EMPIRICAL GAS LAW T01/SO3 An expandable weather balloon reached a height at which the temperature was 152 °c, the atmospheric pressure was 775 torr and the volume was 66.5 L. If it ascended to a new height at which the atmospheric pressure was 768 torr and its temperature was 45 °C, calculate the new volume (mL). Unit conversion K = C + 273 х 10 1 atm = 760 torr EMPIRICAL GAS LAW T01/S01 A sample of air in a cylinder with a moveable piston has a 2200 ml volume at a pressure of 3650 torr and a temperature of 67 °C. Calculate the pressure (atm) of the gas when the volume changes to 3900 mL and the temperature is 387 K. Unit conversion K = C + 273 1 atm = 760 torr the tolerance is +/-2%

Q: The greatest (most important) contributor to the actual structure of the ion depicted in Figure 4-7…

A: We have to find out most important contributing structure and reason behind it from the given…

Q: An antacid tablet was ground, and 0.510 g of the powder was dissolved in 30.00 mL of 0.500 M HCl.…

A: Mass of antacid = 0.510 g Volume of HCl = 30 mL Molarity of HCl = 0.5 M Volume of NaOH = 9.25 mL…

Q: The Ksp value for calcium sulfate [CaSO4] is 2.40 X 10-5 and a professor made 1825 mL of a CaSO4(ag)…

A: GivenKspCaSO4 = 2.40 * 10-5Ca3(PO4)2 = 0.125 MCa3(PO4)2 dissociate in solution asCa3(PO4)2 (aq)  → 3…

Q: Write and balance the equation representing what happens when Mg(NO3)2(s), a strong electrolyte,…

A: When a strong electrolyte dissolved in water. It dissociates into its respective ions.

Q: 7) Given the reaction and data below: BrO3(aq) + 5 Br(aq) + 6 H(aq) [Br.] 0.100 M 0.100 M 0.100 M…

A: Given , Reaction : BrO3-(aq) +5Br-(aq)+6H+(aq)→3Br2(aq) +3H2O(I)

Q: Methods of Analysis Test #1: Polarity, or Effect of a charged rod on a stream of liquid: This test…

A: Given substances are: acetone, hydrogen monoxide, ethylene glycol, n-butanol, hexane, and toluene.…

Q: s that can be obtained non-invasively such as saliva, sweat, hair, nails, etc. The lab will analyze…

A: For the analysis of Cu in biological samples, both Atomic Absorption Spectrophotometer (AAS) and…

Q: II. b) What is the difference between liquid-liquid, solid-liquid and solid-phase extraction?…

A: We need to differentiate between liquid-liquid, solid-liquid and solid-phase extraction.

Q: Type your answer to the following: Consider the steps the student took in the following scenario.…

A: A student forgot to weigh the filter paper prior to filtering the salt from the sand. To make up for…

Q: We started with 20 mL 1 M acetic acid ~ 0.020 L acetic acid in a flask. (Ka acetic acid =…

A: Millimoles of acetic acid taken=Molar concentration of acid×mL of acid=1 M×20 mL=20 mmol

Q: Predict the reactants of this chemical reaction. That is, fill both sides of the equation to balance…

A: In balancing the reaction number of atoms will be equal both sides (reactant side and product side )

Q: The Ksp value for calcium sulfate [CaSO4] is 2.40 X 10 and a professor made 1825 mL of a CaSO4(aa)…

A: The question is based on the concept of Le-chatlier principle.   It States that when a system at…

Q: It may help to keep the following equation in mind as you work Kw = [H3O+][OH ] = [1 x 10-7 M[1 ×…

A: Solutions are classified in three types (acidic/basic/neutral) based on their pH value which in turn…

Q: For each of the following scenarios, determine if the error will cause the molarity of the…

A: For Error in molarity:- (A) 50ml water add instead of 25ml means solution gets more diluted hence…

Q: the formal charge on CI?

A:

Q: How could you distinguish solution of sodium chloride (table salt) from a solution of sodium iodide…

A: A question based on writing chemical equation, which is to be accomplished.

Q: Absorbance 1.4 1.2 1 0.8 0.6 0.4 0.2 0 0 Absorbance vs. Concentration at 400 nm for solution of M+…

A: To answer: What is the absorbance of a 80 mmol/L solution of the metal at 400 nm?

Q: The correct answer was 0.04, but thanks sm!

A:

Q: Question 4 Determine the position of equilibrium for the ACID-BASE reaction below: 0:- ? H A: ~…

A: Whether equilibrium lies on the right side or left side depends upon the acidity of the reactant and…

Q: Answer the questions below based on the complex ion: [Cu(H2O)6]?+ a) How many (n-1) d electrons are…

A: We have to find out the following answer

Q: Time to turn up the spiciness just a little bit! This next example is similar to the previous one in…

A: An isolated system is identified as one that does not exchange energy or matter with the…

Q: In Figure 7 above, the 3 columns represent 3 different samples. Which column(s) represent pure…

A: Concept:  TLC gives us an idea about the presence of the compound in the column or test tube. Single…

Q: Question 2 Determine the position of equilibrium for the ACID-BASE reaction below: :0: A: :0: B: C:…

A: Answer:Any specie that gains H+ ion during the reaction is called Bronsted-Lowry base and species…

Q: At a physiological temperature of 37 °C, what is the probability of rhodopsin populating the first…

A: To calculate the probability of rhodopsin populating the first excited state. Temperature = 37oC…

Q: AG and AG are equal when Q=

A: Free energy change: change in the free energy takes place while reactants converts to product where…

Q: Based on the data given answer questions. 1,3, and 5 please ?? Question 2 is already answered to…

A: The question is based on the concept of experimental Chemistry.  we need to discuss precision and…

Q: 1a. Throughout the experiment, what are some possible sources of error that could have led to…

A: The objective of this question is to show the experiment involving the separation of table salt and…

Q: Complete the table below. Be sure each of your answer entries has the correct number of significant…

A:

Q: 3. Standard white vinegar you can buy in the grocery store is 5% concentration. That means 5% of the…

A:

Q: PRE-LAB QUESTIONS 1. A student dissolves 2.006 g of FeSO4-7 H₂O in 40 mL of sulfuric acid and then…

A: #2(a): Mass of FeSO4.7H2O standard taken = 2.047 g  Molar mass of FeSO4.7H2O = 55.845 + 32.065 +…

Analytical Tools

Analytical tools or analysis tools help one to get into a conclusion or results from the data collected. Analytical tools can be applied for simple data sets and also in the case of big data analytics.