Water discharging into a 10 m wide rectangular horizontal channel from a sluice gate is observed to have undergone a hydraulic jump. The flow depth and velocity during the jump are 0.8 m and 7 m/s respectively. The wasted power production potential due to the hydraulic jump is kW. (round off to two decimal places)

Water discharging into a 10 m wide rectangular horizontal channel from a sluice gate is observed to have undergone a hydraulic jump. The flow depth and velocity during the jump are 0.8 m and 7 m/s respectively. The wasted power production potential due to the hydraulic jump is kW. (round off to two decimal places)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A 10 m wide rectangular channel carries a discharge of 20 m³/s under critical condition. Using g =…

A: Channel width B=10 m Discharge Q=20 m3/s

Q: A 150-mm diameter penstock supplies water to a turbine under a constant head of 30m. Surge tank…

Q: kg.m of a If the sequent depth equal to1.7m, and the energy dissipated =0.5 kg hydraulic jump in a…

A: Length of jump (Lj) : It is the distance measured from front face of hump to a point on surface…

Q: 4.49. If 100 m³/s of water flows in a channel 8 m wide at a depth of 0.9 m, calculate the downstream…

Q: A sluice gate, as shown in Figure Q1, is used to control the upstream water level in a 4 m wide…

Q: Water is lifted from a lower reservoir to a higher reservoir by a pump that provides 23 kW of power.…

A: Given: The power provided by the pump is 23 kW. The rate of water pumped is 0.03 m3/s. The velocity…

Q: Two reservoirs ( Elev. 38.7m and Elev. 90.6m ) are connected by two pipelines 1-2 and 2-3 with a…

Q: 1.25 m head of water is flowing over a 36-1m high spillway, hence, the percentage of energy…

A: He = 1.25m H = 36 + 1.25 = 37.25m C(coefficient of spillway discharge) = 2.6(assuming) {vary from…

Q: A hydraulic jump is formed in a 2 m wide rectangular channel carrying water at a flow velocity of 16…

Q: A 125 mm diameter orifice is installed at the vertical side of a tank 2 m diameter and has a…

A: Diameter of orifice (d) = 125 mm or 0.125 m Area of orifice (a) = Πd2/4 = 0.01227 m2 Head (H) = 5.5…

Q: The discharge of water through a rectangular channel of width 10 m is 30 m³/s when depth of flow of…

A: Rectangular channel Width of the channel (B) = 10m Discharge (Q) = 30 m3/s Depth of the flow (y) =…

Q: Consider the flow of water in a 10-m wide channel at a rate of 70 m3 /s and a flow depth of 0.5 m.…

A: Using formula

Q: A rectangular channel 10 m wide carries 60 m3/s when flowing 3 m deep. What is the specific energy?…

Q: Two reservoirs are connected to each other with a pipe of length of 2 km and diameter 0.2 m.…

A: Given: Length, L = 2 km Diameter, d = 0.2 m Difference in water level, h = 8 m Friction factor, f =…

Q: 3 2 Figure Q1

A: Given : Height at 1 = 2.4 m Width, b = 4 m Discharge, Q = 12 m3/s

Q: 8.13) A hydraulic jump occurs in a rectangular channel. and a discharge of 15m³/s. The depth…

Q: 7. Two reservoirs A and B have elevations of 250 m and 100 m, respectively. It is connected by a…

Q: Determine the maximum flow in a rectangular channel 6m wide if the specific energy is 4 Nm/m.

