An auditorium is to be maintained at atemperature of 24°C dry bulb and 18°C wetbulb temperatures. The sensible heat load is67 kW and 49 kg per hour or moisture mustbe removed. Air is supplied to the auditoriumat 19°C. Determine (a) the relative humidity atcondition 1 and 2 (b) the mass flow rate ofsupply air,volume of condition 1 and 2, and (d) thesensible heat ratio.(c) the enthalpy and specific

Auditorium maintained at, 24°c=DBT=TD,WBT=18°c=Tw Sensible heat lead Qs=67kw Moisture removing…

e removed. Air is supplied to the auditor t 19°C. Determine (a) the relative humidit ondition 1 and 2 (b) the mass flow rat upply air, (c) the enthalpy and spe olume of condition 1 and 2, and (d) ensible heat ratio.

e removed. Air is supplied to the auditor t 19°C. Determine (a) the relative humidit ondition 1 and 2 (b) the mass flow rat upply air, (c) the enthalpy and spe olume of condition 1 and 2, and (d) ensible heat ratio.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Pat Pb ifde A Air enters a window air conditioner at 1 átm. 30 cand 80 % RH at a rate of 10 m³/min and it leaves as saturated air at 14 c°. Part of the moisture in the air that condenses during the process is also removed at 14 c°. Plot the schematic and psychometric of the process and determine the rates of heat and moisture removal from the air. B- ایسا آستا
Q# 2: Chapter 14: Gas vapor mixtures and air-Conditioning (Psychrometric chart) doly to design air conditioning systems using the psychrometric chart, and mass and energy balance relations CLO 4 Air enters an air-conditioning system at 20C and 70 percent relative humidity at a rate of 2 m' /min It is cooled to 15 °C and saturated when the liquid water leaves the system at 32°C. Calculate the amount of water removed from the air and the rate of heat removal from the air.
Dry air inlet temperature 23.9 (t1) Wet air inlet temperature 20.5 (t2) Dry air outlet temperature 24.3 (13) Wet air outlet temperature 23.1 (14) Inlet (A) Outlet (B) Set 2 Set 1 T [°C] Inlet (A) Outlet (B) (b) By using the psychrometric chart, fill up the table below for mass balance. Set 1 v[m/kg dry w[kg/kg dry air] Inlet (A) Outlet (B) 0.0183 0.017 [kg/kg dry air] 61 Set 2 T [°C] 68 24.2 20.8 25.4 24.5 aur] 0.86 v[m³/kg dry air m (c) By using the psychrometric chart, fill up the table below for energy balance. het [kJ/kg dry air] het [kJ/kg dry air [kg dry air/s] 0.0586 m [kg dry air/s] 6
Air enters a humidifier at 34.25°C and 30% RH. If the air leaves the humidifier at 70% RH. Determine: The exit dry-bulb temperature of the air in °C.The saturation effectiveness in %.
าา 3.15.) In air conditioning unit, 71,000 cfm at 80'F dry bulb 60% th and standard atmospheric pressure, enter the unit. The air leaves the wait at 57°F dry bulb and 90% relative humidity. Calculate the following a.) Cooling capacity of the air conditioning unit, in Btu/h 6.) rate of water removal from the unit. (.) sensible heat load on the conditioner, in Btu/h di) latent heat load on the conditioning in Blu/h e.) The dew point of the air leaving the conditioner.
14-121 A laboratory has a volume of 700 m' and must have one complete air change per minute when being used. Outside atmospheric air at 100 kPa, 30°C dry bulb, and 60 percent rela- tive humidity is ducted into the laboratory air-conditioning equipment and conditioned to 20°C dry bulb and 12°C wet bulb, the required state for air supplied to the laboratory. (a) Sketch the system hardware and the psychrometric diagram for the process. (b) What outside atmospheric air mass flow rate is required for the air change, in kg/h? (c) Determine the mass flow rate of water condensed from the atmospheric air, in kg/min. (d) The cooling fluid in the air-conditioning system is chilled water, which has a 15°C temperature rise during the heat exchange process. Determine the chilled water mass flow rate, in kg/min.
27. Air is being heated with steam in a heat exchanger as shown in following fiqure. Saturated water opy yer vapor enters this unit at 35°C at a rate enters the unit at 20°C, and leaves at 30°C at same twarie, process. 10,000 kg/h and leaves as saturated liquid at Marut, iwarr Air generation associated with Determine the rate of MarutPrewari Air 20°C 32°C Steam 35°C 10,000 kg/h Marut Tiwari 30°C Marut Tiwari
Gas-Vapor Mixtures (Properties of atmospheric air) 20. Find the humidity ratio of an air that has tdb = 27 °C and twb = 20 °C with arelative humidity of 55%. (Use PB = 100 KPa)a. 0.0124 lbv/lbab. 0.24 lbv/lbac. 0.133 Kgv/Kgad. 0.0133 Kgv/Kga
On a summer dya in Houston, the temperature is 25 degrees Celsius and the relative humidity is 76 percent. (a) What is the humidity? (b) To what temperature could the air be cooled before condensation would start to take place? (That is, what is the dew point?)
Atmospheric air, which is a mixture of dry air and water vapour, is supplied into ducting with a cooling coil. Initially it has a relative humidity of 0.57, volumetric flow rate of 0.72 mis and temperature of 17°C. The atmospheric air is then passed over a cooling coil such that the temperature drops to 6°C. As this is below the dew point, the water vapour condensates after cooling coll and the air leaves in a saturated state. Assuming the barometric pressure of atmosphenic air to be 1.01325 bar, determine the folowing quantities in question parts () to (vi): (1) Partial pressure of water vapour in the air and water vapour mixture entering, Pul
No card B a O n O O N 14I 5:25 2.7 kg of Steam at 500 kPa and 400°C was cooled in a piston cylinder device until 80% condenses. What is the amount of heat rejected (kJ)? Select one: A. 5968.9 B. 6348.4 X C. 5834.3 D. 6097.2 O E. 6236.8
For a compression ratio of 4.56 (V1/V2), determine the final temperature of air inside the closepiston cylinder assembly if the initial condition is at STP. Final pressure is 847.75kPa a. 273.89260C b. 271.50380C c. 279.13430C d. 277.92850C