diameter of the smallest pin that can be used if not to exceed a shear stress of 60 MPa (Draw

Q: Describe about the deviator stress.

A: - Deviator stress is also know as Principal stress difference, Shear stress, Back pressure stage -…

Q: toonges as aasm 12 mm thick plate is conected to two 8 mm thick plates, on either side through a 16…

A:

Q: DETERMINE THE AVERAGE PUNCHING SHEAR STRESS THE CIRCULAR SHAFT CREATES IN THE METAL PLATE THROUGH…

A:

Q: hollow cast iron column with the cross section shown in the image attached is subjected ti a…

A: A vertical point load acting at A of magnitude 100kNTo determine the maximum compressive and tensile…

Q: a) Calculate the internal forces/moments at point J? b) Bar DE is made of aluminum with Young…

A:

Q: 18,000 lbs K₁ 3) This steel bar is 3" x 3" by 30" long. It has a 1" diameter hole centered in the…

A:

Q: Determine the maximum permissible value of T provided the allowable shearing stresses in brass and…

A: ζb=70 MPaζs=110 MPaGb=80 GPaGs=40 GPa di=70 mmd0=90 mm

Q: In the steel structure shown a 6 mm diameter pin is used at C and 10 mm diameter pin is used at B.…

A: Given:Diameter of pin at C is 6mmDiameter of pin at B is 10 mmRequired:Largest P applied

Q: The maximum shear stress (kPa) is most nearly 100 kPa 50 kPa -50kPa 50 kPa 75 O 56 O 66 O

A:

Q: 3. Determine the maximum tensile and compressive bending stresses in the beam shown. 4 kN/m A 10 kN…

A:

Q: The plates in the figure below are each 3 inches by 0.5 inches in cross section. If the hole in each…

A: Solution:- Given information: Cross section of plate =3×0.5 in Hole diameter, d=1316 in, and Load,…

Q: The maximum safe compressive stress in a hardened steel punch is limited to 0.8 GPa and the punch is…

A: The given data is: Maximum safe compressive stress=0.8 GPa=800 MPa The shearing stress of plate=300…

Q: -0/02 -400 m

A:

Q: 16-11. A newly designed transaxle was tested with strain gages to determine the maximum stress,…

A: Maximum stress measured using Strain Gage (σmax) = 40000 psiFactor of Safety = 3

Q: A steel punch with a diameter of 45mm punches a hole in a steel plate with a thickness of 12mm, with…

A:

Q: Figure P-130 shows a roof truss and the detail of the riveted connection at joint B. Using allowable…

A:

Q: determine the minimum force P required to punch the slot. Punch O 575 kN O 675 kN O 724 KN Slug…

A:

Mechanics of Solids

It is the study of the behavior of solid materials, their characteristics under various circumstances such as variation in external forces, temperature, and other internal factors. It is one of most important study in the field of engineering science, especially chemistry and mechanical engineering. In rigid body, the idealization of the solid body in which deformation is neglected. Deformation is known as the force acting on the solid state system which exerts change in its shape of the body but it continues to be at rest or in a uniform motion but it cannot accelerate. But those solid systems do have elasticity, compressibility and can be bent. This field is very vast since there are wide range of materials around us.