Answered: Explain the driving of tunnels in hard…

Engineering

Civil Engineering

Explain the driving of tunnels in hard rocks and in soft grounds and the problems associated with tunnels development ?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 2. Excavation for the basement of a construction project requires a temporary retaining wall to…

A: As the project requires that the retaining wall must be installed immediately without any delay so…

Q: Calculate the quantity of earthwork for a cement concrete road 200m length for a portion of road in…

A: Length of road, height of bank from one end, height of bank from other end, Formation width,

Q: What are the corrective or preventative measures to reduce sliding and improving stability of…

A: The corrective or preventative measures to reduce sliding and improving stability of slopes are as…

Q: Sometimes construction work requires ground excavations with vertical or near-vertical faces, for…

A: Two type of braced cut commonly used in construction work are sheet pile and solider pile . Sheet…

Q: Explain the assumptions used in determining rock failures. (

A: The study of rock Failure deals with behavior of material of earth's crust when subjected to static…

Q: Dr NK Assignments 28 2- In the following Figure, the survey of a proposed cutting shows that the…

A: We have to determine the value of plan surface area of the excavation ABCD and the actual area of…

Q: most settlement. The braced excavation type of (3) below is chosen for the construction of subway…

Q: a). The government of Ghana through the infrs agreement has secured funding for the construction of…

A: Solution;

Q: Define the Influence of Soil Compressibility on Bearing Capacity ?

A: Soil Compressibility Soil compressibility is the capacity of a soil to decrease in volume when…

Q: A tunnel of length of 800 m is to be driven. Part of the total length is through granite and balance…

Q: What type of machine is used in a quarry to cut rock into manageable sizes?

A: Majority of the stones used in construction industry are produced by cutting large blocks of rocks…

Q: 1A) Site investigation should form a part of a coordinated chain of design from inception of the…

A: Reconnaissance survey:It is the Initial stage of site investigation where the site engineer collects…

Q: Kindly summarise the Channel Tunnel's history, building process,

A: The Channel Tunnel, also known as the Chunnel or Eurotunnel, is a railway tunnel. It runs under the…

Q: Discuss the Long-wall Mining and Short-wall Mining Methods with Reference to Strata Control.

A: Long wall Mining: Mine development in the longwall mining process is done in such a way that big…

Q: Define the Bearing Capacity of Foundations on a Slope ?

A: Solution: The bearing capacity factor value of the footings increases with an increase in the…

Q: PROBLEM 1 -Given the following sections 1+020 a +0.90 +3.5 +0.55 1+080 -1.85 -1.20 -0.42 Base for…

A: Given, FILL: Base for fill= 12 m side-slope = 1:1 CUT: Base for cut= 12 m side-slope = 2:1 Distance…

Q: What are the types of structures subject to lateral soil and water pressures?

A: Structure which is used to hold back the lateral soil mass and water pressure is called a Retaining…

Q: elling supervisor, designed a 10-meter-long tunnel with the following secti TOPSOIL BACKFILL PLAIN…

Q: t do you understand by rock mass properties? What are the purposes of rock mass classification? Name…

A: A matrix of rock material and rock discontinuities is referred to as a rock mass. Its…

Q: Define the Drained sliding resistance ?

A: Sliding resistance is a simple concept. The classical laws of friction governing a rectangular block…

Q: What are Mode of deflection and lateral pressure distribution for sheeting supporting a vertical…

A: Mode of Deflection for sheeting supporting a vertical cut :

Q: t least 3 paragraphs, discuss the proper maintenance and usage of ladders. Discuss your idea on how…

A: A ladder is a collection of rungs or steps that can be upright or sloped. Rigid ladders, which are…

Q: Calculate the design moments of two-way slab as shown with a dimension of 4 mx 6 m if it is to…

A: Shorter span of slab, S=4mLonger span of slab, L=6mDL=10 KPaLL=3.2 KPaOne short and One long edge…

Q: 5. Determine whether the slabs shown is a two-way or one-way and also 3m S-1 approximately find the…

Q: The ratio of the Boussinesq's influence factor to Westergaard's influence factor at point 0 (2 m…

A: The ratio of the Boussinesq's influence factor to Westergaard's influence factor at point 0 ( 2m…

Q: QUESTION 14 The cross section of excavation is: O 7.40 m2 O 4.06 m2 3.58 m2 O None of the answers…

A: Question 14 Cross-section of the excavation = 550 x (250+1100) = 0.55 x (.25+1.1) =0.55 x 1.35 =…

Q: 1. Soil investigation/explorations are required for vertical structures under categories I, II, III…

A: For vertical structures, soil investigation/exploration is typically required to determine the…

Q: What are Procedures, apparatus, and calculations needed in Fall Cone/ Cone Penetration Method

Q: Define the Uplift capacity of footings in granular soils ?

