Estimate the heat capacity of magnesium bicarbonate Mg(HCO3)2 using Kopp's rule Table B.10 Atomic Heat Capacities for Kopp's Rule" Cr[J/(g-atom-"C)J Element Solids Liquids 7.5 12 H 9.6 18 B 11 20 24 25 Si 16 17 21 23 26 26 F 29 P 31 31 33 All Others

Q: The octane number of gasoline is the % by volume of iso-octane in an iso- octane (C8H18) and…

A:

Q: Calculate the bubble pressure (bar) of the mixture: liquid that is in equilibrium with the following…

A: Given that,Temperature T = 80 Co = 353.15 KComposition (in Mole fraction) of vapor phase Ethane =…

Q: Name of compound 1. cupric nitrate 2. potassium dichromate 3. titanium (III) nitrate 4. barium…

A: Given that: there are some compound given we have to write ion involved and formula of that compound

Q: Problem 1. Phenol and water are partially miscible liquids. A mixture consists of phenol and water…

A: Given data: % Phenol 10 20 30 35 40 45 50 55 60 70 T(°C) 42 52 60 67 66 65 63 60 50 28

Q: Question: A solution prepared by dissolving 65.0 g of an unknown compound (non-electrolyte) in 375 g…

A: Molar mass is defined as the ratio of the mass of a solute of that solution to the amount of…

Q: 1- Why do we measure aniline point for petroleum fractions?

A: Since you have posted multiple independent questions in the same request, we will solve the first…

Q: Say, a pure saturated hydrocarbon is burned in excess air at some given conditions. Saturated air…

A: To explain How saturated air that enters the combustion process of a pure saturated hydrocarbon  at…

Q: For an ideal gas, the residual enthalpy HR is equal to 0 01 O HIG

A: It is required to calculate the value of residual enthalpy HR for an ideal gas.

Q: A real gas mixture consists of 35% N2 and 65% C2H4 (on molar basis), has a pressure of 18 MPa and a…

A: The value of the molar-specific volume of the mixture is to be determined and a comparison of this…

Q: Air at an industrial site contains 1.5 mos CO 2 and the rest N 2 and 02 on a dry basis The air is in…

A: The concentration can be expressed in parts per million. This is the ratio of the mass of solute to…

Q: Joule Thompson’s coefficient for CO2 is of 1.084 degree/atm- and Cp,m = 8.75 cal/(mol degree). Which…

A: Given-isothermal compression of for 50g CO2at 25oCJoule Thompson's Coefficient, μjt=1.084 degree/atm…

Q: valuate the enthalpy change, in kJ, as 4 mole of methanol go from vapour at 264°C to liquid at the…

A:

Q: Calculate the average molecular weight of air  1. From its approximate molar composition of 79%N2,…

A:

Q: At which temperature will carbon dioxide be in the corresponding state to argon at 32 atm and 340K?…

A: Here, we have to find the temperature and pressure of Carbon dioxide such that both are in the…

Q: At 25°C, 0.1 mole of water changed from 1atm to 10atm. find Gibbs free energy AG. Mole volume of…

A: The boiling point is a function of pressure, for instance, the boiling point of water at 1 atm…

Q: A liquid hydrocarbon mixture consists of 20 mol % n-butane (1), 25% n-pentane (2), 35% n- hexane…

A: The objective of the question is to estimate the bubble point pressure of a hydrocarbon mixture at a…

Q: A rigid vessel with an internal volume of 100000 litres contains 2 kg of saturated water mixture at…

A: Given:  Initial Volume = 100000 L = 100 m3   Specific Initial Volume = V = 100 m3/2 KG  = 50 m3/Kg…

Q: 100 Cyd. o% Tel. 10 100% What is the approximate comp that condenses during simple distillation of a…

A: Distillation is a separation process in which the high volatile component is removed from the less…

Q: 2. What pressure is generated when 1kilomole of ethane is stored in a volume of 0.125m³ at 50°C base…

A:

Q: Calculate the fraction of pentane in the liquid that is in equilibrium with the following vapor at…

A: Given that, Temperature T = 80oC = 353.15 K Composition (in mole fraction) of vapor phase Ethane =…

Q: : In some application, there are used C,Hy as a fuel to produce energy, during analysis gases of…

A: The composition of flue gas is given.

