Exercise 13.8: cold air at 5°C is carried by a rectangular duct 30 cm X 20 cm in size which is maintained at 15°C over the whole surface. The velocity of the air is 10 m/sec. taking the following properties of air at a mean temperature of 10°C, find the heat gained by the airv when it is passed through 10 m length of duct

Exercise 13.8: cold air at 5°C is carried by a rectangular duct 30 cm X 20 cm in size which is maintained at 15°C over the whole surface. The velocity of the air is 10 m/sec. taking the following properties of air at a mean temperature of 10°C, find the heat gained by the airv when it is passed through 10 m length of duct

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Whole milk is flowing into a centrifuge through a full 6.5 cm diameter pipe at a velocity of0.19 m/s. The milk is separated to skim milk and cream with specific gravity of 1.04 and1.01, respectively. Calculate the flow velocity of cream, if skim milk and cream aredischarged through 3 and 4 cm diameter pipes, respectively. The specific gravity of wholemilk is 1.035.
Asap
The man shown in (Figure 1) blows air through the 3-mm diameter straw with a velocity of 2.8 m/s. Assume fully developed flow occurs along the straw. The temperature of the air is 20°C. Figure -225 mm- 1 of 1 > T Part A Determine the force his lips exert on the straw to hold it in place. Express your answer using three significant figures and include the appropriate units. P-6.673 HA Provide Feedback N ? ubmit Previous Answers Request Answer X Incorrect; Try Again; 3 attempts remaining
There is a flow of air that circulates over a flat plate that is used to store a food product at a temperature of 95 ° C throughout its surface. The air flows at a speed of 2.5 m/s and has a temperature of 25.0°C. The plate measures 600.0 mm · 300.00 mm. As a task assigned by your plant operations manager, you are asked to answer the following questions: i. Determine the heat loss from the plate if the air flows parallel to the 600.00-mm side.ii. How would this heat loss be affected if the airflow is made parallel to the 300.0-mm side? For this type of configuration, the coefficient of heat transfer by forced convection, h, can be obtained from the relation IMAGE BELOW The previous correlation is valid for the laminar regime, that is: Re < 500000
Air at 60°F and atmospheric pressure flows in a horizontal duct with a cross section corresponding to an equilateral triangle (all sides equal). The duct is 100 ft long, and the dimension of a side is 6 in. The duct is constructed of galvanized iron (ky = 0.0005 ft). The mean velocity in the duct is 12 ft/s. What is the pressure drop over the 100 ft length? 100 ft 12 ts 6 in
A steam reservoir is covered by a rectangular plate (its length is 1 m and width 2 m). The steam temperature is 95o C, and it is in contact with the plate. Over the outside surface of the plate, water is flowing at a speed of 3 m/sec at a temperature of 25o C. What is the mean Nusselt number over the plate? What is the mean heat transfer convective coefficient over the plate? What is the heat transfer rate to the water?
A vehicle carrying refrigeration box is moving with a speed of 24 m/s on a road withambient temperature of 323 K. The dimensions of box are 3 m(H) × 4 m (W) × 10 m (L).Assume a wall temperature of 283 K and air flow is parallel to the longest side of the box.Neglecting the heat loss from the front side and backside of the box, calculate heat lossfrom four surfaces. For flow over flat surfaces useNu = 0.036(Re)0.8(Pr)1/3The properties of air at bulk mean temperature are : = 1.165 kg/m3, Pr = 0.701, cp = 1005 J/kg – K,  = 16 × 10–6m2/s
1. A hollow tube is designed to be a heater with the ability to provide uniform surface heat flux of 2000 W/m2 to the water that flows in it. The water with a velocity of0.3 mis enters the tube at a temperature of 15 °C and leaves the tube at a temperature of 45 °C. The tube is 13 m long with a diameter of 5 mm. a. is the flow laminar or turbulent? b. Is the flow fully developed? Prove it with appropriate calculation. c. Calculate the heat transfer coefficient for water that flows inside the pipe. d. What is the temperature of the surface at the exit point of the tube?, e. Evaluate the heat transfer performance when the velocity of water increases to 3 m/s. Briefly discuss your answer. 2. The double pipe, parallel flow heat exchanger is to be used to cool oil using sea water. The oil enter the heat exchanger at 0.15 kg/s and at a temperature of 90 °C. Meanwhile, the sea water enters the heat exchanger at 0.3 kg/sand at a temperature of 10 °C. The area of the heat exchanger is 11. 5 m2…
A 30mm ID, 50mm OD aluminum round tube passes air through it at a rate of 0.08 m^3/s. A 100W electric heater blanket covers the outside of the 2m long tube. If the air enters the tube at 100 celsius , what temperature does it exit at? Assume that the heater blanket is perfectly insulated on the back side (no heat loss out the back). Note-RT is 25 celsius
Air at 20°C is hydrodynamically fully developed as it flows in a 1 cm I.D. pipe. The average velocity is 0.7 m/s. If it enters a section where the pipe wall is at 60°C, what is the temperature 0.25 m farther down stream?
Air at a temperature of 20 oC flows at a speed of 10 m/s through a rectangular duct made of wrought iron with a cross section of 30 cm x 50 cm and a length of 20 m. Calculate the required fan power
n electric generator at a power plant produces energy by passing superheated steam from a high temperature container (reservoir), through a pipe connected to a series of fans, and then into a low temperature reservoir. As the steam passes across the blades of the fans some of the heat energy of the steam is transformed into mechanical energy, which turns the fans which in turn are connected to a generator, which in turn converts the mechanical energy into electrical energy. If the high temperature steam has a temperature of 412.1 K and the low temperature reservoir has a temperature of 105.4 K, what is the Carnot efficiency of this process?