Determine the volume of earthwork in excavation of the foundation trench. AA6 mPlan4 m(a) 6.528 cu. m(c) 8.832 cu. m80 cmSection A-AThe above figure represents plan and section ofan excavation layout. The volume of earthworkin excavation of foundation trench is60 cm(b) 8.064 cu.m(d) 9.600 cu. m

Given. Plan and section of an excavation layout is given in figure.Find the volume of earthwork in…

Answered: Determine the volume of earthwork in…

Engineering

Civil Engineering

Determine the volume of earthwork in excavation of the foundation trench.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 900 sand 3 m Ysar = 22 KN/m Clay 2.5 m Yaar = 26 KN/m 5 m с — C - Cc =0.25 2.5 m AJ = 27 KN/m

Q: Find Wn for the shown slab when M- ve=2Mn and M+ve=Mn for the shown slab use Yield Line Theory XX…

Q: 3- For the two columns shown in Fig. (2), design a foundation system using a strap beam. The…

A: Strap footing is a combined containing two column footing connected by a concrete beam called strap…

Q: A rectangular footing shown below, 10m x 15m, is uniformly loaded with q=100 kPa. Determine the…

Q: 10

A: f'c=5500 psi (column) f'c=3000 psi Pu=550 k qall=10000 psi fy=60000 psi

Q: 1. Volume of excavation for the foundation with depth 0.2 m 2. The amount of construction materials…

A: All the details of the plan and footing are given in question.We will use long-wall short-wall…

Q: Chapter 5: Settlement of Buildings X6-3) Determine the total immediate settlement of the rectangular…

A: The given data is from the figure: Df/B=1/3=0.33L/B=4/3=1.33μo=0.93AndFor…

Q: A footing carrying a load of 1500 kN. Depth of Footing is 3 m. maximum tolerable settlement is 45 mm…

Q: What are the Methods in widespread use for determining a soil’s bearing capacity?

A: Soil’s bearing capacity is the soil's capacity to carry load.

Q: B- Describe standard penetration test and its application in foundation engineering Values of N. 9 =…

A: Brief concept- Standard Penetration Test (SPT)- It is a field test and it is used to determine the…

Q: Consider excavation of a simple long trapezoidal pit with a joint highlighted in the pit slope,…

Q: Explain the Settlement of Shallow Foundations on Sand (after Vesic 1973).

A: Overview of vesic (1973) and why it was less influencial The settlement of load behaviour of…

Q: 2. What is the difference between shallow foundations and deep foundations? Where would you…

A: Given : a) shallow foundation and deep foundation…

Q: a).An excavation is to be made for a footing 1.5 m x 1.5 m. However during the excavation you…

A: We need to first dewater the pit which is not possible at instance as water is getting accumulated…

Q: 42' 12' 26' 26 15' 42' Figure 1

Q: Define Baguelin et al. (1978) approach to estimating foundation settlements for preliminary design ?

A: Answer:- Baguelin approach:- Baguelin et al. (1978) present a simplified approach to estimating…

Q: 2m x 6m singular sitting on a sandy ground If the total foundation pressure of a foundation is 150…

A: solved

Q: The measured standard penetration numbers at various depths of the soil profile shown in Figure (1)…

A: Overburden pressure assuming γsoil=20KNM2N1=20×3501.5×20+70=70similarly at depth of…

Q: In a highway construction site, excavation with sloping is planned for soils with an unconfined…

A: According to Occupational Safety and Health Administration, soil are classified into 4 categories…

Q: a. A layer of sand, of saturated unit weight overlies a layer of clay, of saturated unit weight. A…

A: It is required to draw the soil profile and find consolidation settlement of clay at it's centre.

Q: Refer to Figure 5.9. For a continuous foundation in two-layered clay, given:●● γ1 = 121 lb/ft3,…

Q: Q#3:…

A: The allowable safe bearing capacity is given by: Where,

Q: Define the method for estimating the settlement of shallow foundations on sands presented by Arnold…

A: In geotechnical engineering, it is important for an engineer to calculate the settlement in…

Q: The average correcte N60 = 7 in the effective zone for a square footing (1m x 1m) located at a depth…

A: If the soil support of the continuous foundation yields due to the load imposed by the foundation,…

Q: Given: a square footing (BxB) shown in figure. If the allowable consolidation settlement (Sc = 25…

Q: Determine the width B of square foundation within sandy clay

A: Step 1:Step 2:

Q: Find the depth of the borehole required for the site investigation in which a circular footing of 3…

A: d- 3m Df - 2m P -1560 kN WT depth - 1.5m γd- 17 kN/m3 γsat- 19 kN/m3 To find the Depth of borehole…

Q: Foundation Engineering Homework: The allowable settlement for a continuous footing shown in the…

A: Assume constant stress will go below the base of the foundation.

