er at 20°C flows upwards through the 50-mm-diameter cast pipe at 5.88 kg/s. The water is discharged into the sphere at B. Use the equation [(STD) ¹.11 3.7 -1.8 log[( + 6.9 Re B (Figure 1) 1 of 1 Determine the major head loss that occurs over the 3-m-long vertical segment. Express your answer to three significant figures and include the appropriate hL = 0.863 m Submit Correct Part B Previous Answers Also, what is the pressure at A? Express your answer to three significant figures and include the appropriate PA= 372 Submit μA kPa Previous Answers Request Answer ? * Incorrect; Try Again; 3 attempts remaining

Q: The diameter of a pipe carrying water changes gradually from 150 mm at A to 450 mm at B. A is 5 m…

A: Given data,  Diameter at A = 150 mm Diameter at B = 450 mm Pressure at A = 70 Kpa Pressure at B = 50…

Q: This cross-section shows steady incompressible flow in an open channel. Copy the figure, then add…

A: To find: Draw the EGL and HGL.

Q: Water flows through a horizontal bend in the (x, y)-plane and discharges into the atmosphere as a…

A:

Q: B 12 m No. 3 Please note, this is an Equilibrium problem. 8 m 10 m 1.2 m A O C 200kg P 2 m SAMPLE…

A: m=200kgtwo cables AB and ACFINDmagnitude of P and the tension in each cable

Q: circular orifice of 50 mm diameter is fixed to the end of a water pipe of 75 mm diameter. The gauge…

A:

Q: Add the energy grade line (EGL) as a solid line and the hydraulic grade line (HGL) as a dashed line…

A: The pressure head,

Q: Gate AB in figure below is 6 m long and 2 m wide (into the paper). What is the gate minimum weight…

A: angle of inclination  θ=60°vertical height  of water =4.0 mheight of C.G of submerged gate below…

Q: A 300 mm diameter cast-iron pipe of 1000 m length delivers water from an upper reservoir to a lower…

A:

Q: A hydraulic pipeline 3 km long and 50 cm in diameter is used to convey water with a velocity of 1.5…

A:

Q: Repeat Problem 8.12 if the pipe is on a 20° hill. Is the flow up or down the hill? Explain. Problem…

A: Pipe inclination = 20oPipe diameter = 1 in

Q: The hydraulic cylinder extends at 0.5 m/s and determine the angular velocity and the angular…

A: The given figure is shown below:

Q: Q1: For the set up shown in the following figure. Determine the total head, pressure head, elevation…

A: As head at E is more than head at B flow is in upward direction. n = Porosity = 0.34K = Permeability…

Q: 1. A circular orifice 30 mm in diameter, in the interval side of a vessel, discharge water under a…

A:

Sediment transport

Sediment transport or Soil transport is the movement of solid particles, usually due to the combination of gravitational forces acting on the sediment, and the movement of the liquid at which the sediment enters. Soil erosion occurs in natural systems where the particles are sandstones (sand, rocks), mud, or clay; the liquid is air, water, or ice; and the gravitational force that works to move particles to the landing surface. Sediment transportation or soil migration due to the movement of liquids occurs in rivers, lakes, lakes, oceans, and other bodies of water as a result of currents and waves. Transportation is also caused by glaciers as they flow, and to places on earth under the influence of wind. Soil erosion due to gravity alone is possible in most sloping areas, including hills, scarves, cliffs, and the continental shelf — the continental boundary of the slope.