Ex. 681. Given a sinusoidal voltage source in series with R,L, and C. The sinusoidal frequency is 400 Hz. C=500 microFarad, V=30sin(wt) volts. phasor voltages across the capacitor, resistor, and inductor. R=2 Ohms, L=6 milliHenry, Find the phasor current, ans:8

Ex. 681. Given a sinusoidal voltage source in series with R,L, and C. The sinusoidal frequency is 400 Hz. C=500 microFarad, V=30sin(wt) volts. phasor voltages across the capacitor, resistor, and inductor. R=2 Ohms, L=6 milliHenry, Find the phasor current, ans:8

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 2) A sinusoidal alteznating voltage has Eo Mo S. value of 200V and 50 H7. It cEOSses an a fzequency…

A: Given : f=50 HzVrms=200 V The angular frequency can be calculated as : ω=2πfω=2π×50 Hzω=314 rad/sec…

Q: Given a capacitive load absorbing 5 kW with a power factor of 0.85. The source connected to this…

A: Given the real power P and the power factor pf, we can find the apparent power S using the formula:…

Q: Ac - 100 Vrms R1 - 1k R2 - 500 Rload - 1k Capacitor - 2uF Q1. How much is the capacitor voltage…

A: To determine the phase lag between the capacitor voltage and the AC source voltage, we need to…

Q: What will be the impedance of an inductor of inductancs 4 mH? The ac input frequency is 50 Hz.

A: If an inductor of the inductance of L H is subjected to ac of input frequency of f Hz, then the…

Q: Please show your detailed solution Number 15 A circuit with a resistor and capacitor in series takes…

Q: A current of 1A RMS 60HZ flows through a 120mH inductor. Calculate the RMS voltage drop across the…

A: In this question, Choose the correct option What is rms voltage drop across the inductor VL = I XL…

Q: 3. In the circuit shown in Figure, the total current is 150 mA and the current through the inductor…

Q: For a series RLC circuit with a sinusoidal input voltage, the amplitude of the current passing…

Q: The phasor diagram below shows the phasor voltage and current of the same element This element is…

A: As given phasor is as, As from given phasor, the current is Laging the voltage in anticlockwise…

Q: Consider a circult where an ideal inductor L=0.144H is connected in parallel to a resistor R=1.00kn.…

A: Given R =1000 Ω L=0.144 H C=0.367 μF f=3.4 kHz supply voltage =V The circuit is drawn as per given…

Q: 5. What value of the current when a capacitor of 10uF connected to a 110V a.c. 50 Hz power supply?…

A: Given, Capacitance, C=10 μF. Supply voltage, V=110 V. Frequency, f = 50 Hz.

Q: A coil has an inductance of 478µH. What is its reactance in 1000Hz ac circuit? 3.00ohms if connected…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: A coil of resistance 20000 and self- inductance 1.0 Henry has been connected to an a.c. source of…

A: The coil can be thought of as the resistance connected in series with the inductor. The inductive…

Q: 5. What value of the current when a capacitor of 10uF connected to a 110V a.c. 50 Hz power supply?…

A: Given: Capacitor, C=10μF Frequency, f=50Hz Voltage, V=110V

Q: An Inductor has an internal resistance of 10 Ohms and an inductance of 0.5H. What is it's impedance…

A: Given R = 10 ohm, L = 0.5H, F = 60Hz To calculate impedance Z

Q: current of 20sin(200t - 30°) A flows into the parallel combination of a 100-ohm resistor and a…

A: We need to find out the current through capacitor for given parallel RC circuit .

Q: Express these sinusoids as phasors write phasor in rectangular and exponential form

A: Note: As per guidelines will be solving only 1st question (i.e. Q2). Please repost for others. Given…

Q: The voltage and current of an element are i(t) = 3.cos(1000t + 10°) V(t) = 6.cos(1000t – 80°) The…

A: Q(6)SolutionThe voltage and current of an elementarei(t)=3 cos(1000t+10°)A=(3∠10°)Av(t)=6…

Q: Answer the following with illustration and solution. 1.) A circuit consisting of a resistor of…

A: The required parameter can be obtained by calculating the impedance of the capacitor and then by…

Q: RESISTOR OF 28 ohms AND A CAPACITOR OF 66 Mf ARE IN SERIES. THE CAPACITOR VOLTAGE IS 50 sin 1000t.…

Q: For the given waveforms, waveform C * the waveform D and E. Degrees 30 60 90 180 210 360 540 M A…

Q: How does interconnected grid system provide stability to the system?

A: Suppose three generating stations G1, G2, and G3 are interconnected. This interconnected system has…

Q: For the circuit shown below, determine: a) Amplitude of the Voltage Source b) RMS value of the…

Q: An electrical circuit with a sinusoidal voltage source, a resistor, and an inductor all connected in…

A: we need to tell the correct option for the given statement.

