Determine the rate of flow of water through a pipe of 300 mm diameter placed in an inclined position where a venturimeters is inserted, having a throat diameter of 150 mm. The difference of pressure between the main and throat is measured by a liquid of sp. gravity 0.7 in an inverted U- tube which gives a reading of 260 mm. The loss of head between the main and throat is 0.3 times the kinetic head of the pipe. Liquid (Sp. gr. = 0.7) y= 260 mm Inlet - Throat Water (Sp. gr. = 1.0) 10

Determine the rate of flow of water through a pipe of 300 mm diameter placed in an inclined position where a venturimeters is inserted, having a throat diameter of 150 mm. The difference of pressure between the main and throat is measured by a liquid of sp. gravity 0.7 in an inverted U- tube which gives a reading of 260 mm. The loss of head between the main and throat is 0.3 times the kinetic head of the pipe. Liquid (Sp. gr. = 0.7) y= 260 mm Inlet - Throat Water (Sp. gr. = 1.0) 10

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 12. A pipe contains an oil of sp. gr. 0.8. A differential manometer connected at the two points A…

A: h2-h1=0.2m

Q: Determine the pressure at the center of the pipe from the piezometer shown. 200mm WATER 75mmØPIPE

A: Given:- a piezo meter is attached to the pipe as shosn below

Q: Darcy Experiment A set-up of Darcy Experiment involves measuring the pressure head at two…

A: Given data Hydraulic head at 1 (h1) = 66cm Hydraulic head at 2 (h2) = 54cm Travel distance (L) =…

Q: Oil of sp.gr. of 0.750 flows through the nozzle shown and deflects the mercury in the U-tube gage.…

A: The given data is shown below: Specific gravity=0.75Pressure at A=142 kPa

Q: The discharge flowing down the pipe is 0.03 m3/s and the pressure at 2 is 20kPa. Assuming the losses…

Q: Oil (s = 0.90) is discharging through a 100mm circular sharp edge orifice int 150mm pipe. The…

A: Solution Given Data S=0.90 Pipe Diameter D= 150 mm Pressure Head = 9 m of oil = P1ρg Vapour…

Q: Two pipes A & B carries an oil of specific gravities 0.9 & 1.2 respectively. The center of the pipe…

A: Specific gravity of oil in pipe A (S1) = 0.9Specific gravity of oil in pipe B S2 = 1.2Difference in…

Q: (b) Water flows without viscous effects from the nozzle, as shown in Figure Q2 (b). The pressure…

Q: A U - tube is made up of two capillaries of bores 1.2 m and 2.4 mm respectively. The tube is held…

A: It is required to determine the mass density of liquid. ∆H=2σcosθr2-r1ρg Here ∆H is the difference…

Q: (4) Consider that we have a horizentral pipe, like shown in the sketh, which is carrying in this…

A: Elevation of tank (z1) = 100 mElevation of pipe (z2) = 20 mDiameter of pipe (D) = 20 cm = 0.20…

Q: A single colurmn vertical manometer (i.e., micrometer) is connected to a pipe containing oil of sp.…

Q: A closed cylindrical tank filled with water has a hemispherical dome and is connected to an inverted…

Q: A U-tube contains a liquid of relative density 1.25 to a height of 25 cm in both the columns. It is…

Q: Q A U-tube manometer is connected to a pipe for measuring the pressure of oil (Specific gravity…

A: Given:- The specific gravity of the oil = 0.92 The specific gravity of the mercury = 13.6 The…

Q: À U-tube differential manometer connects two pressure pipes A and B. Pipe A contains can…

A: "Thank you for the question. As per our honor code we are supposed to solve the first question,…

Q: A capillary tube of inside diameter 6 mm connects tan A and open container B, as shown in the…

Q: The fluid in the tank is water. Flow is steady state, incompressible and nonviscid. It is known that…

A: Using the Bernoulli's equation between the tank and the point 1 - Patmρg + v122g + Z1 = P1ρg +…

Q: A U-tube differential manometer connects two pressure pipes A and B. Pipe A contains carbon…

Q: height of water at that point. 6. An open tank contains water upto a depth of 1.5 m and above it an…

A: Note: We'll answer the first question since the exact one wasn't mentioned. Please resubmit a new…

Q: O-0.13 Darcy Experiment A set-up of Darcy Experiment involves measuring the pressure head at two…

A: given- Hydraulic head at 1, h1=24 inchesHydraulic head at 2, h2=11 inchesdistance travelled, L=100…

Q: 4. A 1.9-mm-diameter tube is inserted into an unknown liquid whose density is 960 kg/m3, and it is…

Q: The open tank with piezometers attached on the side, contains two different liquids. Find the…

A: As the liquid in piezometer A and liquid in tank above the installation point of piezometer A is…

Q: Figure Q1 (a) shows the tank attached with piezometer tubes. The pressure gauge A is 2.3 kPa. The…

Q: -8.33 -0.12 8.33 (1) 0.12 -L Darcy Experiment A set-up of Darcy Experiment involves measuring the…

A: Given data Hydraulic head at section-1 (h1) = 66cm Hydraulic head at section-2 (h2) = 54cm Length…

Q: Problem 4. The open tank shown in the figure have 2 piezometers attached on one side, containing two…

Q: 2. Oil of specific gravity of 0.90 is discharging through a 1 orifice in the end of a 120mm pipe.…

Q: Two pipes A & B carries an oil of specific gravities 0.9 & 1.2 respectively. The center of the pipe…

A: Difference in centers of Pipe A and B, h = 0.3 m Specific gravity of oil in Pipe A, SA = 0.9…

Q: tank contains water upto a height of 1 m above the base. An immiscible liquid of sp. gr. 0.8 is…

A: Given:- The height of the water in a tank = 1 m The specific gravity of the liquid = 0.8 The height…

Q: In a pump the suction and delivery pipes are of the same size and are at the same level. At a given…

Concept explainers

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?

