8. Estimate the settlement of the center ofthe tank, shown in the sketch, due toconsolidation of the 20-ft layer of clay.80'diam.-Oil tank; 500 lb/sq ft30' fine sand; 125 lb/cu ft20'clay; qu = 1.3 tons/sq ftW = 54 %Wp = 26%W = 44%Isat = /15 lb /cu ft%3DRock%3D%3D

To find - The settlement of the center of tank.

Answered: Estimate the settlement of the center…

Estimate the settlement of the center of the tank, shown in the sketch, due to consolidation of the 20-ft layer of clay.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Q5): For the soil profile shown in figure, the piezometer reading at point (A) at time (t) after…

Q: And the void ratio for each load increment is shown in the table below. σ₂ (kPa) Void ratio 15 1.66…

A: Vertical pressure, kPa Void ratio, e 15 1.66 30 1.65 60 1.64 120 1.52 240 1.38 480 1.25…

Q: How long will it take for 50% of the total settlement to occur in laboratory specimen of the clay…

A: Degree of consolidation = U= 50%Cv= 0.25m²/dayDiameter of specimen = 6.35cmH= 2.54cm

Q: A clay layer has consolidated in 5 years. The secondary compression in the next 7 years is 40 mm.…

A: Given, tp = 5 years ∆t = 7 years

Q: Determine the value of porosity if void ratio is 0.262

A: The given question is related with geotechnical engineering . In this question we are provided with…

Q: Plot the following data and determine the preconsolidation pressure and the modified compression…

A: % Consolidation (Compression is +)Pressure (kPa)% Consolidation (Compression is +)Pressure…

Q: 8. Plot the consolidation curve for the data given below and determine the preconsolidation stress…

Q: Determine the value of void ratio if porosity 0.423

A: Introduction : The given question is related with soil mechanics . In this question we are provided…

Q: The following readings were taken for an increment of vertical stress of 400 psf in a…

A: The value of the t90 can be find out by plotting a graph between settlement and time. ⇒t90 = 5.5…

Q: Table 2 shows the soil profile and the relevant soil parameters and the loading parameters.…

A: Introduction : Elastic settlement occurs as a result of a change in shape at a constant volume, such…

Q: Determine the over consolidation ratio at the mid point of the clay layer

A: Given, An old well data shows that the ground water level was as low as 10 m below the ground level…

Q: Q. No. Estimate the primary consolidation settlement of the clay layer a) shown in the Figure below.…

Q: A 15" thick clay layer shown below is consolidated. Calculate the time required to achieve 65% of…

Q: A 3 meter thick clay layer (pore water flowing in both directions) saturated with water loaded with…

A: The answer is found to be Coefficient of consolidation Cv=0.01272 m^2/day For explanation please…

Q: Estimate the primary consolidation settlement of the clay. Assume the soil above the water table to…

A: Given that :-The soil profile at a site for a proposed office building consists of a layer of fine…

Q: Two near-surface strata of the same soft clay are to be consolidated. In one the consolidation is to…

Q: Define Drained versus undrained deformation

A: If water is not permitted to flow in or out of the soil, the stress path is called an undrained…

Q: 3- The time for 65% consolidation of a 1.12-inch clay specimen (drained at top and bottom) in the…

Q: The time required for a 50% consolidation of a 25 mm thick layer (drained at both and bottom) in the…

Q: The time required for a 50% consolidation of a 25 mm thick layer (drained at both sides) in the…

A: solutionTime for 50% consolidationt=2min 20sec=140 secfrom settlement tableTv=0.197 for 50%…

Q: A soil stratum is 10 m thick with pervious stratum on top and bottom. The time required for 50%…

A: Given data- Thickness of soil stratum=10 m Coefficient of permeabilityK=10-7 cm/s, Coefficient of…

Question

8. Estimate the settlement of the center of
the tank, shown in the sketch, due to
consolidation of the 20-ft layer of clay.
80'diam.
-Oil tank; 500 lb/sq ft
30' fine sand; 125 lb/cu ft
20'clay; qu = 1.3 tons/sq ft
W = 54 %
Wp = 26%
W = 44%
Isat = /15 lb /cu ft
%3D
Rock
%3D
%3D

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Mass and mass related variables in engineering

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A laboratory sample of clay 2 cm thick took 15 min to attain 60 percent consolidation under a double drainage condition. What time (in days) will be required to attain the same degree of consolidation for a clay layer 3 m thick under the foundation of a building for a similar loading and drainage condition? a.17.15 b.119 c.234 d.564.3
10.9 A consolidation test on a sample of clay produced the following data: o:' (kPa) 8 16 32 64 128 256 512 1024 16 0.032 0.041 0.051 0.069 0.109 0.173 0.240 0.301 0.220 The initial void ratio of the sample was 1.21, and Ozo at the sample depth was 40 kPa. (a) Plot these data on an arithmetic diagram similar to that in Figure 10.10(a) (b) Plot these data on a semilogarithmic diagram similar to that in Figure 10.10(b). (c) Using Casagrande's method, find oc (d) Using Schmertmann's method, adjust the test results. (e) Determine Ccand Cr.
Determine the void ratio if porosity 0.531
The time required for 50% consolidation of a 20 mm- thick clay layer(drained at both top and bottom) in the laboratory is 2min 50 sec. How long (in days) will it take for a 3-m- thick clay layer of the same clay in the field under the same pressure increment to reach 50% consolidation? In the field, there is a rock layer at the bottom of the clay.
Question attached
The rate of consolidation for a stratum of clay soil is affected by several factors. Describe these factors.
2) A rectangular (5ft by 8ft) foundation will be built on the soil profile shown in the figure. Calculate the primary consolidation settlement below the center of the foundation. Assume the clay layer shown in the figure is normally consolidated. For simplicity, do not subdivide the clay into multiple sublayers. AG = 1500 lb/ft? Dry sand *120 pet Clay,Ce =0.28 e,= 0.55 Ya 125 pct Bedrock (Impermeable)
A large building is to be built on a thick layer of normally consolidated clay shown in the figure below. The building is to be placed at the bottom of a 4 m deep excavation, which will correspond to 1 level of parking garages. The water table remains 4 m below the ground surface during the entire process. Find the OCR in the middle of the clay layer at Point A, a long time after excavation and before construction of the building. (Answer tolerance = 2%).
Y
Determine the void ratio if porosity is 0.334
Determine void ratio if value porosity%3D0.5
Asap