The activated sludge processIs an example of a suspended growth systemachieved by mixing untreated sewage with the1.biomass2.Only is feasible because the density of themicroorganisms is greater than that of waterRequires the input of oxygen to maintain thehigh concentration of biomass3.O 3 onlyO 2 only2 and 3All of the above

Answered: Image /qna-images/answer/eb75aa61-34af-421d-82dc-c025375b853e.jpg

e activated sludge process Is an example of a suspended growth syste nieved by mixing untreated sewage with the mass Only is feasible because the density of the croorganisms is greater than that of water Requires the input of oxygen to maintain th h concentration of biomass 3 only 2 only 2 and 3 All of the above

e activated sludge process Is an example of a suspended growth syste nieved by mixing untreated sewage with the mass Only is feasible because the density of the croorganisms is greater than that of water Requires the input of oxygen to maintain th h concentration of biomass 3 only 2 only 2 and 3 All of the above

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

An effluent stream sample (500 mL) from a metal-working facility contains 0.52 g nickel sulphate. (i) What is the nickel concentration of this effluent stream (in mg/L)? (ii) Would you regard this concentration as suitable for discharge to the local sewage system? (iii) How much total nickel (in kg) leaves the facility per year in this stream if ~1 ML of effluent is produced?
Poorly treated municipal wastewater is continuously discharged directly into a lake. The discharge from the wastewater plant into the lake occurs at a flow of Qd = 1 m3/hr. The concentration of phosphate (PO43, M = 95 g/mol) in the discharge flow (Cxd) that is decaying with first-order kinetics is 100 mg/L. The lake is a well-mixed water body of 100 m3. (Phosphate is naturally uptaken by algae with a first- order decay rate constant equal to 0.20/day.) The concentration of phosphate in the incoming river (Cx,r) is 10 mg P/L. The incoming river flow rate is Q, = 10 m3/hr. %3D a) Which of the following equations represent the correct mass balance equation? O va = CxQr - CxdQd -QoutCxvout" kCx,outV %3D O 0 = Cx,Qr + CxdQd -QoutCxvout" kCx,outV X,r O 0 = CxQr + CxdQd -QoutCxvout- kV O 0 = Cx,dQr + Cx,,Qd -QoutCxout- kCxoutV
A Granulated Activated Carbon (GAC) adsorption laboratory column 10cm in diameter and 3m deep, is found to produce good results in COD removal when operated at a flow of 50L/h. The porosity of the GAC is 0.5 Calculate the following: The application rate in m/h. The residence time, t, in the column. The volumetric flow rate, Vb, in bed volumes per hour, for this residence time. You need to design a GAC system consisting of two columns in series for treating the same water at a rate of 0.5 ML/d. Practical considerations limit the diameter of the columns to 3m. Calculate the minimum required height of the columns.
Q- The sludge from the aeration tank of the activated sludge process (ASP) has solids content (by weight) of 2%. This sludge is put in a sludge thickener, where sludge volume is reduced to half. Assume that the amount of solids in the supernatant from the thickener is negligible, the specific gravity of sludge solids is 2.2 and the density of water is 1000 kg/m³. What is the solids content (by weight) of the thickened sludge?
Air is passed through the sludge 1. To provide the biomass with the oxygen required for removing the organic matter from the sewage 2. To keep the biomass suspended thus bringing them in close contact with the organic matter in the sewage 3. To kill pathogens 4. To reduce the hydraulic retention time and thus reduce the size of the bioreactor O 2 and 3 only O 1 and 2 only O All of the above O 1,2 and 4
2. Cadmium is a pollutant of concern in mining. The initial concentration of cadmium in a mining wastewater (also called acid mine drainage) is 0.1 mg/L, and the EPA Maximum Contaminant Level (MCL) is 0.005 mg/L. What must the pH be so that the wastewater does not exceed the EPA MCL? Given: Cd(OH)2 → Cď²* + OH (unbalanced) K, = 5.33 x 1015 Cd(OH)2: Cd2+ = 112.4 g/mol 17.0 g/mol = 146.4 g/mol OH- =
Wastewater is treated with an activated sludge plug flow reactor, similar to one seen at the Norman Water Reclamation Facility. The BOD5 after primary treatment is 100mg/L and the effluent limit is 5 mg/L BOD5. Use 1.00 h-1 as the maximum specific growth rate constant and typical values for the other biokinetic constants. The biomass concentration in the reactor is 2,500 mg/L MLSS based on a recycle ratio of 1. Calculate the mean cell residence time, in hours for this system
The secondary clarifier in the secondary treatment stage Has a uniform distribution of solids throughout its depth Further removes organic matter in the influent sewage by settlement Allows for the separation of the biomass from the treated wastewater Is optional in the activated sludge process because the bioreactor treats the sewage to sufficient effluent standards
Activated sludge is treated in an aeration tank. The HRT is 8 hr, and the SRT is 6 days. The influent BOD concentration is 200 mg/l, and the effluent BOD concentration is 10.2 mgn. With a yield coefficient of 0,4 and a microbial death rate of 0.1 day1, what is the biomass concentration in the tank?Need Help ASAP
An activated-sludge system is to be used for secondary treatment of 15,000 m3/d of municipal wastewater. After primary clarification, the BOD is 130 mg/L, and it is desired to have not more than 5 mg/L of soluble BOD in the effluent. A completely mixed reactor is to be used, and pilot-plant analysis has established the following kinetic values: Y = 0.6 kg/kg, kd = 0.07 d-1. Assuming an MLSS concentration of 2,750 mg/L and an underflow concentration of 11,000 mg/L from the secondary clarifier, determine the followings. [Use θc (MCRT or SRT) = 10 day.] 5.1. The volume of the reactor. 5.2. The mass and volume of solids that must be wasted each day. 5.3. The recycle ratio. Hint: θc = VX/QwXu : MCRT (mean cell-residence time) [or SRT (solids retention time)]; average time microbes spend in reactor = ratio of total biomass in reactor to biomass wasted per given time; currently most commonly used design parameter F/Mv: inversely proportional to SRT; ≈U (cell's specific substrate…
Question 90/100 A trapezoidal section has a bottom width of 20 ft and side slope of inclination 1:1.5. Its friction factor f = 0.056. The depth of the channel is 4.0 ft. The channel slope is 0.025.Use C = √(8g/f) Compute the flowrate in cu.ft/s 1937 1370 2373 2062
Which of the following is not a piece of EPA legislation designed to protect the environment? Clean Water Act Clean Air Act O Civil Rights Act ORCRA D Question 2 What water contaminant was responsible for the 2014 Flint, Michigan water crisis? O Mercury Lead O PCB Giardia Question 3 What condition must be satisfied for us to use the Continuously Stirred Tank Reactor (CSTR) approach? Uniform well-mixed conditions Mixing occurs only in the axial direction The substance is conservative There is only one inflow channel D Question 4 A plug flow reactor is O Less efficient at removing pollutants than a CSTR Has the same efficiency at removing pollutants as the CSTR More efficient at removing pollutants than a CSTR Can be more or less efficient than the CSTR depending on the pollutant