If the dwell time is 3.5 min for a solvent gradient of 5% B to to 60% B over 20 mins,what is the % B eluate composition after 15 mins has past from the injection time.

Solution- Given data- Dwell time is 3.5 min. Solvent gradient of 5% B to 60% B in 20 min. To find-…

Answered: f the dwell time is 3.5 min for a…

f the dwell time is 3.5 min for a solvent gradient of 5% B to to 60% B over 20 mi what is the % B eluate composition after 15 mins has past from the injection time

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Related questions

Q: 1. Follow the steps below to calculate the concentration of CACO3 (in units of ppm or mg/L) based on…

A: To determine: a) Moles of titrant added to the solution b)Moles of Calcium carbonate titrated…

Q: two chromatograms after LC separation. Which chromatogram is better to proceed for MS analysis? What…

A: LCMS is Liquid chromatography–mass spectrometry used for separation, identification and percentage…

Q: How many uL of 5000 ppb standard would you use to fortify 50 mL of matrix to achieve a spike of 10…

A: As we know ,Moles the solute remains same on dilution but volume of the solution increases.Dilution…

Q: Retention time Substance(s) Peak area (%) (min) Crude product Pure product 8.725 1,2-cyclohexanediol…

A: In the analysis of gas chromatography, the evaluation of peak area is one of the most important…

Q: The purpose of the flame in the atomic emission spectroscopy is for I. Vaporization II. Excitation…

A: There is more than one question,and all are different and as per answering guidelines I can answer…

Q: of Reagent 100 mM Tris-Cl pH 8.0 20 mM EDTA pH 8.0 1.4 M NaCl 2% (w/v) CTAB (cetyltrimethyl ammonium…

A: Molarity is defined as number of moles of a substance present in one liter. M =nV (L) =…

Q: They mix. 40ml de HNO₂ 10.0M 75mL KOH 1.20μ 10ml Necl 0.450M K² = 1.00 x 10-14 Asuming that the…

A: Here acid base reaction will occur

Q: An instrumental method was validated by running an analysis on a standard solution with a known…

A: Accuracy: It is generally expressed by the percentage of error. Relative accuracy is the difference…

Q: I need help calculating the remaining values please!!!!

A: A question based on mole concept that is to be accomplished.

Q: Part B. Standardization of EDTA titrant mass CaCo, (g) initial volume (mL) final volume (mL) Trial 1…

A: The moles of a substance is defined as the ratio or the fraction of the given mass of the substance…

Q: Sources of Error Determine the relationship between the observed/apparent value (EX) VERSUS that of…

A: Given: Not all the solid was transferred during the filtration of the precipitate.

Q: 10.0 ml sample of Mg2+ and Nat mixture was titrated against 0.02 M EDTA. It is required 20.0 ml of…

Q: Calculate the average and standard deviations for each solution (and solvent).

Q: A water sample is approximated to have a total hardness equal to 120.0ppm. How many milliliters of…

A: By knowing the hardness amount on particular volume of solution we can calculate the millilitres of…

Q: A fish sample was analyzed for crude protein content using the Kjeldahl method. The following data…

A: Solutions- Given data- Moisture content 10.0%Weight of sample 2.15 gNormality of HCl used for…

Q: What is the corrected weight (g) of KHP (Molar mass = 204.22 g/mol) with an actual weight of 0.8026…

A: Given data: Molecular weight (M) = 204.22 g/mol Actual weight (Total weight) = 0.8026 g % of the…

Q: Why is an aqueous solution of NaCl used to prepare the solutions for Runs 2–4 instead of deionized…

A: Deionized water contains no ions in it where as the sodium chloride solution having sodium(Na+) ion…

Q: help please answer in text form with proper workings and explanation for each and every part and…

A: To find the percent by mass of CaC2O4 in the original sample, we can use the stoichiometry of the…

Q: EPIC Scribe TIG Into The Gloss ... Account Wolfram Alpha: C... WSU Honors Libra... schedule advising…

A: Given that concentration of Pb(NO3)2 solution is 4.60 mM and Ksp of Pb(IO3)2 is 2.5×10-13Since…

Q: The K, value for NaCl is approximately 37.5 M²/L3 at 25'C. Determine the absolute and percent errors…

A: To calculate the absolute error and the percent error in the experimental values. The experimental…

Q: Table 4. Calculations for standardization of sodium hyroxide Trial 1 Trial 2 Trial 3 [1] Tared mass…

A: We have to find the molarity of NaOH using moles of KHP

Q: Titrant density (g/mL) Ave density (g/mL) Trial SD (g/mL) RSD (%) A В

A: A question based on research methodology, which is to be accomplished.

