Example:- A three 1in *3in wood board is connected together by bolt (d-0.5in) as shown in the figure. The washer dimensions are (Do-2in, Di=0.5in). The nut is a 0.5in (Zinc Finish, grade A Finished Hex. Nut). Analyze the stress developed in the wood and the bolt in the following two cases :- Case I:-An External force of (P=1400lb) that is applied on the wood board on the right is transmitted through the bolt to left wood board. Case II: There is no external force but the nut is tightened so that internal stress of o=2700psi is developed in the bolt. t₁ P/2 P/2 NITI NITI E-

Q: The pin-connectsed structure consists of a rigid bar ABCD and two bronze alloy [E = 100 GPa] bares,…

A: GivenE=100GPaA=340mm2L1=810mmL2=1080mma=480mmb=38mmc=600mmσlim=165MPa

Q: A centrifugal pump delivers 300,000 liters per hour of water to a pressurized tank whose pressure is…

A:

Q: 15 in 05 im 24 in The machine link shown is subjected to an axial load P, as shown. The link is…

A:

Q: stresses at each of three holes of 3, 5 and 10 mm diameter.

A: Given: t=15 mm To determine: The stresses at each of three holes of 3, 5 and 10 mm diameter

Q: A steel bar of thickness h, to be used as a beam, is welded to a vertical support by two fillet…

A: Refer to the picture belowExplanation:

Q: A butt connection is shown in the following figure. Plates is Q235 steel; 8.8 Grade M16 high-…

A: Load bearing capacity  Loadbearing capacity is the maximum ability of a structural member or…

Q: 3.33 For the plane trusses supported by the spring at node 1 in Figure P3-33 (a) and (b), determine…

A: As per our guidelines, we are supposed to answer only one question. Kindly repost other question as…

Q: A steel bar of thickness h, to be used as a beam, is welded to a vertical support by two fillet…

A: The allowable force, F, on the weld is approximately 252.84 kN.Explanation:Step 1: To find the…

Q: -0.6*K2 m- A K1 m/s K1=2 К2-8 К4-2 k=50*K4 N/m B 4- The 2 kg smooth cylinder collar has a downward…

A:

Q: The metallic hollow pipe shown in Figure Q1 is fixed at both its ends, and is under axial…

A:

Q: See the figure below. AD is a member with varying diameters. There are three axial loads applied at…

A: Given data: The magnitude of the force acting at the point B is; F1=10 lbs. The magnitude of the…

Q: smooth pin at D and by vertical aluminum alloy [E = 10,000 ksi] bars attached at joints A and C. Bar…

A:

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.