Consider the pump shown in the figure. The water enters a filter before entering the pump. As the water passes through the filter, the internal energy of the water is increased by 50 J/kg due to friction. At the same time there is a heat conduction loss from the water of 250 watts. Determine the following: VA VB Wpump m/s m/s kW 150mm FILTER 50mm B ATUM

Consider the pump shown in the figure. The water enters a filter before entering the pump. As the water passes through the filter, the internal energy of the water is increased by 50 J/kg due to friction. At the same time there is a heat conduction loss from the water of 250 watts. Determine the following: VA VB Wpump m/s m/s kW 150mm FILTER 50mm B ATUM

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

It is desired to rehydrate 10 kg of dried mangoes (3% dry basis) to a moisture content of 80% wet basis. How much water must be added and what is the weight of the rehydrated mangoes? (Write "done" in the answer box when done solving") A pump with a shaft input of 45 KW and efficiency of 70% is connected in a waterline carrying 0.10 m3/s and delivers it to the washing plant of a certain canning industry. The pump has 120 mm diameter suction line and a 150 mm diameter discharge pipe. The pressure gage attached to the suction line is located at 200 cm below the centerline of the discharge pressure gage and reads –500 mmHg. The pressure gage attached to the discharged pipe is located 140 cm above the centerline of the pump. Neglecting friction, calculate the discharge pressure in kPa. Mango juice puree with a specific gravity of 1.48 and viscosity of 26.7 cP is flowing in a 35 mm diameter pipe. If the puree flow rate is 1000 L/min, determine the pressure drop due to friction for a 100…
The cylindrical in the figure is filled with 31.4 m3 of water at t = 0. The radius of the tank is 1 m and its height is 10 m. There is an outlet line with a radius of 0.1 m at the bottom of the tank. What is the time required for half of the water in the tank to drain after the outlet line is opened? The flow velocity of water from the bottom of the water tank is related to the height of the water in the tank, and this relationship is expressed by the formula v: (m / sec) linear flow velocity, g: gravitational acceleration (10 m / sec2) and h: (m) height.
Water with a specific heat of 1 BTU/lbmoF is pumped using a 1-hp jet pump from a well that is 20 ft deep into a vented water vessel 160 ft above the ground. In the process, 400 BTU/min of heat is lost from the system. What is the temperature (oF) of the water as it enters the vessel if the flow rate of the water is 5 gal/min? Assume the temperature of water in the well is (35oF).
A pipe set up is given as seen in the figure. The fluid is oil with a specific gravity of 850 kg/m³. The pressure at the exit is atmospheric pressure. The diameter at the entrance is 6.4 cm and the diameter at the exit is 2.2 cm. The volume rate of flow is given as 0.0315 m³/s and thegage pressure at the entrance is 250 kPa. Ignore weight of the fluid and the pipe. Determine the x-component of the force applied at the bolts at section 1. Assume that the atmospheric pressure is 1013 mb. 40° 2
A reservoir of 20oC water is pushed at a rate of 5 kg/s to a 3 in Sch. The 40pipe is linked to a relatively big storage tank. The tank is 7 meters away from the reservoir, and the pump, which produces 30 kW of power, is positioned on its side. Heat is absorbed by the fluid at a rate of 3.5 kW. Calculate the temperature of the receiver tank.
Water is to be pumped from the bottom of a well 20 ft deep and 160ft above the ground with a specific heat of 1 BTU/lbm F is pumped using a 1-hp jet pump. Heat is lost from the whole system at the constant rate of 500 BTU/min. What is the temperature (℉) of the water as it enters the vessel if the flow rate of the water is 5 gal/min?assuming that the well water is at 35℉? kindly show all necessary calculations
For the system shown in the Figure, Reservoir I has a water depth of 7 m and Reservoir 2 has a water depth of 8 m. The bottom of Reservoir 2 is at an etevation of 20 m above the bottom of Reservoir 1. The pump is required to deliver 400 1/s of water from Reservoir I to Reservoir 2. Given that the total energy loss in the system is 5 J/N, how much power must the pump deliver? Give your answer in kW to one decimal place. Reservoir 2 pump Reservoir 1 Power (kW) Round your answer to I decimal place
On a hot summer day, the air in a well-sealed room is circulated by a 55 W fan (Note that the motor delivers 55 W of net shaft power to the fan). A anemometer sensor measures 13 m/s air velocity at a rate 0.5 m3/s (air density is 1.15 kg/m3). If the mechanical efficiency and flow efficiency are the same, calculate this efficiency and than give the rate of the electric energy .supply to the fan motor None of these .a W 216 b W 69.5 .c W 73 .d W 62 .e W 87 .f
A gardener is thinking of installing piping system for watering the plants in his garden located near a water reservoir. The reservoir is located at an elevation of 150 m above from the surface, as shown in figure. The diameter of pipe (cast iron) is constant equal to 15 cm and total length of pipe is 180 m. It is desirable that the exit velocity of water to the garden should not exceed 5 m/sec and water is at atmospheric pressure and temperature is 20°C. The gardener is planning to open the valve for 3 hours daily. Calculate the followings: a) How much volume of liquid can be drawn from reservoir in a day? b) How much total irreversible head loss will be occurred in the system?
Water with a specific heat of 1 BTU/lbm F is pumped using a 1-hp jet pump from a well that is 20 ft deep into a vented water vessel 160 ft above the ground. In the process, 900 BTU/min of heat is lost from the system. What is the temperature (F) of the water as it enters the vessel if the flow rate of the water is 5 gal/min? Assume the temperature of water in the well is (35 F).
A water initially contains 140 L of water. Now equal rates of cold and hot water enter the tank for a period of 30 minutes while warm water is discharged from the tank at a rate of 25 L/min. The amount of water in the tank at the end of 30 min period is 50 L. The rate of hot water entering the tabk in L/min is (WITH FREE BODY DIAGRAM) CHOICES: A.7 B.5 C.11 D.25
The cylindrical in the figure is filled with 31.4 m3 of water at t = 0. The radius of the tank is 1 m and its height is 10 m. There is an outlet line with a radius of 0.1 m at the bottom of the tank. a. What is the time required for half of the water in the tank to drain after the outlet line is opened?b. The flow velocity of water from the bottom of a water tank is related to the height of the water in the tank, and this relation is v² = 2gh where v: (m / s) linear flow velocity, g: gravitational acceleration (10 m / s2) and h: (m) height.