determine the discharge inside the pipe in liters per second

Q: A saltwater enters into a hydraulic reaction turbine w/ a velocity of 12ft/s & leaves it 3ft lower…

A:

Q: Water discharging into a 10 m wide rectangular horizontal channel from a sluice gate is observed to…

A:

Q: Uniform Flow A rectangular channel of width 4m is carrying a discharge of 36m³/sec. If the depth of…

A: Width of the rectangular channel-B = 4 m,Discharge Q=36 m3/sDepth of flow of one end of hydraulic…

Q: A rectangular channel 2.0 m wide and 1.0 m deep carries a discharge of 4.0 m3/s. A horizontal datum…

A: Rectangular channel (B) = 2m Depth (y) = 1m Discharge (Q) = 4 m3/sec Datam height below channel bed…

Q: kg.m of a If the sequent depth equal to1.7m, and the energy dissipated =0.5 kg hydraulic jump in a…

A: Length of jump (Lj) : It is the distance measured from front face of hump to a point on surface…

Q: Determine the total energy production of a run-of-river plant having an total efficiency of 85%. It…

A: According the given question, the given data is Overall efficiency =85% Length of penstock = 400 m…

Q: A rectangular channel of width 4m is 3 carrying a discharge of 36m³/sec. If the depth of flow of one…

A: Width, B = 4 m Discharge, Q = 36 m3/s Depth, y1 = 1.2 m

Q: A sluice gate, as shown in Figure Q1, is used to control the upstream water level in a 4 m wide…

A:

Q: Water must flow over a distance of 2 800 m from a large catchment dam to a turbine. The water level…

A: L=2800m D=200mm P=300kW

Q: The specific energy in a rectangular channel is 3 kgm/kg. Calculate the critical depth. Also compute…

A:

Q: In a hydroelectric project, a discharge of 400 m/s is available with net head of 32 m. If two…

A:

Q: . In a 3.0 m wide rectangular channel, the discharge is 15.0 m⅔. Calculate the critical depth and…

A: Width, b = 3 m Discharge, Q = 15 m3/s To determine:- a) The critical depth  b) The  specific energy…

Q: Upper reservoir elevation = 100m Lower reservoir elevation = 50m The penstock pipe in between the…

A:

Q: Water is being pumped from a large lake to a reservoir 25 m above at a rate of 25 L/s by a 11-kW…

A:

Q: The discharge of water through a rectangular channel of width 10 m is 30 m³/s when depth of flow of…

A: Rectangular channel Width of the channel (B) = 10m Discharge (Q) = 30 m3/s Depth of the flow (y) =…

Q: A 10-m-wide rectangular canal carrying a discharge of 18 m³/s, where the flow is moving at a…

A: Width of rectangular channel (B) =10mDischarge (Q) =18 m³/sVelocity of flow (V) =6m/s

Q: A 15 -m-wide rectangular canal carrying a discharge of 18 m/s, where the flow is moving at a…

A: We will find head loss to find power dissipated

Q: Water is pumped at a flow rate of 15 m3/s from the lower reservoir through a pipe with a diameter of…

A:

Q: A 10 m wide rectangular channel carries a discharge of 20 m³/s under critical condition. Using g =…

A:

Q: above at a rate of 25 L/s by a 12-kW (sha rreversible head loss of the piping syste mechanical…

A:

Q: Determine the maximum flow in a rectangular channel 6m wide if the specific energy is 4 Nm/m.

A: Given : Rectangular channel  Width, B = 6m Specific Energy, E = 4Nm/N Required : Maximum flow in the…

Q: Water discharging into a 10 m wide rectangular horizontal channel from a sluice gate is observed to…

A:

Q: Two reservoirs (El 23.1m and El 95.5m) are connected by two pipelines 1-2 and 2-3 with a pump…

A: Using Bernoullis equation calculate the pump head. Then using the formula of fluid power the power…

Q: 1. The radial flow pump produces 0.8 m of frictional head losses within the pump. If 3.10 m of head…

A: Input head = 3.10mOutput head = 0.8mTo find:The pump efficiency

Q: A pump delivers water at a rate of 0.025 m³/s against a head of 30 m. If the overall efficiency of…

A: Given data : Head (h)=30 mFlow rate (Q)=0.025 m3/sEfficiency (η)=75%

Q: Determine the specific energy of the flow in a rectangular channel with a width of 7.0 m. The…

A: Given data : Width (B)=7 mMean velocity (V)=2 m/sDischarge (Q)=15 m3/s

Q: A hydraulic jump occurs at the top of a spillway. The depth before jump is 0.3 m. The sequent depth…

A:

Q: Q.4 A 10 m wide rectangular channel carries 3 a discharge of 20 m/s under critical condition. Using…

A: Rectangular channel- Channel width B=10 m Discharge Q=20 m3/s under critical condition.   It is…

Q: A centrifugal pump is used to move water from the lower reservoir to the upper reservoir at a rate…

A: Centrifugal Pump: A Centrifugal pump is used to transfer the water or any fluid from the lower…

Q: Q110. A hydropower plant has to work under the following conditions. Determine the likely number of…

A:

Q: Reservoirs A and B have elevations 250 m and 100 m, respectively, and are connected by a pipe having…

A: Elevation of reservoir A, Elevation of reservoir B, Diameter of pipe, Length, Discharge in pipeline,…

Q: A rectangular channel of 2.5 m width and 2 m depth of water carries a flow of 10 m³/s. The specific…

A:

Q: he water taken from a stream at an average speed of 5 m/s is transferred to the turbine by a forced…

A: step 1-

Components of Hydroelectric Power Plant

A hydro electric power plant derives the energy from the force of fast moving water to harness energy. The demand for energy needs has impacted the environment resulting in global warming. Extensive use of non-renewable energy sources like petrol and diesel is the primary reason for environmental pollution. A major shift from non-renewable energy sources to renewable energy sources is the only solution to encounter the rising issue of environmental damage.