Cone penetrometer soundings were used for the subsurface investigation of a planned construction site. At one sounding location, the value recorded for qc at a depth of 21 feet was 150 ksf. The soil has a unit weight of 115 pcf. Using criteria that relate CPT results and the soil angle of internal friction, estimate the value of f for the sand at the test depth (known from borings).

Q: A sample of sandy soil is known: ϕ′=32∘ Under the CD test of this sample, what is the expected…

A:

Q: Cross-sectional area of soil: 80 cm^2; Length of soil: 10 cm ;Initial head: 90 cm ; Final head : 84…

A:

Q: A set of three unconsolidated undrained triaxial compression tests were also performed on soil…

A: A set of three unconsolidated undrained triaxial compression tests were also performed on soil…

Q: A cu test was performed on a 3.5cm diameter sand sample. A confining pressure of 2.0 kg/cm2 was…

A:

Q: A sample of dry sand is tested in direct shear. The shear box holding the sample has a circular…

A: Given data  Shear force Normal force Diameter  Dry sand

Q: Q4- Results shown in table below were obtained from an Odometer test on specimen of saturated clay.…

A: H=1.9m,γsat=18.8 kN/m2,h1=2m,h2=2.5m,γ=20.8kN/m2σo=H+h1(γsat-γw)      =35kN/m2∆σ=h2γ       =52…

Q: Solve this problem graphically and then analytically. A CU triaxial test was performed on a dense…

A: Introduction Stress is a physiological term in continuum mechanics that describes the internal…

Q: undrained triaxial test was conducted on a normally consolidated clay sample and the results are as…

A:

Q: A standard penetration test was carried out in a normallyconsolidated sand at 25 ft depth where the…

A: Relative density is defined as the ratio of the density of the material to the density of the…

Q: The results of an SPT investigation at a site in Cool, CA yield a value of Neo of 7 for a saturated…

A: Given data :  N60 = 7  Sand layer span = 3 m  Friction angle ?

Q: The results of two consolidated-drained test triaxial tests on a clay are given below: Specimen No.…

A:

Q: Cone penetrometer soundings were used for the subsurface investigation of a planned construction…

A: Find undrained shear stress:

Q: The standard penetration test results of a sand deposit at a certain site are given below in tabular…

A: Given: SPT data of a sand deposit is as follows Deth(m) Nf (blows/30 cm) 1.5 8 3 7 4.5 12…

Q: FUNDAMENTALS OF GEOTECHNICAL ANALYSIS A constant head permeability test is performed on soil that…

A:

Q: A subgrade soil sample was tested using standard CBR apparatus and the observations are given below.…

A: Given data- A subgrade soil sample- Standard CBR apparatus and test results given- Load-penetration…

Q: A consolidated-undrained tri-axial test was conducted on a normally consolidated clay sample and the…

A: Determine the drained friction angle of the soil. Compute the deviator stress (kPa) at failure

Q: In a soil investigation work at a site, Standard Penetration Test (SPT) was conducted at every 1.5 m…

A:

Q: FUNDAMENTALS OF GEOTECHNICAL ANALYSIS During a Standard Penetration Test on silty clay soil, blow…

A: In a Standard Penetration Test on silty clay soil,The number of blows are as follows,1. For first…

Q: The following results were obtained from a shear box test for a soil sample and the dimensions of…

A: The shear parameter of any soil type is the cohesive strength of the soil and the angle of internal…

Q: Date 1. The site investigation results below are for a site with sand and gravel above 18 ft and a…

A: Given: Moist unit weight of sand, γbsand=105 pcf Moist unit weight of clayey sand, γbClay sand=112…

Q: use the attached graph paper) A series of direct shear tests was performed on a soil sample. Each…

A: Direct shear test is a simple and quick test to determine soil properties like cohesion and angle of…

Q: A piezocone test was carried out at a site, and the following readings were recorded for the cone…

A: Note:- Hi! Thank you for the question As per the honor code, We’ll answer the first question since…

Q: A constant head permeability test is performed on soil that is 2 cm x 2 cm square, and 2.5cm long.…

A:

Q: 423 8, The results of three consolidated-undrained particular soil are: Test no. a (kPa) a-a at peak…

A: Calculate the values and tabulate them Specimen σ3(kPa) σd(kPa) σ1=σ3+σd U σ1' σ3' 1 200 244…

Q: N60 Depth (m) 1.5 3.0 7 13 4.5 18 6.0 22 7.5 24 For, the sand deposit, assume the mean grain size,…

A:

Q: A Standard Penetration Test was performed at a depth of 15 feet in a soil with a Unit Weight of 115…

A:

Q: In a standard penetration test in sands, the blow count measured at 14 m depth was 26. An automatic…

A: SPT N at 14m depth = 26 Eh = 70% = 17.5 kN/m3 NOTE : As per guidelines, first 3 parts are solved.…

Q: A cohesionless soil sample was subjected to a triaxial test.  The sample failed when the minor…

A: Given:- A cohesionless soil sample was subjected to a triaxial test The value of minor principal…

Q: In a deposit of normally consolidated dry sand, a cone pen- etration test was conducted. Following…

A: Given Data:The dry unit weight of sand is, To Determine:The average peak friction angle  for the…

Q: Due Date: One Week after Lab session Part #1 Consolidation test results of a settlement versus time…

A: Consolidation: when the soil mass is subjected to a compressive force, its volume decreases. The…

Q: A sand deposit has been identified beneath a site located adjacent to a river. The sand deposit is…

A:

Q: A cone penetration test result of a deposit of normally consolidated dry sand are given below.…

A: Unit weight of sand = 100 pcfCone penetration data is given for various value of depth

Q: Q11: A silty sand of density index (ID or D₁) = 59% was subjected to standard penetration tests at a…

A: Given Data:ID=59%d=3mN=15energy =350 Joulesunit weight = 19.3 kN/m3

Q: A standard penetration test is carried out in sand where the efficiency of the hammer nH =70%. If…

A:

Q: 2- Subsurface geotechnical investigations carried out in a deposit of sand provide standard…

A:

Q: A triaxial test was performed on dry, cohesionless soil under a confining pressure (?3) of 144…

A: Given data confining pressure,σ3=144 kN/m2Deviator stress=395.8 kN/m2σ1=confining pressure+deviator…

Q: Soil borings for the subsurface investigation of a site indicate a deep deposit of sandy soils. At…

A:

Q: er experts to do , otherwise i will downvote    The following series of standard penetration test…

A: According to given data  18-ft thick stratum of relatively uniform silty sand: Groundwater table…

Q: 2- Subsurface geotechnical investigations carried out in a deposit of sand provided the field…

A: It is given that :

Q: A sand deposit has been identified beneath a site located adjacent to a river. The sand deposit is…

A: Given, Total depth= z= 24'+30'=54'=1.37 m SPT = 20 blows/foot Efficiency= 60% Borehole diameter=…

Q: A direct shear test is performed on a soil sample with two different loads. In the first test, a…

A: Given: For test 1: Normal stress = 55 kPa Shear stress = 35 kPa   For test 2: Normal stress = 75 kPa…

Q: (3) A direct shear test is used to find the shear strength of a soil. For two soil samples, the…

A: Determine strength parameters for given soil

Q: A 6 in diameter exploratory boring has been drilled through a fine sand to a depth of 19 ft. An SPT…

A: Diameter = d = 6in. Depth of sand = 19ft SPT N-value =N =  23 Depth of GWT = 35ft.