42. At 30°C, air-vapor mixture has a relative humidity of 80%. Find the humidity ratio if barometric pressure is 100 Kpa. At 30°C, Psat = 4.246 kpa A. 0.123 B. 0.986 C. 0.054 D. 0.0219

Q: Question 2)) In this figure .A 50mm diameter agitator propeller shaft of is utilized to drive a…

A: Given data: The diameter of the shaft is d = 50 mm. The compressive load on the shaft is P = 125…

Q: During an air-conditioning process, 910 ft3 /min of conditioned air at 64 F and 33 percent relative…

A: Giveninlet temp T1=64Fϕ1=33%

Q: 4.3. The Assmann psychrometer's dry thermometer shows 22°C, wet thermometer - 14°C. The atmospheric…

A: Given: Dry bulb temperature = 22 C Wet bulb temperature = 14 C Atmospheric pressure = 745 Hg mm To…

Q: amount of moisture removed per kg of m/kg da

A:

Q: A large room contains moist air at 35 deg C, 104 kPa. The partial pressure of water vapor is 1.8…

A: Given:Find:The relative humidity, Humidity ratio, The dew point temperature, The mass of dry air in…

Q: Using hfg, Vfg, and Psat at 20°C from the ammonia tables, estimate the saturation pressure, in bar,…

A: Given: Initial temperature: →T1=20°C At this temperature from the ammonia table: →hfg=1185.9…

Q: 5-An unsaturated air stream is undergoing adiabatic saturation process and the outgoing air is…

A: Given: Unsaturated air stream To draw: Schematic and T-s diagram To find: Humidity ration for in…

Q: Using the psychometric chart , calculate the absolute humidity of air which has 50% RH and a…

A:

Q: There are 300 cubic meter/min of atmospheric air initially at 25 C wet bulb temperature and 60 % RH…

A: Given: Flow rate of the atmospheric air→Qa=300 m3/min=5 m3/s Wet bulb temperature of the atmospheric…

Chemical and Phase Equilibrium

Phase diagrams or equilibrium phase diagrams are the graphical representations that show the phase transformations of the constituting elements with respect to the pressure, temperature, and compositions. The diagrams show the conditions that limit the different phases, namely solid, liquid, and gas. The diagram can also be utilized to verify the relations between the state variables. Most of the phase diagrams are temperature-pressure phase diagrams, with the variable parameter as the composition. Usually other variables such as solubility and pressure parameters are not indicated in the phase diagram. For a one-component system (unary phase diagram), the phase diagram is generally a function of temperature and pressure as the state variables, or temperature and volume. However, for a binary system (two-phase) having two components, the phase diagram is a function of temperature and composition as the state variables only. Coexisting of the different phases of the constituting elements is indicated in the phase diagram. A ternary phase diagram can be characterized by consisting of three phases in equilibrium.