Q: Just need a second pair of eyes to confirm whether or not my solution is correct. Thanks

A: Consider the given information is as follows; Ksp=Ba2+ OH-2=0.06 0.1202=0.000864≈8.64×10-4 %…

Q: . Calculate the Ksp of CaF; if [Ca]=2.3x10*

A: Note! Sorry for inconvenience but I can answer only first question, as nothing specific is…

Q: 7.1 g of casein in 140 mL of low-fat milk Express your answer using two significant figures. CF…

A: We have to calculate the concentration of the given solution in % m/v.Given: mass of casein = 7.1…

Q: Calculate Average Molarity of EDTA and Relative Average Deviation (R.A.D.)

A: According to Law of Chemical Equivalence M1V1 = M2V2 M1 = molarity of EDTA = M2V2/V1 Trial…

Q: (A) Draw a sketch of the expected chromatrogram (peaks, broadening, relative elution times, etc.)

A: Given: A) To sketch the expected chromatogram.

Q: 6. Determine the Km and Vmax from the LB plot for enzyme assays in buffer 1 and buffer 2. Buffer 1…

A: To determine the value of Km and Vmax from the given Lineweaver-Burk plot for buffer-1 and buffer 2.…

Q: 5. Which of the following is the correct statement for PPM * O (a) g/mL O (b) mg/10³ mL O (c) Kg/L O…

Q: Given the following data Dissolved Oxygen Titration Data Trial 1 Preparation of titrant 0.4455 g…

Q: 1. Calculate the percent of SiO, in the mixture by using the equation: %= part * 100 whole 2.…

A: The unknown sample contains NaCl and SiO2. We are given the masses for different measurements of…

Q: The Results for SVI Calculation of a Mixed Liquor Sample Weight of Filter Paper = 0.603 g Weight of…

Q: What is the chemical equation for main test and for the confirmation test?

A: On addition of dilute HCl to Ag+ ion results in formation of white AgCl(s). The respective equation…

Q: The average concentration of cadmium (Cd) in .3 tea leaves sample is 68.0(±1.5) ppm Cd. If the true…

A: Given that: average concentration of Cd = 68.0 (±1.5) ppm true concentration = 70.0 ppm To find:…

Q: Two different methods were investigated for Cu2+ detection in water sample and both methods…

A: To choose the correct option:

Q: 1. In a gravimetric analysis of a chloride salt, the following data were obtained. Mass of original…

A: The objective of the question is to understand the impact of sunlight exposure on the results of a…

Q: (5) How do you prepare 25mL of a mix solution of 2% (v/v) serum and 10mM EDTA in 1X PBS. You have…

Q: Can you please explain to me how they the got 27.1% under the percent recovery correction?

A: The chemical equation is as follows:

Q: A river water sample (250 mL) is filtered and 0.032 g of solid is collected on the filter paper.…

A: The total solid in the river sample in ppm, is to be determined from the given data. Given:Volume of…

Q: * 100 mLOf approximately 0.2 M NAOH using Naoi (NaoH MA = 40 gimol) %3D Please recalculate the…

A: The concentration is defined as mass of solute present in per unit volume of solution.

Q: Tc-99m sulfur colloid is to be reconstituted with 75 mCi Tc-99m pertechnetate, to be drawn from an…

A: The objective of the question is to find the volume of eluate and normal saline that should be added…

Q: QUESTION 8 Were the sample prep and the standard prep supplemented with the same amount of internal…

A: An internal standard in analytical chemistry is the substance similar to the unknown sample that is…

Q: A 0.53 g sample containing KBr (MW=119) is dissolved in 50 mL of distilled water. Titrating with…

Q: Calculate the mass percent of the ascorbic acid in the same show full solution Situation: The…

A: A numerical problem based on acid-base titration that is to be accomplished.

