Example 13.3. Two tram cars (A & B) 2 km and 6 km away from a sub-station return 40 A and 20 A respectively to the rails. The sub-station voltage is 600 V d.c. The resistance of trolley wire is 0-25 2/km and that of track is 0-03 2/km. Calculate the voltage across each tram car.

Example 13.3. Two tram cars (A & B) 2 km and 6 km away from a sub-station return 40 A and 20 A respectively to the rails. The sub-station voltage is 600 V d.c. The resistance of trolley wire is 0-25 2/km and that of track is 0-03 2/km. Calculate the voltage across each tram car.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

150 kv single core cable has a radius of cable of 5cm. The insulation martial has two layers. The relative permittivity of the first and second layers are 6 and 3 respectively. If the minimum electric stress of the first and second layers are 30 kv/cm and 20 kv/cm respectively. Find the maximum electric stress of the first layer
low voltage systems What is the system called if current flows through its neutral conductor? a)Balanced b)Unbalanced c)Proactive d)Complex
12.a. You're working on an installation at a patient care facility. You have two panelboards next to eachother that supply the critical and the normal feeder circuits. These two panelboards must be bondedtogether using an insulated copper conductor with a minimum size ofA. AWG 10.B. AWG 6.C. AWG 8.D. AWG 4. 12.b. You're installing an isolated power system in a hospital that'll serve a group of patient care areas. Whichof the following colors must be used for the wire that connects to the terminal at each receptacle that'susually reserved for the neutral conductor?A. Green with a white stripeB. Orange with a distinct stripeC. Red with a black stripe
The loads on a 300-meter ring distributor are depicted in figure 2.1 (a), where the distances are given in metres. Each conductor has a resistance of 0.20 per 1,000 metres, and the loads that are tapped off at points B, C, and D are as shown in the diagram. Determine the voltages at B, C, and D given that the distributor is fed at point A. 50 A 70 1 240 V A (a) 60 B 70 A 100 A 80 50 A 91A D T 41 A 220 V A (b) 129 A B 100 A 729 A 70 A
3. A 250 m, 2-wire d.c. distributor fed from one end is loaded uniformly at the rate of 0-8 A per metre. The resistance of each conductor is 0.0002 2 per metre. Find the necessary voltage at the feeding point to maintain 250 V at the far end of the distributor. [260 V]
What is the current trend of distribution substation? Can you give me an example.
A cable is tested by loss of charge Method using a Ballistic galvanometer with following results : Discharged immediately after electrification deflection 200 divisions. Discharged after 30 second and after electrification (i) Deflection 126 divisions (ii) When in parallel with a resistance of 10 V deflection 100 divisions. Calculate the insulation resistance of the cable.
DIGIT ELECTRONICS
13. What is the colour of live conductor in single -phase a.c. supply, a. Black b. Orange c. Green d. Red
Q2: Equipment ratings for the four power system shown in Figure (1) are as follow: - GI-500 MVA, 13.8 kV, X = 0.2 p.u G2-750 MVA, 18 kV, X-0.18 p.u G3-1000 MVA, 20 kV, X-0.17 p.u TI = 500 MVA, 13.8/500 kV, XT1=0.12 p.u T2-750 MVA, 18/500 kV, XT2= 0.1 p.u T3-1000 MVA, 20/500 kV, XT3-0.1 p.u. (1) T1 T3 T.L 1 G1 j50 ohm 13,8/500 KV 20/500 kV T.L 2 j50 ohm T.L 3 150 ohm T2 G3 18/500 KV G2 Figure (1) neglecting resistance, transformer phase shift, and magnetizing reactance, draw the positive - sequence reactance diagram on a 1000 MVA, 20kV base in the G3.