Compute the total elongation caused by an axial load of 147 kN applied to a square bar, tapering from a width of 120 mm to 40 mm in a length of 10 m as shown. Assume E %3D 202 GPa. Answer must be in mm. 120 mm 40 mm Area = A P kN P kN A B X- L= 10 m

Compute the total elongation caused by an axial load of 147 kN applied to a square bar, tapering from a width of 120 mm to 40 mm in a length of 10 m as shown. Assume E %3D 202 GPa. Answer must be in mm. 120 mm 40 mm Area = A P kN P kN A B X- L= 10 m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 50° 187 kips 10 in 14in 10 in 20 kips 35 kips 84kips 28in

A: Given, AB=14 in Force =84 kips and 187 kips

Q: To print out a and b given below, which printf() statement would you use? float a = 3.14; double b =…

A: Given:- To print out a and b given below, which printf() statement would you use? float a = 3.14;…

Q: Q1// Test the following DE for exactness: y (cos'x+y sin x) dx + cos x (sin x cos x+ 2y) dy = 0 اختر…

A: We have, y(cos3x+ysin x)dx+cos x(sin x cos x+2y)dy=0 A differential equation of first order and…

Q: An m xn matrix has m

A: Ans False.

Q: 1) Determine the Centroid of the Shaded Area, Tabulate your answers and solution. Y 450 mm 300 mm r…

Q: Consider the shaded area in (Figure 1). Suppose that a = 2 m, b = 2.5 m, and k = m-1 8 Figure a y =…

A: Given a parabolic segment in which the y coordinate of centroid is to be calculated. Consider an…

Q: Complete the table

A: To complete following table As asked only displaying excel formulas and output

Q: 1) Determine the Centroid of the Shaded Area, Tabulate your answers and solution. Y 450 mm 300 mm r…

Q: a) The true length of a line was known to be 50 m. The line was measured with a 30 m tape and found…

A: The linear measurement in the survey can be carried out using the chain, tapes etc, While measuring…

Q: Pre-measured experimental data: Using the experimental data given below, complete the lab report as…

A: Euler-Bernoulli Beam Theory : Linear theory of elasticity is simplified in Euler-Bernoulli beam…

Q: A pump takes water from an 8 inch suction pipe and delivers it to a 6 inch pipe in which the…

Q: Q2: The following blanks should be filled with a suitable preposition. 1. Yesterday, there was a…

A: Let's understand the some preposition. "In" is generally used for longer time like "1995" or "2005…

Q: 14. Find the elevation of point A in the figure shown. 30 cm Hg DAIR Vacuum Gasoline (5=1₁5) Ale B…

A: Given To find The elevation at point A

Q: Write true if the statement is correct. if the statement is wrong, Write the word or phrase that…

Q: g Present Worth method,

A: Present worth= cash inflow - cash outflow. For Type A: Present worth = -(250000 + 250000*3%) -…

Q: Complete the integration: 1 Scos"2niax - an2x -an'2x+c Determine the value of "?".

A: cos22x= 1-sin22x

Q: SIEVE NO. AMOUNT RETAINED (g) 215 1 885 980 2,350 3/8 1,190 4 2,205 8. 1,985 10 1,840 40 1,650 100…

Q: What is the probability

A: solution: R, B R, B R, B R, B R, B R, B 1,1 1,2 1,3 1,4 1,5 1,6 2,1 2,2 2,3 2,4 2,5 2,6 3,1…

Q: What reduction factor are we going to use if p > Pb a. 0.9 b. 0.65 c. 0.45 d. Ø= 0.65 +0.25 Ey Et…

A: Given:-ρ>ρbTo find:-reduction factor

Q: omn ample-2 For measuring the area of a figure using planimeter, the as placed outside and the…

Q: Given a liquid with a specific gravity of 0.82 flows through a 100-mm pipe 308-m long at a rate of…

A: The Reynolds number is a dimensionless quantity used to determine the value of the flow pattern when…

Q: An engineer measures the diameter of 20 tubes selected at random from a large shipment. The sample…

A: Given Data : no. of tubes n = 20 S=9.4 mm x¯=48.5 mm x'=42.1 mm

Q: PROBLEM 2: A pipe transports 1962 N/s of water. The pipe tees into a 2"-diameter pipe and a…

Q: Convert 1,200 mils to grads. Select one: O a. 80 grads O b. 86 grads O c. 75 grads O d. 72 grads

A: Given 1200 mils Converting mils to grads

Q: Using the information below, use Excel and show the equation on how to solve for each: #3: The…

A: Given data: Replicate Mass (g) 1 10.0000 2 10.0001 3 9.9999 4 10.0000 5 9.9998 6…

Q: Determine the distance to the centroid of the area.

Q: SIEVE ANALY SIS - US STANDARD SIEVE SIZES BIEVE NUMBER. HYDROMET 30 60 30 140 114 18 10 20 40 80 100…

A: given LL = 34PL = 22IP = LL -PL ⇒12A - line = 0.7322-20 = 10.22

Q: A particle travels along a straight line with an acceleration of a=(10−0.2x)m/s∧2 where x measured…

Q: equivalent to a force-couple system consisting of R and M2 = 3000 kip-in

A: Given: Force couple system of a trapezoidal plate To determine: The moment M1

Q: RKI Instruments manufactures a ventilation controller designed for monitoring and controlling carbon…

A: given datanet cash flow is givenyears are givenfind1) what do the wo rules about sign changes…

Q: How were the equations in the table of "visual work product integration" derived? /in other words…

Q: The error in measuring the radius of a 5cm circular rod was 0.2%. If the cross-sectional area of the…

A: given- Error in measuring radius= 0.2% radius=R=5 cm area=A % error in area needs to be find out.

