Construct Free Body Diagrams (FBD) of typical 12' and 16' joists and the interior beam along grid line B. Also, draw the FBD of the exterior beam on grid line A. Solve for the support reactions in each FBD constructed.

Q: 3. A simply supported beam of length 8 m carries point loads of 4 kN, 10 kN and 7 kN at 1.5 m, 2.5 m…

A:

Q: L Calculate the support reactions at A and B for the beam subjected to the two linearly distributed…

A:

Q: Determine the support reactions of the beam shown. 3 kip/ft B A C -6 ft 4.5 ft- 4.5 ft

A:

Q: Construct FBD's of typical 12' and 16' joists and the interior beam along grid line B. Also, draw…

A: Given data:DL = 10 psfLL = 40 psf (pounds per square feet)Solution:The total load = DL + LL = 10+40…

Q: 1. The cantilever beam in Figure 1 is fixed at A, and is loaded with a distributed load from A to B…

A:

Q: Figure Q2 shows an 11 m long steel beam AC of uniform cross-section, simply supported at left end A…

A:

Q: .Calculate the magnitude of load 1, =__ KN 2.Calculate the magnitude of load 2, =__ KN 3.Calculate…

A:

Q: Problem 6-53: The beam is made from three boards nailed together as shown. If the moment acting on…

A: The cross-section area and the centroid values are as follows-

Q: Draw the load (FBD) and the bending moment diagrams that correspond to the given shear force diagram…

A: we know that in SFD for UDL there is an inclined line. Sign convection taken for shear force Sign…

Q: Draw the moment diagrams for the beam shown in (Eigure 1) using the method of superposition.…

A:

Q: PROBLEM 1 For the beam below, calculate the reactions at A and B and draw its Shear and Moment…

A: The shear force and bending moment diagram. Load diagram: The load diagram is shown below.

Q: Draw the moment diagram for the beam. Click on "add discontinuity" to add discontinuity lines. Then…

A:

Q: The cantilever beam is loaded as shown below by a concentrated force ‘P’ and a moment, ‘Mo’. Use the…

A: Here is the solution for the above question.

Q: Question 1. The supported beam in the diagram has a cross sectional area shown. a. Determine the…

A: The Answer is below

Q: 7. A beam is loaded and supported as shown below. a. Calculate the support reactions b. Write the…

A:

Q: Produce the shear and bending moment diagrams for the beam structure andloading shown below.…

A: The given problem will be solved by taking sections for some of the portion of udl i.e., from…

Q: Compute the support reactions for the vertical wind truss at the right. Remember that each force…

A:

Q: For the following beams compute the vertical and horizontal reactions.

A:

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.