During a change of state of a substance, the temperature of the substance does not change because: A the average translational kinetic energy of its particles is constant B The internal energy of the substance is constant. C The potential energy of its particles is constant. D The average kinetic and potential energy of its particles is constant.

During a change of state of a substance, the temperature of the substance does not change because: A the average translational kinetic energy of its particles is constant B The internal energy of the substance is constant. C The potential energy of its particles is constant. D The average kinetic and potential energy of its particles is constant.

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter21: Heat And The First Law Of Thermodynamics

Section: Chapter Questions

Problem 7PQ

See similar textbooks

Similar questions

The potential energy function for either one of the two atoms in a diatomic molecule is often approximated by U(x)=a/x12b/x6 where x is the distance between the atoms. (a) At what distance of separation does the potential energy have a local minimum (x=) ? What is the force on an atom at this separation? (c) How does the force vary with the separation distance?
(a) How long will the energy in a 1470kJ (350kcal) cup of yogurt last in a woman doing work at the rate of 150 W with an efficiency of 20.0% (such as in leisurely climbing stairs)? (b) Does the time found in part (a) imply that it is easy to consume more food energy than you can reasonably expect to work off with exercise?
A block of mass m = 200 g is released from rest at point along the horizontal diameter on the inside of hemispherical bowl of radius R = 30.0 cm, and the surface of the bowl is rough (Fig. P8.23). The blocks speed at point is 1.50 m/s. Figure P8.23 (a) What is its kinetic energy at point ? (b) How much mechanical energy is transformed into internal energy as the block moves from point to point ? (c) Is it possible to determine the coefficient of friction from these results in any simple manner? (d) Explain your answer to part (c).
A crate of mass 10.0 kg is pulled up a rough incline with an initial speed of 1.50 m/s. The pulling force is 100 N parallel to the incline, which makes an angle of 20.0 with the horizontal. The coefficient of kinetic friction is 0.400, and the crate is pulled 5.00 m. (a) How much work is done by the gravitational force on the crate? (b) Determine the increase in internal energy of the crateincline system owing to friction. (c) How much work is done by the 100-N force on the crate? (d) What is the change in kinetic energy of the crate? (e) What is the speed of the crate after being pulled 5.00 m?
(a) How high a hill can a car coast up (engines disengaged) if work done by friction is negligible and its initial speed is 110 km/h? (b) if, in actuality, a 750-kg car with an initial speed of 110 km/h is observed to coast up a hill to a height 22.0 m above its starting point, how much thermal energy was generated by friction? (c) What is the average force of friction if the hill has a slope of 2.5 above the horizontal?
A hand-driven tire pump has a piston with a 2.50-cm diameter and a maximum stroke of 30.0 cm. (a) How much work do you do in one stroke if the average gauge pressure is 2.1105 N/m2 (about 35 psi)? (b) What average force do you exert on the piston, neglecting friction and gravitational force?
(a) What is the average metabolic rate in watts of a man who metabolizes 10,500 kJ of feed energy in one day? (b) What is the maximum amount of work in joules he can do without breaking down fat, assuming a maximum eficiency of 20.0%? (c) Compare his work output with the daily output of a 187W (0.250horsepower) motor.
(a) Calculate the work done on a 1500-kg elevator car by its cable to lift it 40.0 m at constant speed, assuming friction averages 100 N. (b) What is the work done on the lift by the gravitational force in this process? (c) What is the total work done on the lift?
Consider these scenarios and state whether work is done by the system on the environment (SE) or by the environment on the system (ES): (a) opening a carbonated beverage; (b) filling a flat tire; (c) a sealed empty gas can expands on a hot day, bowing out the walls.
(a) What is the average power consumption in watts of an appliance that uses 5.00kWh of energy per day? (b) How many joules of energy does this appliance consume in a year?
A power plant has been proposed that would make use of the temperature gradient in the ocean. The system is to operate between 20.0C (surface water temperature) and 5.00C (water temperature at a depth of about 1 km). (a) What is the maximum efficiency of such a system? (b) If the useful power output of the plant is 75.0 MW, how much energy is absorbed per hour? (c) In view of your answer to part (a), do you think such a system is worthwhile (considering that there is no charge for fuel)?
Problem 12: When water flows through river rapids or over a waterfall, it experiences a decrease in height and thus a decrease in gravitational potential energy. Some of this energy goes into producing noise and eroding rock, but much of the energy goes into heating the water. A river flows over a waterfall of height h = 41 m. Assume all the available gravitational energy is converted into internal energy of the water. There is no change in the kinetic energy, because the flow speed of the river is the same above and below the waterfall. Part (a) Enter an expression for the change in temperature of the water, in terms of the height of the waterfall, h, the specific heat of water, c, and the acceleration due to gravity, g. Part (b) Calculate the change in temperature, in degrees Celsius, of the river water in this problem. The specific heat of water is 4.19×103 J/(kg⋅°C).