Q: 4. Specific Weight is also called Relative Density. 5. Standard density of water in English unit is…

A: 4, false Because specific weight=weight of fluidvolume of fluid=mgv=Density × acc due to gravity…

Q: swer numerical values only (without units) and in two decimals for questions without choices. Only…

Q: The error in measuring the radius of a 5cm circular rod was 0.2%. If the cross-sectional area of the…

A: given- radius=R=5 cm area=A % error in area needs to be find out.

Q: A machine that costs 3000 JD with a lifetime of 10 years, and an estimated SV of 300 JD. Using…

Q: Part A Suppose that L = 6.6 in. (Figure 1) Locate the centroid (, j). Express your answers using…

Q: between

A: In a bolt connection the net area is defined as the area from which the bolt hole is get deducted…

Q: Consider the non-interacting tanks in the figure below. Resistances R 1 and R 2 are linear. The flow…

Question

100%

Show complete solution. Dont round off initial values, round off final answer only

Compute the total elongation caused by an axial load of 147 kN applied to a square bar,
tapering from a width of 120 mm to 40 mm in a length of 10 m as shown. Assume E =
202 GPa. Answer must be in mm.
120 mm
40 mm
Area = A
%D
P kN
P kN
B
L = 10 m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

1-1 What is the weight in newtors of an object that has a mass of (a) 8 kg, (b)0.04 kg, and (c) 760 Mg?
- GET THE GIVEN, WHAT IS ASKED, AND THE ANSWER. - MAKE A PROPER FREE BODY DIAGRAM. (IT DOES HAVE THE GREATER POINTS IN THIS ACTIVITY) - YOUR SUB ANSWERS MUST BE IN 6 DECIMAL PLACES. - YOUR FINAL ANSWER MUST BE IN 4 DECIMAL PLACES. - WRITE YOUR SOLUTION PROPERLY (EASY TO UNDERSTAND). - I PROVIDED A SAMPLE PROBLEM SO THAT YOU WILL KNOW HOW TO SOLVE IT. THANK YOU IN ADVANCE!
Jasper had $5 in his account in Day 1. On each subsequent day after Day 2, he deposited a constant amount into her account. At the end of Day 101, he has $305. How many dollars does he have in his account at the end of Day 3?
Round the answer into 3rd SIGNIFICANT DIGIT!Round the Answer into 3rd SIGNIFICANT DIGIT!
DO NOT ROUND OFF IN BETWEEN YOUR SOLUTIONS. FINAL ANSWERS SHOULD BE ROUNDED OFF TO 3 DECIMAL PLACES.
ANSWER THE FOLLOWING PROBLEM QUESTION. SHOW YOUR SOLUTION AND BOX THE FINAL ANSWER DO NOT FORGET TO ROUND OFF AND USE 2 DECIMAL PLACES AS YOUR FINAL ANSWER. Thank you again for helping me. TAKE NOTE: A2 MEANS AREA 2 A3 MEANS AREA 3
Please describe the following terms: gradient, gradient ascent, gradient descent likelihood function, maximum likelihood estimation.
1. Answer each problem following the proper format (GIVEN, REQUIRED, SOLUTION). 2. Do not round off intermediate values when using them to solve subsequent values; however, they may be written up to 4 decimal places in your answer sheets. Final answers should be rounded off up to 4 DECIMAL PLACES. 3. Box the final answers.
Using Virtual Work Method Find the smallest value of P acting at the FD midspan that is required in order to get a zero deflection at point B. For two steel beams EI = 400,000 kNm² Please box your final answers I'll thumbs up on the correct answer. please see the note, below before answering. Final answers in the solution sheet should be rounded to three (3) decimal places and should be enclosed in a rectangle for easy identification. Final answers for locations or distances must be given in meters or feet. Final responses for deflections must be given in millimeters or inches. NOTE: No final solutions shall be in scientific notation. Final answers for slopes shall be in degrees to 5 decimal places.
side 1 side 2 side 3 side 4 1 4.5 4.5 15 3 62.1 in. X in. X in. X in. X in. 42.1 in. 23 X Watch It Ⓡ What is the total area of the two triangle shapes (a) and (b) (in square inches)? 182.25 X Your response differs from the correct answer by more than 10%. Double check your calculations. in² What is the area of the rectangular shape (c) (in square inches)? 15 Your response differs from the correct answer by more than 10%. Double check your calculations. in ² What is the approximate frontal area of the car (in square inches)? 5684.8 X Your response differs from the correct answer by more than 100%. in² Need Help? Read It
21- Students A and B compete in final exams. Who was more accurate and won the competition? Results: student A = {9; 8; 8; 8; 7}, student B = {10; 10; 8; 7; 5} A- student B B- student A C- equal result D- No solution
Sheet 2: Do the required for the following questions: O1: dy Find the particular solution of 5 dx dy - 2y 3e" given that when x 0, y= - dx and dx Ans.: y = 44