Saturated ammonia at a temperature of 50oF and a flow rate of 3 lbm/s enters a steady-state well-insulated device with an isentropic efficiency of 85%. The device needs to increase the pressure of the ammonia to 200 psia. Calculate the power required (in hp) and the exit temperature (in oF) if a) The device is a compressor and the ammonia is saturated vapor. b) The device is a pump and the ammonia is saturated liquid

Q: Air Initially at 14.7 psia and 80 deg. F is heated in a constant volume non-flow process until the…

A: Given data: P1=14.7 psiaT1=80°CT2=1500°FV3=3V1 Need to determine the heat added at constant volume…

Q: Draw Pv and Ts diagram of reversible isobaric process. Write the relationship between thermodynamic…

A:

Q: Ammonia exits the stream of a process as saturated liquid at a pressure of 11bar, and is reduced to…

A:

Q: Q1/Water enters a boiler at (323°K & 5 Mpa), and leaves as steam at (673°K & 5 Mpa). The heat…

A:

Q: Refrigerant R-134a at 400 kPa and 30°C enters an adiabatic diffuser steadily with a velocity of 600…

A:

Q: In a continuous flow open system, the inlet velocity of the flowing fluid is 30 m/s, and the outlet…

A: Steady flow means there when the properties does not vary with respect to time therefore the mass at…

Q: Refrigerant R-134a at 400 kPa and 10 ⁰C enters an adiabatic diffuser steadily with a velocity of 600…

A:

Q: During an isentropic process of 3 lb/sec of air, the temperature increases from 50 deg F to 290 deg…

A: given data-  mass of air = 3 lb/ sec initial temperature T1 = 50 deg F final temperature T2 = 290…

Q: an air flow is brought from 20 degree celsius, 100 kPa to 1000 kPa, 330 degree celsius by an…

A: Given, Inlet, Outlet, The compressor power,

Q: Number 3

A: To find change in enthalpy

Q: A piston/cylinder system compresses saturated water vapor at 500 kPa to 2500 kPa, V₂=v₁/3 The system…

A: The initial pressure is The final pressure is The initial state is saturated vaporThe final volume…

Q: Refrigerant R-134a at 400 kPa and 90 ⁰C enters an adiabatic diffuser steadily with a velocity of 600…

A:

Q: Q1: In a steam power plant, steam enters at 8 MPa and 500 C, the condenser pressure is 8 kPa, and…

A: Given data: P1=8 MPaT1=500°C Need to determine the enthalpy at point 1.

Q: Steam engine isentropically expands 5.84 kg/s of steam from 0.68 MPa, 220 degree celcius. The…

A:

Q: Refrigerant R-134a at 400 kPa and 10 kPa ,,,T1=0⁰C , T2 = 1⁰C enters an adiabatic diffuser steadily…

A: Given    Pressure, P1= 400 kPa  At 400 KPa, h₁ = 400.98 kJ/kg  The energy equation is:         For a…

Q: A 130 L rigid tank initially contains nitrogen at 400 kPa, 100 K. The tank is connected to a line…

A: Given: The volume of the tank, V = 130 L The pressure inside the tank, P1 = 400 kPa The temperature…

Q: How much work was required (kJ)?

A: take properties from steam table here state 1 is super heated state and 2 is sub cooled state.so…

Q: A heat exchanger is used to cool an air flow from 900 to 400 K, with both states at 1 MPa. The…

A: Given information:Properties of air:Temperature of air at inlet =900 KTemperatue of air at outlet…

Q: Air enters a continuous flow compressor at a temperature of 23°C and a pressure of 100 kPa and is…

A:

Q: Refrigerant R-134a at 200 kPa and 90 ⁰C enters an adiabatic diffuser steadily with a velocity of 600…

A: Fluid= R134aInlet condition of R134a, P1=200 kPa, T1=90oC, V1=600 m/sExit condition of R134a, P2=10…

Q: A closed constant volume system receives 10.5 kJ of paddle work. The system contains oxygen at 344…

A:

Q: Water vapor enters a continuous flow turbine with 6 MPa pressure, 450oC temperature and 80 m/s…

