No chatgpt pls will upvote Each cord in (Figure 1) can support a maximum tension of 95 lb. Suppose y = 34 degreesFigure 1)Determine the maximum weight WW of the block that can be hoisted at constant velocity. 2)What is theangle 0 for equilibrium?Figure1 of 1

Answered: Image /qna-images/answer/9825d6b4-a9d9-48b8-9372-df3aa7f2d47b.jpg

Answered: Each cord in (Figure 1) can support a…

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter5: Displacement And Force In Two Dimensions

Section: Chapter Questions

Problem 82A

See similar textbooks

Similar questions

A piece of bacon starts to slide down the pan when one side of a pan is raised up 5.0 cm. If the length of the pan from pivot to the raising point is 23.5 cm, what is the coefficient of static friction between the pan and the bacon?
A body of mass 100 kg is weighed at the North Pole and at the equator with a spring scale. What is the scale reading at these two points? Assume that g=9.83m/s2 at the pole.
As shown below, if M=5.50kg , what is the tension in string 1?
Show that, as explained in the text, a force F exerted on a flexible medium at its center and perpendicular to its length (such as on the tightrope wire in Figure 5.26) gives rise to a tension of magnitude T=F/2sin() .
Two children push on opposite sides of a door during play. Both push horizontally and perpendicular to the door. One child pushes with a force of 17.5 N at a distance of 0.600 m from the hinges, and the second child pushes at a distance of 0.450 m. What force must the second child exert to keep the door from moving? Assume friction is negligible.
In order to lift a shovelful of dirt, a gardener pushes downward on the end of the shovel and pulls upward at distance l2 from the end, as shown below. The weight of the shovel is mg and acts at the point os application of F2 . Calculate the magnitudes of the forces F1 and F2 as functions of l1 , l2 , mg, and the weight W of the load. Why do your answers not depend on the angle that shovel makes with the horizontal?
If you wish to reduce the stress (which related to centripetal force) on high-speed tires, would you use large- or small diameter tires? Explain.
Swimmers and athletes during competition need to go through certain postures at the beginning of the race. Consider the balance of the person and why start-offs are so important for races.
Jamal and Dayo are lifting a large chest, weighing 207 lb, by using the two rope handles attached to either side. As they lift and hold it up so that it is motionless, each handle makes a different angle with respect to the vertical side of the chest (Fig. P5.76). If the angle between Jamals handle and the vertical side is 25.0 and the angle between Dayos handle and the vertical side of the chest is 30.0, what are the tensions in each handle? FIGURE P5.76
Part of riding a bicycle involves leaning at the correct angle when making a turn, as seen below. To be stable, the force exerted by the ground must be on a line going through the center of gravity. The force on the bicycle wheel can be resolved into two perpendicular components—friction parallel to the road (this must supply the centripetal force) and the vertical normal force (which must equal the system’s weight). (a) Show that (as defined as shown) is related to the speed vand radius of curvature rof the turn in the same way as for an ideally banked roadway—that is, =tan1(v2/rg) . (b) Calculate for a 12.0-m/s turn of radius 30.0 m (as in a race).
Two blocks connected by a string are pulled across a horizontal surface by a force applied to one of the blocks, as shown below. The coefficient of kinetic friction between the blocks and the surface is 0.25. If each block has an acceleration of 2.0m/s2to the right, what is the magnitude Fof the applied force?
Calculate the maximum acceleration of a car that is heading up a 4.00slope (one that makes an angle of 4.00with the horizontal) under the following road conditions. Assume that only half the weight of the car is supported by the two drive wheels and that the coefficient of static friction is involved—that is, the tires are not allowed to slip during the acceleration. (Ignore rolling.) (a) On wet concrete. (b) On wet concrete. (C) On ice, assuming that s=0.100 , the same as for shoes on ice.

SEE MORE QUESTIONS

Recommended textbooks for you

Glencoe Physics: Principles and Problems, Student…

Physics

ISBN:

9780078807213

Author:

Paul W. Zitzewitz

Publisher:

Glencoe/McGraw-Hill

University Physics Volume 1

Physics

ISBN:

9781938168277

Author:

William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:

OpenStax - Rice University

College Physics

Physics

ISBN:

9781938168000

Author:

Paul Peter Urone, Roger Hinrichs

Publisher:

OpenStax College

Glencoe Physics: Principles and Problems, Student…

Physics

ISBN:

9780078807213

Author:

Paul W. Zitzewitz

Publisher:

Glencoe/McGraw-Hill

University Physics Volume 1

Physics

ISBN:

9781938168277

Author:

William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:

OpenStax - Rice University

College Physics

Physics

ISBN:

9781938168000

Author:

Paul Peter Urone, Roger Hinrichs

Publisher:

OpenStax College

Physics for Scientists and Engineers: Foundations…

Physics

ISBN:

9781133939146

Author:

Katz, Debora M.

Publisher:

Cengage Learning

College Physics

Physics

ISBN:

9781285737027

Author:

Raymond A. Serway, Chris Vuille

Publisher:

Cengage Learning

College Physics

Physics

ISBN:

9781305952300

Author:

Raymond A. Serway, Chris Vuille

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

Each cord in (Figure 1) can support a maximum tension of 95 lb. Suppose y = 34 degrees Figure 1)Determine the maximum weight WW of the block that can be hoisted at constant velocity. 2)What is the angle 0 for equilibrium? Figure 1 of 1