During Destructive test, the specimen is O a. Damaged O b. Not damaged O c. not affected O d. Not broken

Q: 4X .250-20 UNC-2B 1.260±.010 .984±.010 2.600 ø2.012 2.008 Ø 3.350

A: the position tolerance for the diameter hole  2.012/2.008 and the diameter stud 2.006/2.002 position…

Q: 5. How many degrees of freedom (DOFs) does this arm have? M

A: To determine:Number of degree of freedom

Q: The J-shaped member shown in the figure (Figure 1) is supported by a cable DE and a single journal…

A: Given DataThe cylinder has a weight of WB=5.60lbThe Vertical force applied to member C, F=1.50 lbThe…

Q: The diameter of the bolt is .500 inches. Force

A: given:diameter of the bolt d=0.500inforce F= 750pound

Q: What should be considered to ensure the safety of a structural or mechanical member?

A: If in a member or a structure the induced stress is less than or equal to the limiting material…

Q: A single centerline is drawn in Longitudinal Horizontal Circular All

A: 1) ALL   Centerline indicate a circular feature on a drawing. In 2D, most circular features look…

Q: What happens to the Marin temperature factor (kd) when the desired operating temperature of a…

A: What happens to the Marin temperature factor (kd) when the desired operating temperature of a…

Q: What happens when the member is confined?

A: Confined member: If a member is confined then it means it is fixed to a position.

Q: The 2XXX, 6XXX, and 7XXX series of raw aluminum alloy's or non-heat treatable and the 1XXX, 3XXX,…

A: Given: The 2XXX, 6XXX, and 7XXX series of raw aluminum alloy's or non-heat treatable and the 1XXX,…

Q: There are two samples, A and B, ere tested by Rockwell hardness test. Sample A is tested in B scale,…

A: HRB means the Hardness Rockwell B scale HRB means the Hardness Rockwell F scale

Q: What is the cause of slipping inductile failure?

A: Causes of slipping in ductile failure are as follows

Q: In the plane cage system given in the figure, the external force is P=5 kN, and the lengths of the…

A: In the plane cage system given in the figure, the external force is P=5 kN, and the lengths of the…

Q: A kick occurs because the pressure inside the wellbore annulus is higher than formation pressure. a.…

A: The kick formation depend on the pressure gradient in wellbore annulus and formation pressure.

Thermal Properties of Materials

In mechanical engineering, the thermal property is represented as the physical quantity that is relevant to the application of heat. The thermal properties are evaluated by variations in any specific material due to low heat or high heat. The quantities that influence the thermal property of the materials are mass, density, temperature, and many others.