Q: In alternating current, AC, theory, the voltage through an inductor leads the current by a phase…

A: introduction for series for parallel

Q: Required information Problem 06.037 - DEPENDENT MULTI-PART PROBLEM - ASSIGN ALL PARTS The current…

A: In this question We need to determine the voltage across the inductor. We know Voltage across…

Q: 1. A sinusoidal voltage is zero and increasing at t= -1.2ms. The next zero crossing occurs at t=…

A: For sinusoidal For a cycle it has two zero crossings. Given information is about a half-cycle. So…

Q: 6-9) A capacitor, an inductor and a resistor all walk into a bar. No, wait. A capacitor, and…

A: Plot of voltage vs frequency

Q: . A capacitor has a resistance of 80ohms when connected to a 50 Hz supply. Calculate the value of…

A: The solution is given below

Q: Determine the total parallel inductance for the following coils in parallel: 75 μH, 50 μΗ, 25 μΗ,…

Q: In alternating current, AC, theory, the voltage through an inductor leads the current by a phase…

Q: 5. What value of the current when a capacitor of 10uF connected to a 110V a.c. 50 Hz power supply?…

Q: An inductor of reactance 100 Q, a capacitor of reactance 50 Q and a resistor of 50 Q are connected…

A: Given- Resistance R= 50 Ω, Capacitor Reactance XC=50 Ω, Inductor Reactance XL =100 Ω, To Find- The…

Q: An applied voltage signal consists of a superposition of a dc voltage and an ac voltage of high…

A: When voltage applied on series inductor and capacitor is DC voltage. For DC input voltage after…

Q: A certain impedance is given by 1012° N. Does the current lead or lag the voltage, and by how many…

A: Impedance

Q: You want to connect a capacitor as shown above to create a DAC. If the Arduino has a period of 5 ms…

A: For the given RC circuit connected with the Arduino for ADC application the value of capacitance…

Q: coil of power factor 0.4 is in series with a 50-μF capacitor. The p.d. across the coil is equa to…

Concept explainers

Single Phase Induction Motor

The single-phase induction motor or engine consists of a single rotating phase in the stator and a rotating cage in the rotor. When phase one supply is connected to the stator winding, a magnetic field is generated. In the pulsating field, the rotor does not rotate due to inertia. So, a single-phase import motor does not start and requires some initial methods.

Question

Ex. 681. Given a sinusoidal voltage source in series with R,L, and C. The
sinusoidal frequency is 400 Hz.
C=500 microFarad, V=30sin(wt) volts.
phasor voltages across the capacitor, resistor, and inductor.
R=2 Ohms, L=6 milliHenry,
Find the phasor current,
ans:8

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

QUESTION 9 A voltage of 47V RMS is applied across a real inductor. The current through the inductor is measured to be 29mA RMS and the phase angle between the voltage and current is measured to be 84.7. Determine the internal resistance of the inductor.
Find the impedance of a series connection resistor and an inductor.the inductance is L=1mH.the resistance is R=1kohm and the angular frequency is 2.10^5rad/sec
A capacitor is connected in parallel with a load of S= 6000 VA, and pf-0.8 lag. The load is operating at 180 V and a frequency of 60 Hz. Calculate the capacitance value that will correct the power factor to pf%3D1. Select one: O a. None of them O b.0.47 mf O c.0.295 mf O d. 0.354 mf
07. Three capacitors, a 12 µF, a 20 µF, and a 30 uF. are connected in series to a 60-Hz source. What is the totai Ac a. 226.42 S2 b. 342.78 Q c. 442.09 N d. 566.32 Q
A capacitor is connected in parallel with a load of S= 6000 VA, and pf=0.8 lag. The load is operating at 180 V and a frequency of 60 Hz. Calculate the capacitance value that will correct the power factor to pf=1. Select one: a. 0.47 mf b. 0.354 mf c. 0.295 mf d. None of them
An inductive coil of resistance 15 ohms and inductance 0.2 is commented in parallel with a 100 microfarad capacitor to a variable frequency supply.Find the frequency at which the total current taken is in phase with the supply voltage. What is the value of this current if the voltage is 200V.Draw a phasor diagram
d) Determine the phasors VL, VR and Vc.
Draw a diagram of a 60 Hz AC voltage waveform that is being altered by a 3rd (2)harmonic where the 3rd harmonic is subtractive. (It may assist you to draw the fundamental and the 3rd harmonic then the combined waveform). (2)
What is the peak current in a AC circuit with a 50 ohm resistor, 3.3 mH inductor, and a480 nF capacitor in series. If the AC source has a peak emf of 5.0V, then what is the peakcurrent at 3000 Hz?At what frequency do you get the largest potential difference across the resistor? And what isthis potential difference?
Quickly please.
Take note that for the capacitor, the input in the software must be the capacitance in nano-Farad (nF). Since the given parameter in this example is the capacitive reactance in ohms, solve for the capacitance. Use the system frequency of 20 kHz. Attach your solution in the answer sheet.
PLEASE FAST