Compute the shearing stress (MPa) in the pin at B for the member supported as shown. The pin diameter is 20 mm 40 kN Pin at B 250 mm 200 mm

Q: PROBLEM 05 In the steel structure shown, a 6mm diameter pin is used at C and 10mm diameter pins are…

A: This question is related to the Bending Stress and Shear Stresses from Strength of Material. In this…

Q: the glued splice is 75 psi, determine (a) the largest load P that can be safely supported, (b) the…

A: θ=90-60=30°We knowσθ=PAcos2θ75=P5×3cos230P=1500lbs=1.5kips

Q: Determine the force in element DF and EF of the shown reinforcement subject to the indicated forces.

A:

Q: Two plates are joined by four bolts of d= 20 mm diameter and shown in Figure. The shearing, tensile,…

A: Diameter,d=20mm Shear stress=80MPa Tensile stress=100MPa Bearing stress=140MPa To find ,P=?

Q: The vertical links (at BD and two at CE) has an thickness = 9.9 and width = 27.2 mm uniform…

A: bearing stress in BD member load at BD section will be remain 8.5N and diameter of the pin is 7.7 mm…

Q: A truss is loaded as shown in the figure. The cross- sectional area of each member is 500 mm^2.…

A:

Q: Each bar of the truss has a rectangular cross section, 30 mm by 60 mm. Determine the maximum…

A:

Q: In the steel structure shown, a 6-mm-diameter pin is used at Cand 10-mm-diameter pins are used at B…

A: Draw the FBD of the rod then using equilibrium equations calculate the reaction at C. Then using the…

Q: 1.51 In the steel structure shown, a 6-mm-diameter pin is used at C and 10-mm-diameter pins are used…

A:

Q: The hinge support at B, of beam AB shown below, has the magnified front view and side view shown.…

A: To determine the force causing the double shear in pin at support B and the corresponding minimum…

Q: 3. A 16 mm steel bar AB and a 25 mm steel bar BC support a load P = 7,500 N as shown. If E = 200…

A:

Q: COMPUTE THE SHEARING STRESS IN THE PIN AT B FOR THE MEMBER SUPPORTED AS SHOWN IN THE FIGURE. THE PIN…

A:

Q: If the applied load "P" causes the point C to be displaced downward by &c=1 mm, determine the normal…

A: LAC = 210 mmLBC = 480 mm

Q: The thickness of the clevis is 0.016m and the square steel gusset plate has 0.02m thickness.…

A:

Q: raw Mohr's circle and determine the principal stresses. 30 MPa 30 MPa 40 MPa -9-

A:

Q: Determine the maximum distance d to the edge of the plate at which the force P can be applied so…

A:

Q: Radius of the pin at C is 3mm. While at static equilibrium, we know that a force P of magnitude 500…

A: p=500 n r= 3mm

Mechanics of Solids

It is the study of the behavior of solid materials, their characteristics under various circumstances such as variation in external forces, temperature, and other internal factors. It is one of most important study in the field of engineering science, especially chemistry and mechanical engineering. In rigid body, the idealization of the solid body in which deformation is neglected. Deformation is known as the force acting on the solid state system which exerts change in its shape of the body but it continues to be at rest or in a uniform motion but it cannot accelerate. But those solid systems do have elasticity, compressibility and can be bent. This field is very vast since there are wide range of materials around us.