Compute the area of steel for the L-section shown in the figure if it is subjected to M₁ = 120 kN.m fcu = 35 N/mm² and fy = 400 N/mm² 600 mm 100 T

Q: 3k 30lbs 40° 40°

A:

Q: 2.3-7 A steel bar 2.4 m long has a circular cross section of diameter d, = 20 mm over one-half of…

A: Given Data: Total length of the bar is L=2.4 m The diameter of the left half portion is d1=20 mm The…

Q: 1. Rigid member ABC is connected to two elastic bars, as shown in the figure. Bar AD is heated by…

A:

Q: The steel propeller shaft ABCD carries the axial loads shown in Fig. (a). Determine the change in…

A:

Q: The beam shown in the figure below is subject to a moment of M = 10 kN.m as illustrated. Calculate…

A:

Q: Question 3) The rigid beam CD in the figure is attached to the ceiling with AC and BD rods. The…

A: Given data: Bar AC :     L=2 mE=70 GPaD=11 mm Bar BD :  L=0.7 mE=94 GPaD=25 mm Rigid beam CD L=1.5 m…

Q: A rigid bar AB is hinged at A and is supported by a rod at C. The rod is pin-connected at D as…

A:

Q: A cantilever beam with a 'T' shaped cross-section is loaded with a distributed load as shown below.…

A: Width of flange= 80 mm  Height of web = 75 mm

Q: 2 For the assembly shown in the figure, brass rod AE (E=105 GPa) and aluminum rod BF (E=70 GPa) each…

A: To find displacement at point D

Q: the clamp exerts a normal force of 100N on the three pieces held together as shown. what force P may…

A: F=100N u=0.6

Q: An aluminum plate is subjected to uniform stress along its boundaries, as shown in the figure.…

A: stresses on an element is given as followschange in length of diagonal BD=?

Q: What is the value of the torsion constant for the beam cross section shown below? 60 mm 20 mm 20 mm…

A:

Q: 4. A copper bar 250 mm long and 50mmx50mm in cross-section is subjected to an axial pull in the…

A: As per our company guidelines, we are supposed to answer only one question. Kindly repost other…

Q: The steel bar has the original dimensions shown in the figure. If it is subjected to an axial load…

A:

Bars

In civil engineering, bars refer to steel reinforcement bars or rebars. These are structural members primarily used for reinforcement purposes in masonry works. A bar is characterized by its cross-sectional area, which is negligible compared to its length. Bars are usually manufactured by steel which is uniform throughout the length, or by meshing multiple steel wires. Other materials of the bar include carbon steel, glass fiber, carbon fiber, and basalt fiber. The reinforcing bars are coated with epoxy resins and other materials to enhance some of their properties including corrosion resistance.