At hydroelectricelectric power plant site,available head and flow rate are 12 m and 6m3/srespectively. If the turbine to be installed isrequired to run at 2 rev/sec with an over-allefficiency of 60%. Determine the suitable type ofturbine for this site ?

Given data, Head of the hydroelectric plant is,h= 12 m Flow rate,Q=6m3/sSpeed of the turbine,N= 2…

Answered: Determine the suitable type of

Engineering

Civil Engineering

Determine the suitable type of

Sustainable Energy

2nd Edition

ISBN:9781337551663

Author:DUNLAP, Richard A.

Publisher:DUNLAP, Richard A.

Chapter18: Energy Storage

Section: Chapter Questions

Problem 20P

See similar textbooks

Similar questions

At hydroelectric electric power plant site, available head and flow rate are 12 m and 6m3/s respectively. If the turbine to be installed is required to run at 2 rev/sec with an over-all efficiency of 60%. Determine the suitable type of turbine for this site ?
A centrifugal pump is used to move water from the lower reservoir to the upper reservoir at a rate of 10 cfs. If the water surface elevations of the two reservoirs are separated by 100 feet, and the pump operates at an overall efficiency of 70%, determine the required power input (in kW) to the motor. Assume no losses.
PROBLEM E A hydroelectric power plant operates under a discharge of 500 cfs with 90 % turbine efficlency. The overall head loss Is 1.5 times the velocity head In the 7-ft-dlameter penstock. With the conditions stated, determine the following: (a) the velocity (ft/s) In the penstock, (b) the head loss (ft). (c) the head (ft) extracted by the turbine, (d) the power Input (hp) to the turbine, and (e) the power output (hp) expected from the turbine. 30 ft Water d=7 ft 5 ft
The dam on Hydaway Lake on Liberty Mountain (not really sure if a dam exists)has the potential to provide some power to the Hydaway Outdoor Center. Before that canhappen Sparky Consulting needs to determine the potential power output. A diagram of thedam and proposed turbine location are provided below. The lake water flows through an 8-inchdiameter pipe (location A) into the turbine. The discharge pipe downstream of the dam has avolumetric flow rate of 300 ft3/min. The head loss through the piping system is 5 ft. The specificgravity of the water is 62.4 lbf/ft3. What is the power output (in horsepower) of the turbine if theturbine efficiency is 70 percent?
Express your solution in 4 decimal places.
A factory is located near a waterfall where the usable head for power generation is 26 m. The factory requires continuous power of 500 kW throughout the year. The river flow in a year is (a) 6 m3/sec for 6 months, and (c) 2 m3/sec for 6 months: (i) If the site is developed as a run-of-river type of plant, without storage, determine the standby capacity to be provided. Assume that overall efficiency of the plant is 85%. (ii) If a reservoir is arranged upstream, will any standby unit be necessary, and what is the excess power?
8. Energy Equation Water at the Lake William Dam enters a hydraulic turbine through a 30 cm diameter pipe at a rate of 0.6 m³/s and exits through a 25-cm diameter pipe. For the system, elevation effects are negligible and the pressure drop across the turbine is measured to be 148 kPa. For a combined turbine-generator efficiency of 83 percent, calculate (a) hurbine and (b) Wubrine- You look in the FE handbook and see: W turbine = 7/turbine-gen”ightutine, e turbine-genhtubine, e 30 cm diameter 25 cm diameter Turbine Generator
The water is pumped to a higher elevation. diameter = 450 mm pressure = 250 kPa (it is maintained at the summit point) *Summit point = the pipe is 110 meters above the water reservoir* Q (discharge) = 1.56 m^3/sec Total loss due to friction = 8 m Determine the output power that must be furnished to the water. Kindly refer to the figure below.
Read the question carefully and give me right solution with clear calculations. Note: If you don't know the solution please leave it but don't give me wrong solution. At a river a suitable site for a run-of-the river installation has an available head of 13 m between the water intake and the turbine house. Environmental guidelines permit to extract water for hydropower only if it is in excess of 2.8 m3/s. Estimate the power generated in kW when the flow in the river is 10.9 m3/s for a turbine with an efficiency of 90%. Present the answer as integer in kW.
A hydroelectric power plant operates under a discharge of 500 cfs with 90 % turbine efficiency. The overall head loss is 1.5 times the velocity head in the 7-ft-diameter penstock. With the conditions stated, determine the following: (a.) the power input (hp) to the turbine, and (b.) the power output (hp) expected from the turbine. 30 ft Water d = 7 ft 5 ft
Water 300 mm d 300 mm Problem 4.113 4.113. This turbine develops 75 kw when the flowrate is 0.6 m's what flowrate may be expected if the turbine is removed?
At a potential hydro-plant site, the average elevation of headwater is 582m, the tailwater is 480m. The average annual water flow was determined to be equal to that volume flowing through a rectangular channel 8.15m wide, a depth of 1.22m and the velocity is 4.6m. The turbine efficiency is 87%, generator efficiency is 95%, and a head loss is 3.5% of the gross head. Find the following: a. the generator power in kW 44,150 28,206 36,490 b. the annual energy (kWH per year) that can be produced if the plant operation is 345 days per year 235,154,731 302,142,714 244,334,189 c. the annual income of the plant if the cost of the energy produced is P0.60 per kW-hr 141,092,838 181,285,628 162,653,256