Figure Q3 shows a cylinder with a diameter of 80 mm and a mass of 70 g. If it is placed in the tank, which contains oil and water. Calculate the height above the surface of the oil at which it will float if maintained in the vertical position. Take the density of oil as Po 980 kg/m³.

Q: A fluid at 20°C has a viscosity of 0.007 Poise. What shear stress in Pa is required to deform this…

A: Given: strain rate = 294000/min Viscosity = 0.007 poise

Q: For your MQP project you are asked to study fluid (wind) flow over the tall cylinder shaped…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: b) Assume standard atmospheric condition. Determine the pressure in kN/m² for the pressure below: i.…

A:

Q: in fig below, fluid A is water (PH2o = 62.1lbm/ft^3), fluid B is mercury (PHg = 0.4888lbm/in^3).…

A: GivenρH2O=62.1 lbm/ft3ρhg=0.4888 lb/in3=0.4888×123 lb/ft3=844.6464 lb/ft3z=4.5 ft

Q: What are the eregies that a fluid in motion may have?

A: Fluid:-A substance that may flow and adopt the shape of its container is called a fluid. It consists…

Q: (Q3] (a) The wooden rod AB supports the roof ADC. If the mass of roof is 70 Kg and its weight acting…

A:

Q: Based on the following figure and its description, answer Q1, Q2, Q3, Q4 and Q5. Isosceles…

A:

Q: Because of the additional equipment installed, it requires an additional flowrate of 800 CFM. The…

A:

Q: explain mean piston speed with an example and elaborate your answer with proper explanation

A: Solution:

Q: 3. A capilary tube of inside diameter 6 mm connects tank A and open container B, as shown in figure.…

A:

Q: Water is flowing in a rectangular channel that has a width b, = 3 m with a depth y, = 1 m. Then the…

A: From the tables, At section 1, Froude number F1 = 2.99 F1 is greater than 1, it means that flow is…

Q: The pump shown draws water from reservoir A at elevation 10 m and lifts it to reservoir B at…

A:

Q: 4.43 A hydraulic accumulator is designed to reduce pressure pulsations in a machine tool hydraulic…

A:

Q: The Fink truss is supported by a hinge at A and by rollers on a 1 to 2 slope at B. The bracing bars…

A: FBD of given diagram

Q: 3. A square block is weighing 300 N and having a length of 20 cm on one edge slips on a 20° inclined…

A: Given data: F=300 NL=20 cmθ=20°t=1 mm Need to determine the terminal velocity of the block down the…

Q: 6.28 This planar water jet (60°F) is deflected by a fixed vane. What are the x- and y-components of…

A: To solve this question I have applied the continuity equation and force momentum theorem for the…

Q: What trend did you notice in the yaw angle-induced error?

A: introduction; yaw angle error is misalignment of the rotor from the wind direction.

Q: Explain any 2 basic fluid concept with application and neat Long Answer

A: we are to explain 2 fluid concepts and their applications

Q: A velocity field V = (x - 2y)ỉ - (2x + y)¡ given in the form. a)specify how many directions is the…

A:

Q: a) Air enters a converging-diverging nozzle with negligible velocity and exits the nozzle at 500 K…

A:

Q: 1. Name the direct measurement and indirect measurement rock and fluid properties.

A:

Q: 1.10 The pressure rise Ap associated with wind hitting a win- dow of a building can be estimated…

A:

Q: 3. Water is flowing steadily in a 5-cm-diameter and 60 m long horizontal pipe at a rate of 6 L/s.…

A:

Q: [2] Using the method of joints, determine the force in each member of the truss shown State whether…

A:

Q: Describe an everyday situation in which one might want to use any of the "fluid" equations. Please…

A: There are vast applications of the fluid equations in our day-to-day life as we are living in fluid…

Q: Consider the pump shown in the figure. The water enters a filter before entering the pump. As the…

A: The conversion of mechanical energy to hydraulic energy by means of the machine (hydraulic) is…

Q: Identify the missing properties of the fluid whose properties are given in the table. Specify the…

A:

Q: b) A 4 m long and 2 m wide plate shown in Figure Q1(b) is positioned in seawater flowing at 1.5 m/s…

A:

Q: Identify the type of Non-Newtonian fluid for each household product:…

A: The type of fluid which does not obey the Newton's law of viscosity is called Non-Newtonian fluid.

Q: A solid object with hemispherical bottom floats in a liquid (s = 1.25) with 100 cm projecting above…

A: GivenS1=1.25S2=1.50r=1m

Q: QUESTION 1 The Reynolds number can be viewed as the ratio of O Drag force/Dynamic force O Buoyancy…

A: Dear student,                      According to the guidelines, I am allowed to answer only three…

Q: please, i need to see how did you get to this formula

A: ◆ The purpose of using this formula is to avoid complex calculation and to get the answer in minimum…

Q: Elevation = 0 m (Datum) Elevation = 200 m Dia = 0.8 m Pump Dia = 1.0 m L = 500 m L = 200 m Elevation…

A: To perform ""Since you have asked multiple questions, we will solve the first question for you. If…

Q: A 1.5-in-diameter water jet with a velocity of 100 fps impinges on a single vane moving in the same…

A: From the given data:

Q: why Fluid Mechanics:Fluid in motion related in maritime industry

A: Fluid Mechanics: Fluid in Motion related in maritime industry The study of the effects of forces and…

Q: An airfoil has a lift curve slope at 7/rad and angle at zero lift of -3deg. At what angle of attack…

A: Given:Lift curve slope, q=7/rad1 rad=57.296 degq=0.122/degαo=-3 degL=120 lb/ftV=110 mph or 161.333…

Q: ( computational fluid dynamics question) Question:  If the calculations lag behind the flow of…

A: Fluid dynamics, for example, may be used to study the flow of air over an aeroplane wing or the…

Q: 2. Density Units Gram/milliliter Pound/inch cube Ib/in Kilogram/meter cube Pound/foot cube g/ml 32…

A: Considering the given data from the table The basic method applied for the unit converson is…

Q: 6. The timber beam has a cross-sectional area of 2000 mm? and its modulus of elasticity is 12 GPa.…

A:

Q: The aircraft is flying at a velocity of 50 m/s, at an altitude of 4500 m. Determine the lift/span…

A: Given data: v=50 m/sw=3 mL=13 m Need to determine the lift created by the rectangular wing.

Q: A hovercraft weighs M 1500 kg and hovers without changing altitude. The exit flow exhausts to…

A:

Fluid Kinematics

The branch of science that deals with objects which are either in motion or stationary are studied under the branch of classical mechanics. Fluid mechanics is a subcategory of classical mechanics that deals with the behavior of fluids at rest (fluid statics) or in motion (posing some velocity). In fluid kinematics, studies focus on the associated motion of fluid particles or groups of particles, and its associated parameters like displacements, velocity, and acceleration without concerning about the forces that caused the motion. All the laws of classical mechanics are applied in the study of fluid kinematics.