Determine the average punching shear stress the circular shaft creates in the metal plate through section AC and BD. Also, what is the average bearing stress developed on the surface of the plate under the shaft? 60 KN -50 mm- -60 mm- -120 mm 112 mm

Q: Three plates are welded together to form the section shown. Dimensions of the cross section are b =…

A: First we need to divide the section into 3 different parts. Then we need to calculate the neutral…

Q: Draw Mohr’s circle and determine the principal stresses.

A: Given Data: The stress acting along X-direction is σx=30 MPa (Tensile). The stress acting along…

Q: -57. Determine the principal stress, the maximum in-plane shear stress, and ver 120 MPa MADARAKAN…

A: Given data : The value of normal stress in X direction σX=300 MPa The value of normal stress in Y…

Q: diameter of the smallest pin that can be used if not to exceed a shear stress of 60 MPa (Draw

A:

Q: Determine the principal stress and absolute maximum shear stress developed at point B on the cross…

A:

Q: 4. The joint is fastened together using two bolts. The diameter of each bolt is 13.5 mm. Determine…

A: Given data in question  Load 80 kN Diameter 13.5 mm Width 30 mm Number of bolts 2 To find out…

Q: Three plates are welded together to form the section shown. Dimensions of the cross section are b =…

A: Given: The value of b is 3.6 in. The value of d is 10.8 in. The value of a is 2.3 in. The value of t…

Q: Three plates are welded together to form the section shown. Dimensions of the cross section are b =…

A: Solution- The given values are ,b=3.2ind=9.6ina=2.6int=0.8V=36kipsTo Find The shear flow through the…

Methods to Determine Vertical Stress

The load applied to the soil is transferred to the underground. The presence of water at soil pores and solid grains above the soil are the primary components that are responsible for the effective load transfer. Due to the load acting, the internal component of the soil or the underground formations undergoes deformations or a tectonic shift. The amount of deformation depends upon the amount of load acting on the soil surface, which indeed, depends on the weight of everything present above the soil. Due to this, the underground soil element develops internal stresses which try to resist the tectonic changes.