A cable is tested by loss of charge Method using a Ballistic galvanometer with following results : Discharged immediately after electrification deflection 200 divisions. Discharged after 30 second and after electrification (i) Deflection 126 divisions (ii) When in parallel with a resistance of 10 V deflection 100 divisions. Calculate the insulation resistance of the cable.

A cable is tested by loss of charge Method using a Ballistic galvanometer with following results : Discharged immediately after electrification deflection 200 divisions. Discharged after 30 second and after electrification (i) Deflection 126 divisions (ii) When in parallel with a resistance of 10 V deflection 100 divisions. Calculate the insulation resistance of the cable.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Power engineering book Mehta
Transferred surge current method is used to find a. Fault in the transformer insulation b. Fault in the Circuit breaker c. Fault in the cables d. Fault in the lines
what is the introduction for MEASUREMENT USING DC BRIDGES
A voltage transformer in Figure 8 has 1,500 turns of wire on its primary winding and 500 turns of wire for its secondary winding. What will be the turns ratio, a of the transformer. If 240 volts is applied to the primary winding, what will be the resulting secondary voltage. And if a 400 n resistor is connected to the secondary winding, what are the values of current Is and Ip. primary Vp Transformer Core NF Ns Figure 8 secondary Vs
5. It is found that the armature of a coil of wire increases from 50 ohms at 20°C to 60 ohms at 56°C. What is the temperature coefficient of resistance of the conductor at 0°C? a. 0.00750 c. 0.00936 b. 0.00625 d. 0.0208
Power engineering book Mehta
(9) The hysteresis losses in electrical machines reduced. a- By core lamination. b- By core isolation. c- By choosing another type of iron. (10) The eddy current losses in electrical machines reduced. d- By core lamination. e- By core isolation. f- By choosing another type of iron.
Q. 4
Fhe number of parallel paths and the number of series conductrs required for a given kW reting are determined by. System voltage Armature resistance Type of winding Field current
a)The voltage per winding of 220V/12V, 60 Hz single phase core transformer is 1V. If the maximum flux density in the core is 1.5 T, which of the following is the cross-sectional area of the core in cm²? 0.0030 0.0060 30 25 50 0.0050 0.0025 60 b) The voltage per winding of 220V/12V, 50 Hz single phase core transformer is 2V. If the maximum flux density in the core is 1.5 T, which of the following is the cross-sectional area of the core in cm²? 0.0030 0.0060 30 25 60 0.0050 0.0025 50
The number of disc insulators used in a suspension insulator setup with string efficiency 90 %, phase voltage 33 kV, and the voltage across insulator nearest to conductor 10 kV is
define energy and co-energy and sho them in graph of bonding flux with respect to Magnetizing current