Figure 1 shows the manometer apparatus with different fluids. It is given that the specific density of the mercury and oil are 13.56, and 0.9 respectively. Solve, a. The liquid level, Az when the area of the reservoir on the left limb of the manometer is 100 times the area of the manometer tube in right limb. The volume X is equal to Volume Y. b. The pressure at point A. Oil Volume Y 45cm 18cm Mercury Az olume X ÷

Q: 10. Calculate the density, specific weight, and specific volume of chlorine gas at 25°C and pressure…

A:

Q: For the shown inverted manometer, all fluids are at 20°C. If P - P = 97 kPa, what must the height X…

A: Using concept of Pressure in left limb of manometer = pressure in right limb  solution = 1.31m

Q: (c) Venturi-type flowmeter shown in Figure 5 is used to obtain the flowrate of oil inside a conduit.…

A: ## solution of venturi type flow meter, and calculation of volume flow rate, mass flow rate,

Q: 2) Assuming we have a fluid with SG-0.6, and height of fluid in the piezometer tube equal to h=10m,…

A: To Determine Pressure at point M, P & S

Q: A 3 cm orifice plate is placed within a 4 cm pipe in which methanol at 20 °C (SG = 0.7884 and…

A: Diameter of the orifice = d = 3m   Diameter of the pipe = D = 4m   Specific gravity of the methanol…

Q: The cyclindrical tank with hemispherical ends shown in the figure below contains a volatile liquid…

A: To Determine (a) the gage pressure reading on the pressure gage Pressure gage is 1m below the liquid…

Q: The cyclindrical tank with hemispherical ends shown in the figure below contains a volatile liquid…

A: Reference : Fluid mechanics, Pressure analysis for Volatile liquid. We know that , Gage pressure is…

Q: what is the pressure (in Pa) at the higher center (P₂) if H=

A:

Q: Chamber A oil SE=0.89 0.30 mercury Chamber B tetrachloride sg=1.59 0.8 m

A:

Q: 6.8 in PA Water FIGUD

A:

Q: A manometer is connected to a tank on the side (see below). There are two layers of different…

A: A manometer is connected to the bottom of the tank for measuring pressureSpecific Gravity of Water=…

Q: For the shown inverted manometer, all fluids are at 20°C. If P, - P, = 130 kPa, what must the height…

A:

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?