Q: x, y (Acetone), mol.frac. a. A 75-mole mixture that is 40.0 mol % ethanol at 60 °C is cooled at…

A:

Q: Calculate AS (unit :JK-1) for the molar transformation H₂O(s, 0°C) decimal places, for example: 15.2…

A:

Q: find the ideal difference from the boiling points of a compound that can normally be distilled ( in…

A: The ideal difference from the boiling points of a compound that can be distilled is to be…

Q: 10. Given that the system is 750 in total, how is this distributed to the ɛ and n phase? Liquid 1200…

A: The phase diagram shows the composition of different phases in which the components are present. In…

Q: Compute the heating value of ammonia in kilocalories per mole (kcal/mol) at standard temperature and…

A: To find the heating value of ammonia, we need to consider the combustion of ammonia in the presence…

Q: 6.18 The variation of vapour pressure of benzene with temperature is given in the table below Т, К…

A:

Q: 17. In a combustion device, propane (C3H3) burns with oxidizer (0.2502 + 0.75CO2) on mole basis at…

A: The combustion of any species gives us carbon dioxide and water. If excess oxygen is supplied the…

Q: Which of these compounds has the lowest vapor pressure? HOH O2 CO2 H2 None of the above

A: Vapor pressure is tenancy of material to transform from liquid state to vapor state. At boiling…

Q: Four hundred and fifty lbmol/h (204 kmol/h) of a mixture of 60 mol% benzene (LK) and 40 mol% toluene…

A:

Q: The fuels that used in Furnaces are gaseous only O solid, liquid or gaseous O liquid only Other:

A: A furnace is a device that provides heat using fuel as a source. The device is used in plants for…

Q: For the following hypothetical Eutectic binary system, A and B, determine the melting point of pure…

A: Hypothetical eutectic phase diagram is given as shown below,

Q: The molar composition of a gas mixture at 273 K and 1.5 x 10 Pa is 0 2 7%, CO 10%, CO 2 15%, N 2…

A: Basis: 100 moles of a gas mixture Therefore, given that, O2 = 7% = 7 moles CO = 10% = 10 moles CO2 =…

Q: A 9 m³ container is filled with 300 kg of R-134a at 10°C.What is the specific enthalpy of R-134a in…

A: This problem is based on thermodynamics. Let us see the data given : Volume of the container = 9 m3…

Q: Provide solution in this given format: Given, required, solution and answer.  1. Hydrogen gas is…

A: Given:  Hydrogen gas is collected over water at 22.5 oC.             Total pressure = Pt = 94.4 kPa…

Q: If this vaporization is done in equilibrium or flash distillation and 40 kg mol are distilled, what…

A: 40kg mol are distilled

Q: A Bi-50% Sb alloy is heated to 400C. The composition of the liquid phase is about 650 630.6 "C 600…

A: The corecct answer is option b) 30%   the detailed solution is uploded below

Q: 1. An ideal gas (diatomic) initially at 275 Kand pressure of 13.8 atm expands to 1.4 atm…

A:

Q: 6. Hexane at 20 °C is burned with 80% excess air at 10 °C in a constant pressure of 100 kPa.…

A: Given: Pt = 100 kPa For Hexane, T = 20 0C For Air, T = 10 0C  Combustion Reaction, C6H14 + 1.8y( O2…

Q: Liquid mixtures of n-octanol (1) and n-decane (2) at atmospheric pressure of 300 K The heat changes…

A: Liquid mixtures of n-octanol (1) and n-decane (2) at atmospheric pressure of 300 K The heat changes…

Q: Question 2 For a binary mixture of Acetone and Hexane (i) If the mixture forms an azeotrope boiling…

A: “Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: A 5 kg/min stream of liquid ethanol-water at 40 °C containing 30% w/w of ethanol will be heated and…

A: (a) What will be the composition  of the liquid at the bottom?(b) What will be the temperature  in…