Q: Question 52 What is the MAXIMUM elevation variation of anchor rod tops from the foundation? 1. 1 2…

A: In the design of Column base plate, there are variations arise due it's construction in Anchor bolt…

Q: When revising the characteristic value of the subgrade bearing capacity, which of the following…

A: Brief concept introduction- Subgrade bearing capacity- Subgrade materials are often classified…

Q: he amount of support needed in an excavation depend on Select one: a. The strength of footing b.…

A: The amount of the support needed in an excavation depends on

Q: Select the value of Cs to use for the edge of a 2'x20' flexible strip footing. Table 7-1 Values of…

A: cs values for different foudations are given as followscs value for flexible strip footing of…

Q: Consider the strip footing shown in the figure below. The soil consists of sand with f’ =36° and…

A: The angle of friction = 36° The effective cohesion (c') = 0 The saturated unit weight of the clay =…

Q: The exit gradient for the following weir or a permeable foundation as per Khosla's method will be ¥…

Q: If the square footing has an 800mm edge with a 300mm thickness, and that the 200mm x 200mm column…

A: Compaction: The reduction of air voids from the tightly packed soil particles is known as…

Q: (127) 12.7 Refer to Figure 12.10. Given: H = 7 m, y = 18 kN/m³, d' = 25°, c' = 12 kN/m², unit length…

A: Given: H = 7m γ=18 kN/m3 ϕ=25o C = 12 kN/m2 α = 10o

Q: By using the center line length method- find the foundation excavation quantity plotted in chart…

A: There are various methods of estimating the quantities in a construction activity. Two of the most…

Concept explainers

Measuring site work, Excavation and Piling

Bid drawings typically include very little material about the precise requirements of site work operations, measuring site work and excavation work differs from measuring most other works on a construction project. The actual site work conditions are not provided and also the dimensions of the excavations are not known during the pre-construction phase. The precise measurement of the excavation and backfill of the earth material and topsoil is important for a contractor to decide upon the total cost required for the process. All the works should be carried out under OSHA (Occupational Safety and Health Administration) standards to ensure the safety of the workers.

Question

Determine the volume of earthwork in excavation of the foundation trench.

A
A
6 m
Plan
4 m
(a) 6.528 cu. m
(c) 8.832 cu. m
80 cm
Section A-A
The above figure represents plan and section of
an excavation layout. The volume of earthwork
in excavation of foundation trench is
60 cm
(b) 8.064 cu.m
(d) 9.600 cu. m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Measuring sitework, excavation and piling

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Indicate the typical time period associated with foundation settlement for the condition where granular soil provides the support and for the condition where saturated clay provides the support. Discuss the reasons for the difference.
Question,
What are the Conditions for ultimate soil bearing capacity: involved soil zones and related foundation settlements?
Use 4 decimal places in all solution
Calculate the amount of foundation excavation works for the diagram below if you know that the excavation depth = one meter
Use Housel method to determine the size of square footing required to carry a column load P = 55 tons if the two plate loading tests results are as given below:- Plate size (1) = 30x30 cm, corresponding load- 6.2 tons; relative to 1.0 cm settlement. Plate size (2) = 45x45 cm, corresponding load -12 tons; relative to 1.0 cm settlement. 60 Martes 02(b):
In the principle of dividing foundation design grades, what is not considered ( ). ◼A. Complexity of subgrade ◼B. Scale and functional characteristics of buildings ◼C. The extent to which subgrade problems may cause damage to buildings or affect normal use ◼D. Type of building foundation
A rectangular footing has dimensions shown and is acted upon by a dead load of 382 kN and a live load of 536 kN. The column dimension is 307x560 mm where the shorter dimension is parallel to B. The thickness of the footing is 656mm. fc=28 MPa and fy=420 MPa for diameter 20mm bars. A=2.6m and B=5.2m
This is Civil Engineering. Specifically Foundation Engineering. Please post thorough answers and work. Any plot needs to be computer generated. Thank you
a) What are the functions and functional requirements of foundations and slabs? b) With aid of well labelled diagrams, explain the classifications and the types of foundations? c) Settlement and Geotechnical studies of foundations and slabs. d) What are the preparations and placement of foundations e) What are the choice of selection of foundation f) What are the preparations and placement of slabs
Draw the figure.
Describe about the Variation of foundation–soil contact pressures for rigid and flexible foundations on cohesive soil, and related settlement pattern.