A: Given : Rectangular channel Width, B = 6m Specific Energy, E = 4Nm/N Required : Maximum flow in the…

Q: A rectangular channel 10 m wide carries 60 m3/s when flowing 3 m deep. What is the specific energy?…

A: The given data is: Channel width, B=10 m Channel depth, y=3 m Channel flow, Q=60 m3/s

Q: Water discharging into a 10 m wide rectangular horizontal channel from a sluice gate is observed to…

Q: In an experiment on a trapezoidal notch the flow is collected in a 3.37 meter diameter vertical…

Q: A 10 m wide rectangular channel carries a discharge of 20 m³/s under critical condition. Using g=…

Q: A hydraulic jump occurs at the foe of a spillway. The depth before jump is 0.2 m. The sequent depth…

A: Depth before jump- y1=0.2 m, Sequent depth y2=2 m,

Q: A hydraulic jump occurs at the top of a spillway. The depth before jump is 0.3 m. The sequent depth…

Q: A pump draws water from a pit through a vertical 30 cm diameter pipe which extends below the water…

A: Given :

Q: Q.4 A 10 m wide rectangular channel carries 3 a discharge of 20 m/s under critical condition. Using…

A: Rectangular channel- Channel width B=10 m Discharge Q=20 m3/s under critical condition. It is…

Q: For a hydraulic jump in a rectangular channel the velocity and depth after the jump are known to be…

A: Given: The flow velocity is 0.8 m/sec. The depth after the jump is 1.75 m.

Q: A 10-m-wide rectangular canal carrying a discharge of 18 m/s, where the flow is moving at a velocity…

A: B=10m V=6m/s

Q: 7. A flow of 0.03 m³/s must be pumped against a head of 30 m. The pump will be driven by an electric…

A: Q=0.03m3/sechead(H)=30mspeed(N)=2000rpm

Concept explainers

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.

Question

Water discharging into a 10 m wide rectangular horizontal channel from a sluice gate is
observed to have undergone a hydraulic jump. The flow depth and velocity during the
jump are 0.8 m and 7 m/s respectively. The wasted power production potential due to the
hydraulic jump is
kW.
(round off to two decimal places)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given data

VIEW

Step 2: Determine energy loss due to jump

VIEW

Step 3: Determine Power production potential due to hydraulic jump

VIEW

Solution

VIEW

Step by step

Solved in 4 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A five cylinders reciprocating pump raises the water level by 150 m and the theoretical discharge is 0.20 m³/s. The velocity in the delivery pipe is 2.0 m/s. Total head loss in pipes is 20 m. What is the input power, if the efficiency of the pump is 0.87?
A discharge of 12 m3 /s of water flowing with a velocity of 1.5 m/s in a rectangular channel 7.5 m wide. What would be the value of minimum specific energy (in meters)? a.0.639b.1.1825c.0.0958d.2.5
Problem 12.24 In a 1 in 20 model of stilling basin, the height of the hydraulic jump in the model is observed to be 0.20 metre. What is the height of the hydraulic jump in the prototype ? If the energy 1 kW, what is the corresponding value in prototype ? 10 dissipated in the model is B qrecpsn
Please provide solution asap with explanation
Water passes under a sluice gate in a horizontal rectangular channel of width 2.0 m. The depths of flow on either side of the sluice gate are 1.8 m and 0.3 m. Assuming no energy loss at the gate, calculate the force on the gate
i need the answer quickly
Water flows at the rate of 12 m³/s in a 6 m wide rectangular channel. A hydraulic jump is formed in the channel at a point where the upstream depth is 30 cm (just before the jump). considering acceleration due to gravity as 9.81 m/s² and density of water as 1000 kg/m³, the energy loss in the jump is elisw moting dlu201
Problem- In a pressure penstock 4500 m long, water is flowing at a velocity of 4 m/s. If the velocity of the pressure wave travelling in the pipe, due to sudden complete closure of a valve at the downstream end, is given as 1500 m/s. What will be the period of oscillation under frictionless conditions.
36 The flow net constructed for the dam is shown in the figure below. Taking the coefficient of permeability as 3.8 x 10-6 m/s, the quantity of flow (in cm³/s) under the dam per meter of dam is. 6.3 m T ! 9.4 m 17.2 m I 1.6 m T - 50 m - Impermeable Stratum