d. Check oil level & moisture content19. If the main wire (coil) to the distributor and the coil to the switch are broken, replace them and makesure the connections are clean and tight relevant toa. Breaking systemb. Ignition systemc. Ventilation systemd. Combustion system20. The required gap in ignition system between----------a.-4 to 5b.-0.4 to 5c.-0.4 to 0.5d.-4 to 0,5|21. Which of the following is the fouled of spark pluga. Sootb. Oilc. Over heatedd. All of the above|22.The suitable thread of spark plug for heavy engine isa. M19b. M18c. M15d. M1623. Using a Torque wrench, tighten the plugs to the specified torque. (Most) 4mm plugs are torqued tofour kilograms per square inch.a. Trueb. False24. Start the engine and evaluate its performance refers toa. Weekly Maintenanceb. Annually Maintenancec. Daily Maintenanced. None of them25. Check to see if Dynamo is working properly. If necessary, adjust the regulator refers toa. Weekly Maintenanceb. Annually Maintenancec. Daily Maintenanced. None of them|26. Remove all of the wheels, inspect the brake drums and linings, replace brake linings as needed, andadjust the brake drums if necessary.a. Quarterly Maintenanceb. Monthly Maintenancec. Daily Maintenanced. None of them27. In diesel engines, re-calibrate injectors and pumps (This should be done by the authorized agenciesand preferably in air-conditioned rooms).a. Quarterly Maintenanceb. Monthly Maintenancec. Daily Maintenanced. fitness certificate work28. Road test Report is -------a. After the maintenance operation is completed, the road test inspector or the machine creates the road test| герort.b. Overhaul all four-wheel brakes and the Universal jointsc. In case of diesel engines overhaul injectors, besides the above items of wash, all the items mentioned in themonthly maintenance schedule should be carried out during quarterly maintenance also.d. During service, remove and clean shackle pin if necessary.29.What is meant by Overhauling?a. Removing the machine (ex- engine) repairing it and placing it back again for better performanceb. Date of the previous maintenance reportc. Over haul carbonatord. Ball Joints and dust covers30. The methods of overhaul differ from maintenance procedure.a. Trueb. False31. During the useful life of a set of new tires (including the spare), it is necessary to rotate them atintervals of about---------- for rear drive vehicles and---------- for front drive vehicles to get the mostmileage out of them.a.3000 km,2000 mileb.3330 km,2225 milec.3000mile, 2000 miled.3000 mile,2500 mile32. Punctures are----a. a small hole in a tire resulting in an get-away of airb. a large hole in a tire resulting in an get-away of airc. a small hole in an engine resulting in an escape of aird. a small hole in a tire resulting in an get-away of oil33.Remove the dynamo and starting meter cable connections (it is preferable to remove both startingmotors) (It is better to remove both starting motor and dynamic if readily accessible, as this allows betteraccess to engine mounting nuts) relates toa. Removal engine from the vehicleb. Removal dynamo only----

d. Check oil level & moisture content 19. If the main wire (coil) to the distributor and the coil to the switch are broken, replace them and make sure the connections are clean and tight relevant to a. Breaking system b. Ignition system s. Ventilation system d. Combustion system 20. The required gap in ignition system between---- a.-4 to 5 b.-0.4 to 5 c.-0.4 to 0.5 d.-4 to 0.5 21. Which of the following is the fouled of spark plug a. Soot b. Oil c. Over heated d. All of the above

d. Check oil level & moisture content 19. If the main wire (coil) to the distributor and the coil to the switch are broken, replace them and make sure the connections are clean and tight relevant to a. Breaking system b. Ignition system s. Ventilation system d. Combustion system 20. The required gap in ignition system between---- a.-4 to 5 b.-0.4 to 5 c.-0.4 to 0.5 d.-4 to 0.5 21. Which of the following is the fouled of spark plug a. Soot b. Oil c. Over heated d. All of the above

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

If the main wire (coil) to the distributor and the coil to the switch are broken, replace them and make sure the connections are clean and tight relevant to Ventilation system Breaking system Ignition system Combustion system Skip Which of the following is the fouled of spark plug Soot All of the above Oil Over heated Skip
the metring valve portion of combination valve fails .technician A says that this means the entire combination valve must be replaced.Technician B says that the metring part can be repaired who is correct?
when installing a spin-on oil filter, failure to lube the o-ring will?
Q156. which of the following components can cause execcively high pressure in a returnless fuel delivery system? a. faulty fuel pressure. b. faulty fuel pressure regulator c. all answers are correct d. faulty PCM
Technician A says that broken engine mounts can cause the fan to hit the shroud. Technician B says that missing or broken air dams can cause an engine to overheat. Who is correct? Select one: a. Technician A only b. Technician B only c. Both A and B d. Neither A nor B
Reach, heat range, and air gap are all characteristics that affect the performance of which ignition system component? a. Ignition coils b. Ignition cables c. Spark plugs d. Ignition modules
Please explain and choose the right option. A spark ignition operates at ________ VAC. A. 1000 B. 5000 C. 8000 D. 10000
Which of the following components are common to most automatic control systems for residential split air conditioners? a. Thermostat, contactor, transformer b. Thermostat, magnetic starter, contactor c. Thermostat, diode, contactor d. Thermostat, time-delay relay, contactor
Automotive cooling system problems are being discussed. Technician A states that engine overheating is a common failure. Technician B states that an engine remaining below proper engine operating temperature is a common failure. Who is correct? Select one: a. Technician A only b. Technician B only c. Both Technicians A and B d. Neither Technician A nor B
Which of the following components is NOT a type of ventilation system? Select one: a. Airconditioning Units b. Venting Skylight c. Boilers d. Exhaust Fans
Technician A says that when draining the engine oil, the engine should be fully cold for best results. Technician B says that the engine should be running when checking the engine oil level. Who is correct? Select one: a. Technician A b. Technician B c. Both A and B d. Neither A nor B
A lawnmower stops running after a short period of time. The fuel tank filler cap is removed and an almost fuel tank of fuel is found, so the cap is reinstalled and the engine restarted. The engine runs again for a short time and then dies so the cap is removed again and the process repeats. Tech a says the problem may be due to a clogged vent in the fuel cap. The b says that the intake mainfold gasket may be defective. Who is correct?