Question

Determine the rate of flow of water through a pipe of 300 mm
diameter placed in an inclined position where a venturimeters is
inserted, having a throat diameter of 150 mm. The difference of
pressure between the main and throat is measured by a liquid of
sp. gravity 0.7 in an inverted U- tube which gives a reading of
260 mm. The loss of head between the main and throat is 0.3
times the kinetic head of the pipe.
Liquid
(Sp. gr. = 0.7)
y= 260 mm
Inlet
- Throat
Water
(Sp. gr. = 1.0)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step by step

Solved in 5 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

13. A U-tube differential manometer connects two pressure pipes A and B. Pipe A contains carb tetrachloride having a specific gravity 1.594 under a pressure of 11.772 N/cm2 and pipe B contains oil of sp. gr. 0.8 under a pressure of 11.772 N/em. The pipe A lies 2.5 m above pipe B. Find the difference of pressure measured by mercury as fluid filling U-tube. 14. A differential manometer is connected at the two points A and B as shown in Fig. 2.25. At B air pressu is 7.848 N/cm² (abs.), find the absolute pressure at A. [Ans. 31.36 cm of mercury] [Ans, 6.91 N/em) AIR B WATER OIL Sp. gr.0.8 OIL Sp. gr. 0.8 50'cm 30 cm om 100 cm 50 cm 10 cm MERCURY Sp. gr. 13.6 WATER Fig. 2.25 Fig. 2.26
13. A U-tube differential manometer connects two pressure pipes A and B. Pipe A contains carbo tetrachloride having a specific gravity 1.594 under a pressure of 11.772 N/em and pipe B contains ofl of sp. gr. 0.8 under a pressure of 11.772 N/em. The pipe A lies 2.5 m above pipe B. Find the difference of pressure measured by mercury as fluid filling U-tube. 14. A differential manometer is connected at the two points A and B as shown in Fig. 2.25. At B air pressu is 7.848 N/cm (abs.), find the absolute pressure at A. [Ans. 31.36 cm of mercuryl (Ans, 6.91 Nicm) AIR WATER OIL Sp. gr.0.8 OIL Sp. gr. 0.8 50'cm 30 cm 100 am 60 cm 10 cm MERCURY Sp. gr.13.6 WATER Fig. 2.25 Fig. 2.26
Q9) A U - tube is made up of two capillaries of bores 1.2 m and 2.4 mm respectively. The tube is held vertical and partially filled with liquid of surface tension 0.06 N / m and zero contact angle. If the estimated difference in the level of two menisci is 15 mm, determine the mass density of the liquid.
The discharge flowing down the pipe is 0.03 m3/s and the pressure at 2 is 20kPa. Assuming the losses in the pipe is negligible. A U-tube is connected between points 1 and 2 to determine the difference in their pressure, what would be the value of y. Liquid flowing in the pipe is water
Determine the pressure at the center of the pipe from the piezometer shown. 200mm WATER 75mmØPIPE
height of water at that point. 6. An open tank contains water upto a depth of 1.5 m and above it an oil of sp. gr. 0.8 for a depth of 2 m. E the pressure intensity : () at the interface of the two liquids, and (i) at the bottom of the tank. (Ans. () 1.57 N/em', (i) 3.04 Niem 7. The diameters of a small piston and a large piston of a hydraulic jack are 2 cm and 10 cm respectively. A force of 60 N is applied on the small piston. Find the load lifted by the large piston, when : (a) the pistons an at the same level, and (b) small piston is 20 cm above the large piston. The density of the liquid in the jacks [Ans. (a) 1500 N, (b) 15205 N] kg given as 1000 - m 8. Determine the gauge and absolute pressure at a point which is 2.0 m below the free surface of water. Take [Ans. 1.962 N/em? (gauge), 12.066 N/em (abs.)) atmospheric pressure as 10.1043 Nicm. 9. A simple manometer is used to measure the pressure of oil (sp. gr. = 0.8) flowing in a pipe line. Its right limb is open to the atmosphere…
Two pipes A & B carries an oil of specific gravities 0.9 & 1.2 respectively. The center of the pipe A is 55 cm above the pipe B. The height of oil in right limb is 30 cm. Also, the mercury level difference is found in right limb as 70 cm. Find the pressure difference between these two pipes in kPa. Also find the pressure equivalent in water head in mm. The difference of pressure between two pipes (PA-P3) (Unit is in kPa) = Equivalent to Water head in mm =
liquid flows into the tank at A at 4 m/s. Determine the rate, dy/dt, at which the level of the liquid is rising in the tank. The cross-sectional area of the pipe at A is AA = 0.1 m2. 3 m 4 m/s
help with hw...thnks
1 a) A 2-mm-diameter clean glass tube is inserted in water at 15°C (Figure 1.2). Determine the height that the water will climb up the tube. The water makes a contact angle of 0° with the clean glass. ADo h W=y¥ Air Water Figure 1.2
Determine the velocity inside the pipe 0.5-m-dlameter using the pitot tube installed. The difference between the water levels in the Pitot tube and in the plezometer is 80 mm. O 1.09 m/s O 053 m/s O 1.25m/s O 27 m/s
INCLINED MONOMETER EXAMPLE tube shown in Fig. than that at B. T 1m Determine the angle of the inclined if the pressure at A is 5KPa greater SG-0.7 SG-1.0 10 m