7. A source of 100 Volts rms is supplying a resistance 80 ohms in parallel with a 200mHinductor. To what angle is the current lag or lead?A. 46.7 deg. lagB. 43.3 deg. lagC. 46.7 deg. leadD. 43.3 deg. Lead8. Two impedances Zı=2+j4 and Z2=R+j0, are connected in parallel. Determine R so that the pfof the circuit is 0.9 lagging.A. 3.2 ohmsB. 4.2 ohmsC. 2.4 ohmsD. 6.4 ohms9. The power factor of a load on a 120 volt. 60HZ source is raised from 0.707 to 0.866 laggingby connecting a 53 micro-farad capacitor across the load. What is the true power of the load inwatts?C. 862D. 268А. 286В. 68210. A factory has an average demand of 176 kw at 70% power factor. What is the minimum sizeof capacitor required to raise the power factor to 95%?C. 122 KVARD. 157 KVARA. 165 KVARB. 82 KVAR

According to guidelines we need to solve only the first question. According to the question we have…

7. A source of 100 Volts rms is supplying a resistance 80 ohms in parallel with a 200mH inductor. To what angle is the current lag or lead? A. 46.7 deg. lag B. 43.3 deg. lag C. 46.7 deg. lead D. 43.3 deg. Lead

7. A source of 100 Volts rms is supplying a resistance 80 ohms in parallel with a 200mH inductor. To what angle is the current lag or lead? A. 46.7 deg. lag B. 43.3 deg. lag C. 46.7 deg. lead D. 43.3 deg. Lead

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 2. Find the rms value of Hhe current wareform vhown below. i, A 10 T- 88- 4 t, s 14

Q: The average value of a sinusoidal current is 100 A. Its r.m.s. value is ............ (1) 63-7 A…

A: Given: Average value of a sinusoidal signal is Vavg=100 A.

Q: For the given waveform, current the voltage by an angle, þ. cot

A: we need to fill the given blanks.

Q: The voltage waveform during the first half cycle are from t = 0 to t = 0.01 increases linearly from…

Q: A The value of: A=5 ms C= 15 ms Peak to peak = 10 B D Figure 1 (a) From Figure 1 above, identify the…

A: An a.c circuit differs from a d.c circuit in many respects. First, in a d.c circuit we consider…

Q: Q2: For the following waveforms find a. Plot the instantaneous power P(t). b. Find average value of…

A: In this question, we need to plot the instantaneous power P(t) and average current and power? We…

Q: Find the RMS value of V-100 sin(377t+76) V

A: Equation of voltage is given as, vt=100sin377t+760 V.

Q: 2. Sketch the waveform of vo. Indicate the maximum, minimum and average values.vipk =15V

A: Solve the problem

Q: Q4/ Find the voltage average and the voltage waveform for the output of the circuit shown below.…

A: VAvg= 2V/pi VRMS=V/sqrt(2) Where V= peak voltage

Q: he sinusoidal waveform 4.35 Ohm Xc-5.52 E-100V

Q: The PMOS transistor in the circuit below has ∣Vt∣=0.5 V, kp=20 mA/V2 , and λ=0. Also, I=0.9 mA. (i)…

Q: Alternating voltage and current differ from direct voltage and current because alternating voltage…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: what will be the power factor, if the inductive reactance is equal to the capacitive reactance of 20…

A: Given: Inductive reactance is equal to capacitive reactance of 20 Ω XL=XC=20 Ω The resistance is 20…

Q: A sinusoidal current has a rms value of 3 amperes, its peak to peak value will be 2.1213 amp O 3.46…

Q: Calculate the rms value of a sinusoidal current of maximum value 20A.

Q: Find the RMS current from 30⁰ to 180⁰ at Im = 10 Amperes

Q: Given: Vi = Vpeak Sin wt V Vpeak %3| = 5 V With the ideal foward voltage = 0.7V, draw the waveforms…

A: It is given that: V1=VPeak Sin ωtVPeak=5VRL=1KΩVD=0.7V

Q: Draw rough sketches showing the following: a. A current which lags the voltage by 60°. b. A current…

A: Phasors rotates in anti clockwise. Current lags the voltage means current comes after voltage.

Q: An alternating current varying sinusoidally with a freq. of 50 c/s. has a r.m.s. value of 35 A.…

Q: Tu netuork show in opeating in the thndy doulce. If V, = 2aes2t state wilh sinusoidal ve and V, 2…

Q: Q1. A square waveform with following specifications RMS Voltage 163.21 Time for two cycle 35ms…

Q: What is value of RMS current if voltage is 10sin(100t) Volt and load is 10mH inductor.