Q: How many amperes are required to deposit 0.291 grams of magnesium metal in 213 seconds, from a…

Question

If the dwell time is 3.5 min for a solvent gradient of 5% B to to 60% B over 20 mins,
what is the % B eluate composition after 15 mins has past from the injection time.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Sources of Error Determine the relationship between the observed/apparent value (EX) VERSUS that of the true value (ET) for the quantity being sought by writing either <, >, or = on the space provided TOPIC: Measured mass of the precipitate 1. Filter paper was dried prior to filtration. EX _____ ET TOPIC: Standardization of Titrant 2. Distilled water was not equilibrated to room temperature before the preparation of NaOH titrant. EX ______ ET TOPIC: Determination of Molar Concentration of each component (Double Indicator Titration) 3. No blank correction EX ______ ET
Consider Table 1, which lists the volumes of the Fe3+ and SCN- solutions used for the continuous variation method. Note that each of the stock solutions is 0.002 M before mixing. What are the initial concentrations of Fe3+ and SCN- for solution 4, where the volumes are both 5 mL? [Initial meaning after they are mixed, but before]they reach equilibrium)
Sources of Error Determine the relationship between the observed/apparent value (EX) VERSUS that of the true value (ET) for the quantity being sought by writing either <, >, or = on the space provided TOPIC: Determination of % SO32- Question 1 Not all solid was transferred during the filtration of the precipitate. EX ___ ET TOPIC: Measured mass of the crucible Question 2 After heating, the crucible was weighed without cooling. EX ___ ET TOPIC: Measured mass of the precipitate Question 3 Filter paper was dried prior to filtration. EX ___ ET
A water sample was analyzed for the total hardness through the reaction between the sample and EDTA. The data obtained from the experiment are presented below (MM CaCO3 = 100.0869 g/mol): What is the ppm? 10,290 ppm 12,390 ppm 11,270 ppm 990 ppm
Extraction Pre-Lab Question 14 Status: Not yet answered | Points possible: 1.00 Type answer: Suppose you are working with a NaOH stock solution but you need a solution with a lower concentration for your experiment. Calculate the volume (in mL) of the 1.410 M stock NaOH solution needed to prepare 250.0 mL of 0.1273 M dilute NaOH solution. here to search 2 F12 P Cla Hon
Following the Kjeldahl procedure, calculate the % protein content of a flour sample by considering the following: Vol HCL (0.1 N) for blank = 0.2 mL Vol HCl for sample = 16 mL Wt of sample = 1.0872 g N conversion factor = 5.7 ...i will surely upvote...please answer asap
A 200 mL water sample was treated with SPE column for pe- concentration of a certain pesticide. The final solution (24 mL) was analysed by HPLC and the .pesticide content was 1.2 ppm :The pre-concentration factor is 12.5 O 6.7 O 11.4 O 8.3
Determine the relationship between the observed/apparent value (EX) VERSUS that of the true value (ET) for the quantity being sought by writing either <, >, or = on the space provided Determination of the true concentration (ppm Fe) in a water sample using the iron-phenanthroline method. Dilution factor was not taken into account. EX _____ 1ET
using the given values for trial 1, how would you find the mass of pure liquid H2O2?
Solve for titer. Pls show me the solution or step by step process so I can follow. Thank you
A sample of explosives residue is dissolved in an appropriate solvent and is injected into HPLC. The column contains a non- polar stationary phase. The sample revealed three chemical compounds that are commonly present in homemade explosives. ТAТP DADP HMTD 1 2 3 4 5 6 7 8 Retention time (minutes) a) determine the retention time of TATP. b) which one elute first :DADP,TATP or HMTD? c) State and explain which compound is most polar. d) If you are investigating this terrorist attacks, state one way in which the information in the chromatogram would be useful.