L Calculate the support reactions at A and B for the beam subjected to the two linearly distributed loads. The reactions are positive if upward, negative if downward. 5.7 kN/m Answers RA- RB- i -0.7 m 13.76 i 13.76 2.9 kN/m 4.8 m 2.9 kN/m +3.0 m- kN kN 1.8 m 5.7 kN/m

Q: A symbol used to identify a physical feature of a part as a datum feature is called a: O Reference…

A: Reference feature: There are the feature where the other features are referenced from. feature…

Q: n an engine, the piston diameter is 3 1/4 inches, the stroke is 4 7/8 inches, and the piston…

A: For the solution refer below images.

Q: Given the multiview projection of the solid, draw the isometric view.

A: Given:To find:Draw the isometric view.

Q: Given the two views of a solid and an auxiliary reference plane, draw the auxiliary view and…

A: Draw Auxiliary view of the given figures.

Q: Draw the isometric and orthographic sketch of the given figure (in catia V5 ;no hand drawing );

A: isometric view

Q: 124,000s o(2) 0 s85 0.03 (o in MPa) 1+ 300ɛ (a) Find the axial normal strain in the cable and its…

A: σε = 124,000 ε1 +300 ε 0≤ ε ≤ 0.03W = 6.8 kN To-Determine:-  a. Axial normal strain in the cable and…

Q: (a) tang tan

A: Given data: Opposite side =4 Adjacent side=2

Q: Directions: Draw an isometric view of the following orthographic views. Views most be properly…

A: Draw an isometric view of the following orthographic views.Views most be properly aligned attached.…

Q: Sketch the isometric view Sketch the first angle orthographic view Note:use creo parametric to…

A:

Q: Given the front, top and side views of the drawing add the missing lines (center, object, and…

A:

Q: Given the left and front views, sketch the top view.

A: The problem is easily done with the help of orthogonal projection. first try to imagine the 3D view…

Q: PART-A (Sectional View - SKETCHING) 1. Reproduce all two views given and add/complete the sectional…

A: Given Diagram To find Sectional views

Q: Circle the letter corresponding to the correctly aligned set of orthographic views. 1. 2. A 6:6 A E…

A: according to the drawing data we need to find, the right option. that represent the three…

Q: Sketch a isometric drawing for each of the three sets of orthographic drawings

A: Given: A set of orthographic projections.

Q: sketch the orthographic view of the given figure below

A:

Q: Top View Front View Right side View

A: according to the given details in the question, the Drawing of the figure is shown below. as…

Q: ZATION & ENGINEERING Design GraPhics with AuGmented REALITY

A: Sectional view

Q: Given the top and front views, sketch the right face.

A: According to the details provided in the question. Top view and front view is given we need to draw…

Bending Moment

In general, we can define the bending moment as the reaction induced when a certain amount of load or force is applied to an element which makes it bend.