A: v(t)= 10sin (100t) Volt XL=jωL XL=j(100)(0.01) Ω XL=j1 Ω

Q: 7 Find the average and effective values of voltage for sinusoidal waveform shown in Figure. Vm = 100…

A: Given Waveform in the question, Form the above figure, it can be observed that the waveform is an…

Q: If there is reactive power associated with a circuit element we can say a) That said element is…

A: Real Power: The power dissipated from the supply is utilized by the resistive nature of the circuit.…

Q: iii) A sine waveform with following specifications. RMS voltage 161.4V Time for ten cycles 0.02s…

A: Given values are =

Q: Q4/ Find the voltage average and the voltage waveform for the output of the circuit shown below.…

A: Diode conducts for negative half cycle and reverse bias for positive half cycle of input . As output…

Q: A series circuit consisting of 17ohm resistance and 20mH inductane is connected across a 220V(RMS)…

A: The solution is given below

Q: (b) An engineer is required to analyse a sinusoidal waveform for the voltage and current using…

Q: An engineer is required to analyse a sinusoidal waveform for the voltage and current using…

Q: The voltage applied to the metal grid of CRO is negative with respect to cathode. Select one: O True…

A: Concept of CRO CRO is called as Cathode Ray Oscilloscope. The main component of CRO is Cathode Ray…

Q: A triangular voltage source has a peak value of 10 V. What is the computed RMS value of this source?…

Q: The current waveforms of a capacitor are shown in Figure below. Determine the average, root mean…

A: Given:capacitor current waveform as,with Ipeak = 400A.we need to find:a) the average value of the…

Concept explainers

Sinusoids And Phasors

Sinusoids are defined as the mathematical waveforms that are used to describe the nature of periodic oscillations.

Circuit Theory

Electric circuits are a network that comprises of a closed-loop, which helps in providing a return path for the current through a switch. When the switch is activated, the load operates, and the current accepts a path to finish the circuit at a low potential level from the opposing high potential level. Electric circuits theory is a linear analysis that helps in establishing a linear relation of voltage and current for R (resistance), L (inductance), and C (capacitance).

Question

7. A source of 100 Volts rms is supplying a resistance 80 ohms in parallel with a 200mH
inductor. To what angle is the current lag or lead?
A. 46.7 deg. lag
B. 43.3 deg. lag
C. 46.7 deg. lead
D. 43.3 deg. Lead
8. Two impedances Zı=2+j4 and Z2=R+j0, are connected in parallel. Determine R so that the pf
of the circuit is 0.9 lagging.
A. 3.2 ohms
B. 4.2 ohms
C. 2.4 ohms
D. 6.4 ohms
9. The power factor of a load on a 120 volt. 60HZ source is raised from 0.707 to 0.866 lagging
by connecting a 53 micro-farad capacitor across the load. What is the true power of the load in
watts?
C. 862
D. 268
А. 286
В. 682
10. A factory has an average demand of 176 kw at 70% power factor. What is the minimum size
of capacitor required to raise the power factor to 95%?
C. 122 KVAR
D. 157 KVAR
A. 165 KVAR
B. 82 KVAR

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Find the RMS value..
Find the rms of the below voltage waveform A. 0.8165V B 8.165V C 0.9268 D 9.268
A curve is drawm in descending order of load with time. Al1
Get the RMS and average value of the voltage. Frequency is 60 Hz. Please write properly the solution. Make sure to recheck.
Q2. For the circuit shown below, sketch the current waveforms is and io and determine the Average and RMS for both currents. ot io Vs = 220V a = 220° + ot 1002
Measure and record the peak-to-peak voltage across each of the following points in the table
Select the letter of the correct answer from the given problem. *Kindly provide a CLEAR and COMPLETE solution* (Answer should be typewritten) *Please answer it ASAP
Design a circuit limit a 25 V rms sinusoidal voltage to a maximum positive amplitude of 18 V of using 12 V dc source.
i need the answer quickly
Solve for 20 V rms supply. Thank you.
Question 19 A 23 kHz sinusoidal signal is applied to a 0.0023 µF capacitor. If the rms current measures is 4 mA what is the voltage rms across the capacitor Enter your results in volts. Do not type the unit.
Computed Rms value (V) 100 E1:A to B E2:A to C 1502 E3:A to D 220. E4:A to F 220 Vac E5:A to G 330 E6:F to G E7:B to C 470 E8:C to D 6802 E9:D to E E10:E to F