Determine the total number of revolutions of the flywheel during the entire time interval. The correct answer is 8.06 revs.

Q: Consider the portion of an excavator shown. At the instant under consideration, the hydraulic…

A:

Q: The angular position of a radial line in a rotating disk is given by the clockwise angle 0 = 3.3t³ -…

A: According to the given dataWe need to findangular displacement for the given interval

Q: The rotation of an element in a mechanism is managed so that the rate of change of angularvelocity…

A: Θ=λωo​​∗(1−e−λ.t)ω=ωo​.e−λ.tα=−ωo​.λ.e−λ.t Explanation:Given,∂Θ∂ω​=−λIntegrating both…

Q: The motion of A is controlled by the hydraulic cylinder. As A moves to the right, there are two…

A: The velocity of A is The acceleration of A is

Q: For the following mechanism, if velocities vc = 4.7 m/s, and VA = 3.8, determine the magnitude of…

A: Given   Velocity, vc = 4.7 m/s                  vA = -2.1 m/s Find   Angular velocity   Linear…

Q: The rotor of a gas turbine is rotating at a speed of 6900 rpm when the turbine is shut down. It is…

A: Given Data  No. of revolutions, N=6900 rpm Initial angular velocity,  ω0=2πN60=2π(6900)60=722.57…

Q: In a rotating body, when a body rotates with the angular velocity of 53.5 rad/sec, Calculate the…

A: for solution refer below images.

Q: The rotor of a gas turbine is spinning at a speed of 6,300 rpm when the turbine is deactivated. It…

A: Rotor initial speed Ni = 6300 rpm Rotor final speed Nf = 0 rpm ( rotor reaches rest )Time taken t =…

Q: acceleration of the follower rod A as a function of 0.

A:

Q: 4 in. - 16 in. P M. Lr=1 in.

A: Given:  Angular velocity of the motor is,  ωm=411-e-t rads. The radius of the motor is rm=1 in. The…

Q: Erza is running her wagon on straight road while chasing Natsu at 200.0 kph. After driving for some…

A: v=200 kphv=200×518=55.55 msecθ=180° or π radian r=13 msince v=rω so ω=vrω=55.5513=4.273…

Q: the slider crank mechanism shown in Fig. 2-29, the crank is rotating at 200 rpm. Determine the…

A: Given:N=200 rpmθ=30°r=600 mml=2500 mm

Q: oscillating crank is defined by the relation Θ=6sin(πt/4)-sin3 where 'Θ' is expressed in radians and…

A:

Q: A connecting rod is supported by a knife-edge at point A. For small oscillations the angular…

A: maximum angular velocity when t = 2sec.

Q: A wheel rotating with 17 rev/s is uniformly accelerated at 0.3 rad/s2 for 9 seconds. It then rotates…

A:

Q: The guide with the vertical slot is given a horizontal oscillatory motion according to x = 5.1 sin…

A: X = 5.1 inX = 5.1 Sin (3.4t)y = x²/8

Q: 3 he linear velocity of A is represented by Va. Determine the linear velocit fB,C, and D on link 3…

A:

Q: A shaft rotating with 10 rev/s is uniformly accelerated at 0.3 rad/s2 for 8 seconds. It then rotates…

A:

Q: A wheel rotating with 15 rev/s is uniformly accelerated at 0.6 rad/s2 for 7 seconds. It then rotates…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: displacement of the valve rod is 25 mm. If the outstroke and return stroke is simple harmonic…

A: Given: Speed of the engine=1500 rpm Hence the speed of the camshaft=15002=750 rpm Hence the angular…

Q: Problem 1: A disk at rest experiences a constant angular acceleration for t 55 s, at the end of…

A: Given Data: The time for constant angular acceleration experienced by the disk is, t=55 s. The…

Q: A flywheel rotates with a uniform speed of 111rpm for 6.1 seconds .Then it is uniformly accelerated…

A: Note: As per the company guidelines we will answer the first three subparts for you. For the rest of…

Q: 7. A Frisbee spins with a frequency of 15HZ. If the Frisbee has a diameter of 35cm, calculate the…

A:

Q: 1.The maximum angular velocity in (rad/s) is  2.The total angular displacement in (rad), θ=

A:

Q: The design of a camshaft-drive system of a four-cylinder automobile engine is shown. As the engine…

A:

Q: A four wheel drive accelerate uniformly from 50Km/hr.to a speed of 80 km/hr. over a distance of…

A: Given Data The initial speed of the wheel drive, u=50 Km/hr u=50×518u=13.88m/s The final speed of…

Q: A four wheel drive accelerate uniformly from 60Km/hr.to a speed of 90km/h. over a distance of 450m.…

A: Displacement of an object is defined as the shortest possible change in the position of an object in…

Q: When the speed reached 120 km/h, the car entered a curved road of radius 150 m. The brakes are…

A:

Q: A child is playing with a tyre of radius 0.5m. She accelerates it from 5 rpm* to 25 rpm in a time of…

A: The linear acceleration of the tyre is 0.07 m/s2. Therefore, option (d) is correct answer.

Q: The telephone-cable reel is rolled down the incline by the cable leading from the upper drum and…

A:

Q: Packages enter the 10.9-ft chute at A with a speed of 3.4 ft/sec and have a 0.39g acceleration from…

A:

Q: A sphere is suspended from a string of height 1 m. The sphere begins to rotate uniformly in a circle…

A:

Q: The rotor of a gas turbine is turning at a speed of 6,600 rpm when the turbine is turned off. It is…

A:

Q: Situation #5: The body rotates according to the relation a = 4t, where a is in rads/s and t in sec.…

A: dw/dt = alpha it can be integrated to get the expression of angular velocity and this can be further…

Q: A flywheel rotates with a uniform speed of 112rpm for 5.7 seconds .Then it is uniformly accelerated…

A: Note :- you have posted multiple questions on single window. As per the guidelines I am able to…

Q: A shaft 5.0 cm in diameter and rotating at 2,400 rpm, comes to a full stop in 6.0 seconds. It slows…

A:

Q: The design of a camshaft-drive system of a four-cylinder automobile engine is shown. As the engine…

A:

Q: of stion The hook is attached to a cord which is wound around the drum. If it moves from rest with…

A: al = 20 ft/sec² Radius r = 2 ft Time t = 2 sec

Q: A flywheel rotates with a uniform speed of 111rpm for 6.1 seconds .Then it is uniformly accelerated…

A:

Q: Initially at rest, a gear starts rotating with a constant angular acceleration a = 5 rad/s². What is…

A: Introduction: A pseudoscalar, angular acceleration, exists. If the angular speed rises…

Conservation of Energy

In physics, the rule of the conservation of energy states that energy doesn’t disappear from the atmosphere; instead, it changes its form from one type to another. Energy is one of the most important physical quantities in nature, and it cannot be created or destroyed — only transformed.