A: Steam turbine It is a device which converts the thermal energy of steam into electrical energy. High…

Q: Air enters an adiabatic nozzle at 230 kPa, 600°C with a velocity of 60 m/s. The air is at 70 kPa,…

A:

Q: Water at 50°C is cooled in a cooling tower which has an efficiency of 65%. The temperature of the…

A: Given: Cooling temperature, Tc=50°C The efficiency of the cooling tower, ηCT=65% Air temperature in…

Q: 1 1 Helium is compressed through a compressor steadily. At the inlet the pressure is P₁ = 100kPa and…

A:

Q: a line at 0,7 MPa and 40 IS attached tO a tank that Contains little water (assume zero initial…

A: Solution is given below:

Q: In a closed container with a constant volume, there is air at a temperature of 300 K and a pressure…

A:

Q: he 1 lb of air has decrease of internal energy of 20.58 Btu while its Fahrenheit temperature is…

A: Given:m=1 lb∆u=-20.58 BTU T2=T13

Q: Steam @ 500 C and 3500 kPa enters a nozzle at a velocity of 30 m/s and leaves as saturated vapor at…

A: Step 1:Inlet conditionsPressure (P1) = 3500kPa = 3.5 barTemperature (T1) = 500°cInlet velocity (V1)…

Q: stirrer tank heater. It is a the water at 20 C. Wate ame flow rate rom the top

A:

Q: 1 1 Helium is compressed through a compressor steadily. At the inlet the pressure is P₁ = 100kPa and…

A:

Q: 4 kg/s of air enters steadily at 20°C through a heat exchanger at a velocity of 35 m/s where its…

A: Given Data  The mass flow rate of air in a heat exchanger, m=4Kg/s The inlet temperature of the heat…

Q: 1 Helium is compressed through a compressor steadily. At the inlet the pressure is P₁= 100kPa and…

A:

Q: Calculate the workdone, heat transfer and change in entropy.  Do not need to solve.  I just need…

A: Now write the expression for the work done.

Q: A piston-cylinder system contains 1 kg of air at (V1, P1, T1). The air is heated at constant…

A: Given data: The mass of the air is, m=1 kg. The equation of polytropic compression curve is, PV3=C.…

Q: 1.Atmospheric air enters a single stage screw compressor at 1 bar and 250C at  low velocity. The…

A: To Find :  The heat that needs to be taken away by the after cooler. Given :  The pressure inlet of…

Q: Refrigerant R-134a at 200 kPa and 10 ⁰C enters an adiabatic diffuser steadily with a velocity of 600…

A: Given:-Inlet:T1=10°CP1=200 kPaV1=600 m/sOutlet:T2=150°CP2=10 barTo find:-a) The exit velocity b) The…

Q: Refrigerant R-134a at 200 kPa and 50 ⁰C enters an adiabatic diffuser steadily with a velocity of 140…

A:

Q: R-134a fills a 0.1-m³ capsule at 20°C, 200 kPa. It is placed in a deep freezer, where it is cooled…

A: Soln:- C. v. R- 134a out to the -20°c space. Energy equation :-  m(u2-u1) = 1Q2- 1W2 Actual process…

Q: A pump delivers 4 ?3/??? of water from 110 kPa to 350 kPa. Both pipes’ gages are on the same level.…

A: Given DataP1=110kPaP2=350kPaD1=16cm=16×10-2mD2=13cm=13×10-2mρ=997kg/m3Flow Rate…

Q: 40°C 4. A mixing chamber receives 5 kg/min of ammonia as saturated liquid at -20°C from one line (1)…

A:

Q: Q.: 1. For a Polytropic Reversible Process PV =constant show that: Q=(Y-n/Y-1 )x work done 2. The…

A: Given :- For a Polytropic Reversible Process PV =constant show that: Q=(Y-n/Y-1 )x work done

Q: A turbine operating in a continuous flow works adiabatically. The water vapor enters the turbine at…

A: Given, T1 = 650 C P2 = 20 kPa x2 = 0.85 P = 10 MW

Q: One kg water at velocity 12.5 m/s and 30oC enters a 2.54 cm diameter horizontal pipe where  there is…

A: