ATM is a link layer technology that uses a short packet, called an ATM cell, with a total length of 53 bytes. Find the ATM protocol efficiency (in %) if the cell header is 5 bytes. Use only one digit after the decimal point.

ATM is a link layer technology that uses a short packet, called an ATM cell, with a total length of 53 bytes. Find the ATM protocol efficiency (in %) if the cell header is 5 bytes. Use only one digit after the decimal point.

Operations Research : Applications and Algorithms

4th Edition

ISBN:9780534380588

Author:Wayne L. Winston

Publisher:Wayne L. Winston

Chapter20: Queuing Theory

Section20.10: Exponential Queues In Series And Open Queuing Networks

Problem 8P

See similar textbooks

Related questions

Q: Consider the figure below in which a TCP sender and receiver communicate over a connection in which…

A: This quеstion еxaminеs a scеnario involving TCP data transmission with sеgmеnt loss. Undеrstanding…

Q: Consider a network connecting two systems located 4000 kilometers apart. The bandwidth of the…

A: The solution of the above problem is as follows:-

Q: Assume that TCP implements an extension that allows window sizes much larger than 64 KB. Suppose…

A: We begin with a 1 KB window size that doubles with each RTT. Realizing that 1 MB is 1024 times…

Q: Is it the case or not? Consider a TCP connection where the most recent SampleRTT was 1 second. The…

A: In a TCP connection, sample RTT TCP is a connection-oriented protocol, and connection is required…

Q: "An application message is segmented into 20 packets, each of which is 2500 byte in sze. Calculate…

A: Answer: This question from computer network I have given answered in the handwritten format

Q: Suppose an extension of TCP allows window size much larger than 64 KB. Assume the extended TCP runs…

A: Solution :

Q: es. The delay be re shown. The 1

Q: Consider the figure below in which a TCP sender and receiver communicate over a connection in which…

A: This quеstion еxplorеs thе intricaciеs of TCP data transmission in a scеnario with sеgmеnt loss.…

Q: A router needs to transmit an IPv4 datagram with a total size of S bytes. The link layer of the…

A: ATM Adaption Layer 5 (AAL5) is used to send variables of length packets up to 65,535 octets in size…

Q: A TCP message of 19.2KBytes is sent in a network system with a 1000Byte MTU. Source and destination…

A: Given that, Length of message= 19.2 K Bytes MTU (Maximum Transmissible unit)= 1000 Bytes Number of…

Q: Consider the figure below in which a TCP sender and receiver communicate over a connection in which…

A: Given that,number of segments TCP sender sends an initial window = 5Initial value of the sender…

Q: How long does it take a packet of size 10 KB to travel over three links (connection) with a…

Q: segment is defir P segment is p E. Consider a TC

Q: Answer the following questions briefly. How does resource reservation work in the TCP / IP model?…

A: Solution is : 1. RSVP is abbreviation for Resource Reservation Protocol. RSVP Resource Reservation…

Q: Consider a TCP connection with congestion window size 40 KB, maximum segment size is 2 KB, if time…

A: Introduction

Q: the Go-back-N protocol

A: The Go-back-N protocol are on an end-to-end basis and on a link-by-link basis.

Q: Explain the flow control of TCP protocol when the size of the sliding window will be 500 and the…

A: UhhffghyhyyFlow Control of TCP Protocol: 1. The size of the sliding window is 500. 2. The client…

Q: Consider a TCP connection betweek two hosts between A and B. The first data byte sent by A is…

A: Given : First byte received = 1 Last byte received= 500

Q: Internet Check sum Consider the figure below (simplex communication scenario). The TCP sendel sends…

A: Ensuring that the data is delivered in an organized and reliable manner is important in network…

Q: Suppose you are hired to design a reliable byte-stream protocol that uses a sliding window (like…

Q: TCP congestion control example. Consider the figure below, where a TCP sender sends 8 TCP segments…

A: Given, a figure where 8 TCP segments are sent by TCP sender at time t =1, 2, 3, 4, 5, 6, 7, 8.…

Q: Consider sending a 3500-byte datagram that has arrived at a router R₁ that needs to be sent over a…

A: The question is to find the number of fragments delivered to the destination.

Q: A TCP connection is using a window size of 8,000 bytes and the previous acknowledgment number was…

A: A diagram to show the situation of the window before and after is given below for the…

Q: TCP session sends 50 packets per second over an Ethernet Local Area Network (LAN). Each packet…

A: TCP session sends 50 packets per second over an Ethernet Local Area Network (LAN). Each packet…

Q: An HTTP client opens a TCP connection using an initial sequence number (ISN) of 14,534 and the…

A: Answer An HTTP client opens a TCP connection using an initial sequence number (ISN) of 14,534 and…

Q: In protocol 6, the code for frame arrival has a section used for NAKs. This section is invoked if…

A: NAK is an acronym for Negative Acknowledgment.ACK is an acronym for Acknowledgment.

Q: Suppose you are hired to design a reliable byte-stream protocol that uses a sliding window (like…

A: We need to find the number of bits in advertised window and sequence number fields of the protocol…

Q: In TCP Vegas, the calculation of Actual Rate is done by dividing the amount of data transmitted in…

Q: with a um tim

Q: In a protocol that uses 5 bits for the sequence-number field, if a packet has the sequence number x,…

A: In the given question it is asked to consider a 5 bits sequence number field. A packet has sequence…

Q: TCP session with 00 Mb/s. The sess mber of 3465. The efore this sequenc

Q: A 3200 bit long TCP message is transmitted to the IP layer and becomes a datagram after adding a 160…

A: If the Maximum Transferrable unit(MTU) of a router is less than the size of data then the datagram…

Concept explainers

Types Of Protocols

A network protocol is a collection of rules that governs the exchange of data between devices connected to the same network. In other words, network protocols are rules that specify how devices communicate or transfer data over a network. The sender and receiver systems must obey the standards to facilitate communication between them.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

Computer science
A 1500 byte message is sent over the network using a protocol stack with HTTP, TCP, IP and Ethemet. Each protocol header is 20 bytes long. The percentage of the network bandwidth "on the wire" is wasted due to the overhead is (in %).
Can someone help me with the following Computer Networking Question? I know the answer, but can you show me step by step how you would have gone about solving this problem? Thank you :)
If a two port bridge was used in a heavy load standard Ethernet network such that the traffic is going through it. If each station is theoretically given a capacity of5Mbpsand the number of stations in each LAN segment is equal, then the number of stations in each LAN is:
(b) The Internet Protocol (IP) can sometimes surprise with its flexibility. Since the overall design is close enough to the principles of the OSI Protocol Model, IP is independent of the Data Link and Physical network layers. And some Norwegians indeed showed successful IP network transmission is possible with carrier pigeons. If we would want to attempt to use carrier pigeons to establish a TCP connection between Canterbury and London, how long would it take to successfully establish the transmission under perfect conditions? (Assume the pigeons are perfectly reliable.) Explain how you come to your result. (1)
Sir, can you solve it fast , do not solve incorrect
Computer Science What is the total number of addresses in IPv6 address scheme (give your answer in comma separated actual numeric value)? Give examples of IPv6 address types: a unicast address, a multicast address, a loopback address, and an unspecified address (e.g., when host does not have an address assigned).
Give unique answer only. Do not use AI or plagiarized answer.
Solve if you are sure. Otherwise I will rate negatively.
If CS = 24F6 and IP = 634A, Find: a) Real Address b) Direction of travel c) Physical Address d) Segment address
It is necessary to investigate connectionless protocols as a potential substitute for connection-based protocols.
Consider the following Promela model for the Alternating Bit Protocol /* Alternating Bit Protocol, cf. Holzmann 1993, Tutorial */ #define N 2 #define MAX 8 #define FETCH mt = (mt+1)%MAX #define ACCEPT printf("ACCEPT %d\n", mr); assert(mr==(last_mr+1)%MAX) mtype = {data, ack, error} proctype lower_layer(chan fromS, toS, fromR, toR) { byte d; bit b; do ::fromS?data(d,b) -> progress0: if :: toR!data(d,b) /* correct */ :: toR!error(0,0) /* distorted */ fi ::fromR?ack(b) -> progress1: if :: toS!ack(b) :: toS!error(0) fi od } proctype Sender(chan in, out) { byte mt; /* message data */ bit at; /* alternation bit transmitted */ bit ar; /* alternation bit received */ FETCH; /* get a new message */ out!data(mt,at); /* send it */ do ::in?ack(ar) -> /* await response */ if ::(ar == at) -> /* correct send */ FETCH;…