A: Uplift capacity : The uplift capacity is defined as the measure of the resistance of a pile to being…

Q: 16 - In tunnelling which type of geological structure can be treated by grouting? a) Faults b) O…

Q: SHOW FIGURE Given the following sections: Station 2 + 020 a 0 b +2.5 +3.15 +2.65 Station 2 + 080…

Q: What are the advantages that the use of micropiles (soil nails) and launched soil nails could offer…

Q: Q- The nature of the soil and its engineering properties and moisture content and groundwater…

A: The above mentioned properties are are important factors for ground discharge methods, where the…

Q: the

A: Slope failures are common phenomena around the world where large masses of soil move downslope by…

Q: Why does it prefer to the use of continuous steel sheeting is preferred for excavations deeper than…

A: To safeguard against these hazards in deep excavation work we do provide different type of elements…

Q: You are assigned to supervise an earthwork for a road construction, leveling it down to 30 m. The…

A: 1) Direct and Indirect excavation assessment prior to the earthwork are:- Techniques of soil…

Q: What are the possible reasons and purposes for the utilisation of different underground structures.…

A: The underground structures can be classified into three categories; (i) Tunnels (ii) Cavern and…

Q: Explain Mode of deflection and lateral pressure distribution for sheeting supporting a vertical cut.

A: Sheet piles are used to retain the sand and clays i.e. soil present on the side of cut. They are…

Q: To assist in picturing and understanding underground conditions existing at a site, it has become…

A: Geo-technical investigation or soil exploration: It includes investigations and data includes…

Q: An understanding of rainwater drainage and the groundwater levels is of high importance in…

A: Option D

Q: A partial-diaphram type of earth embankments is sometimes referred to:

A: An embankment dam is an artificial dam that is constructed of natural materials. There are two types…

Concept explainers

Foundation construction

Question

100%

Explain the driving of tunnels in hard rocks and in soft grounds and the problems associated with tunnels development ?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 Tunneling

VIEW

Step 2 Tunneling in hard and soft rock

VIEW

Step 3 Problems associated in tunneling

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Borings advanced by wash boring methods through cohesion less soils or below water are subject to cave-in. To prevent this, it is typical to drive a protective casing around the boring. Describe about the casing and how it is helpful?
Explain why the majority of slope breakdowns happen during the rainy season, especially after a particularly severe downpour.
Calculate the net cut/fill for Station A, B, C and D, and draw the Mass Diagram Ordinate of the earthwork. The details of the cut and fill is given below. The location between each station is 6 meters apart. Station A - Cut (30 m³), Fill (10 m?) Station B- Cut (10 m2), Fill (20 m?) Station C- Cut (60 m?), Fill (20 m?) Station D- Cut (10 m?), Fill (50 m2)
---DETERMINE THE VALUES OF “a” AND “b” THEN FINISH THE PROBLEM. --- Determine the area of the cross-section --- The volume of excavation and fill using end-area method
Explain Alternate Types of Retaining Structures.
Please answer Problem no 2 **********
1. Find an earth retaining structure in your nearby environemnt or if you cannot find one, search from the internet a picture of such already installed structure.
The estimated common excavation for the driveway is 420 cubic meters and there are also 32 footings of 2 x 2 meters size and 0.60m thickness. The depth of the footing is 1.6m from the natural grade line. [Column sizes are 0.80 x 0.80m) Using a D4 dozer, determine the duration of excavation. With manual embankment done by 12 laborers, how many days will it take to PLACE backfill for the structural excavation? With manual embankment done by 12 laborers, how many days will it take to COMPACT backfill for the structural excavation?
Write down the practical limitations to information provided by soil borings and cone penetration tests?
welcome please needed solved this question, please
Explain why most slope failures do occur during the raining season, especially after heavy rain.
There are three types of retaining wall in a geotechnical project. Cantilever wall, sheet pile wall and anchored diaphragm wall. Sort seismic coefficient in descending order for those retaining walls by explaining the basic logic behind it.