Consider the following circuit diagram: 16 Q 25 j 64 N + 40020° -36j Z, Find Thevenin voltage VTh, Norton current Iy, and maximum average power. (A) 12.2708-65.86°, 334.81Z-5.13° and 12.27 W (B) 12.2708Z-65.86°, 334.81Z-5.13° and 1050.48 W (C) 334.81Z- 5.13°, 12.2708Z-65.86° and 1050.48 W (D) 334.8125.13°, 12.2708Z65.86° and 12.27 W

Consider the following circuit diagram: 16 Q 25 j 64 N + 40020° -36j Z, Find Thevenin voltage VTh, Norton current Iy, and maximum average power. (A) 12.2708-65.86°, 334.81Z-5.13° and 12.27 W (B) 12.2708Z-65.86°, 334.81Z-5.13° and 1050.48 W (C) 334.81Z- 5.13°, 12.2708Z-65.86° and 1050.48 W (D) 334.8125.13°, 12.2708Z65.86° and 12.27 W

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

ans: a. i = 10 cis-30° Ab. v = 220 cis25° Vc. I = 7.0711 cis-30° Ad. V = 155.5635cis25° Ve. Z = 22 cis55° Ω
Circuit theory 2
Two relays each with 20-ohm resistance and 0.16-henry inductance are connected in series. What is the equivalent impedance?a. 20 + j102.2 ohms c. 20 + j95.32 ohmsb. 20 + j120.63 ohms d. 10 + j25.32 ohms
A 5-ohm resistor is connected in series with a 25 micro-farad capacitor. A source voltage of158 volts, 50 Hz supplies the combination. Determine the following: e. Reactive power supplied by the sourcef. Apparent power of the circuitg. Power factor of the entire circuit
A source is connected to two loads impedance Z, and Zz in parallel. Choose the correct statement(s): Select one: a. The total average power delivered by the source is the sum of the apparent powers dissipated by Z, and Z2 O b. The total apparent power delivered by the source is the sum of the apparent powers dissipated by Z1 and Z O c. None of these O d. The total average power delivered by the source is the sum of the real powers dissipated by Z, and Z2
Q38 - Q40 refer to the table below: The voltage in a 60 Hz, 1-phase system has the following harmonic content: Harmonic Number Rms value 1 120 V 3 20V 5 9V Use this information to answer the questions Q25 to Q27. Q38. What is the rms value of the resulting current when this voltage is applied across a 100 resistive load? (a) 14.9 A (b) 12.2 A (c) 12.0 A (d) 3.9 A (e) 2.2 A Q39. What is the rms value of the resulting current when this voltage is applied across a 60 inductive load? (a) 24.83 A (b) 23.58 A (c) 20.33 A (d) 20.03 A (e) 20.00 A Q40. What is the rms value of the resulting current when this voltage is applied across a 69 capacitive load? (a) 24.83 A T (b) 23.58 A 20.99 A 20.36 A 20.00 A (c) (d) (e) 11
RMS Value of sinusoidal current is given by O a. Im//2 b. I,x2 Ос. c. ImX/2 O d. I/2 m
A load is supplied by a 230 V, 50 Hz source. The active power P and the reactive power Q consumed by the load are such that 1 kW SPS2 kW and 1 KVAR SQS2 KVAR. A capacitor connected across the load for power factor correction generates 1 KVAR reactive power. The worst case power factor after power factor connection is Options: 1. 0.447 lag 2. 0.707 lag 3. 0.894 lag 4.1
An impedance coil, in series with a resistor takes a current of 3A when connected to a 120V AC source. Using a voltmeter, the voltage across the coil was found out equal to 90V and that across the resistor equal to 30V. Find the power factor of the impedance coil only. The frequency is 60 Hz
Consider the circuit show in below figure 492 ww 200°V rms -j 20 The average power delivered by the source is (A) 37.85W, pf = 0.93 (Leading) (B) 75.7W, pf = 0.93 (Leading) (C)_75W,pf=0.93 (Lagging) (D) 37.85W, pf = 0.93 (Lagging) 6Ω
For a source which has load has the following characteristics: • Vrms = 125 20° V • P= 400 W • pf = 0.925 lagging What is the rms current and reactive power?
Circuit theory