress at the wall of the pipe
Problem 2. A reverse osmosis membrane has a kw values of 2.5-10 L/(m²-s-bar) and an average ks value of 3.5.10+ L/(m²-s). Find the expected permeate salt concentration of chloride if the feed concentration is 4500 mg/L, the system operates at a gauge pressure of 35 bar on the feed side of the membrane, and 95%. Assume the permeate has a negligible osmotic pressure. Answer: 171 mg/L.
Sub: Seperation Process A mixture of solid particles, consisting of silica (B) and galena (A), with particle sizes ranging from 1.27 × 10^2 mmto 5.08 × 10^2 mm, is intended to undergo hydraulic classification. This process involves free settling in the laminarregion within water at a temperature of 293.2K. The specific gravity of B is 2.65, while that of A is 7.5. (a) Determine the size range for the various fractions obtained during settling. (b) Calculate the terminal settling velocities vt(m/s) for particles A and B within the size range of 1.27x10^2 mm to 5.08x10^2 mm. (c) Utilize Excel or other contemporary tools to plot a graph of vt(m/s) against particle diameter Dp (m) for the specified size range of particles A and B. (d) Establish the similar values of vt(m/s) for both A and B from the plotted graph. Verify these values through calculation. (e) Compute the value of the largest Reynolds number observed. (f) Based on the information presented in (c) to (e), elucidate this…
Water quality and characteristics discuss: 1. Organoleptic parameters 2. Nitrate 3. Solids
Seepage force per unit volume can be expressed as (A) iy„L (B) iL (C) Y,h (D) iy.
Problem 7-29 The initial ultimate BOD after mixing of the Noir River is 50 mg/L. The DO in the river after the wastewater and river have mixed is at saturation. The river temperature is 10 °C. At 10 °C, the deoxygenation rate constant ka is 0.30 d-¹ and the reaeration rate constant k is 0.30 d-¹. Determine the critical point to and the critical DO.
i need the answer quickly
A given sludge with 98% moisture content is X times more bulky than with 95% moisture content. The value of X is ______
In a municipal wastewater treatment plant, the influent flow rate into a complete mixing activated sludge system is 50 L/sec, its solid concentration MLSS is 30 mg/L, and the BODs in the influent is 245 mg/L. The MLSS concentration at the bottom of the secondary clarifier is 15,000 mg/L and 10 mg/L at the top of the |clarifier. The flow rate of returned activated sludge is 20 L/sec. a. What is the concentration of the MLSS in the activated sludge reactor (assuming that it is fully mixed and has constant concentration)? b. What is the activated sludge basin volume if the hydraulic retention time in the basin is 10 hours and the system is operated at the R/Q ratio given in the problem? |c. If the cross section of the basin is 20 m² (perpendicular to the flow), how long the basin will be? d. The plant has 96% BOD5 removal. What is the effluent BOD5? e. The flowrate of the waste activated sludge (WAS) is 0.2 L/sec. How many solids (in kg) are wasted every day through the secondary…