complete solution and drawing. if u can please add some explanation thankyou FN = 49 MN = 101 SN = 94

Q: A lever is attached to a shaft with a square shear key as shown. The force applied to the lever is P…

A:

Q: The timber beam in Figure 2 is simply supported at points A and E. The cross-section of the beam…

A:

Q: someone who can.

A: Given Cantilever beam of length 4 ft and udl of 100 lb/ft

Q: given truss. Pls, indicate the scale. 1000 lb 2000 lb 1000 lb 2000 lb 1000 lb D 1000 lb THE no 2000…

A: given the truss and applied load for the truss

Q: A lever is attached to a shaft with a square shear key as shown. The force applied to the lever is P…

A: P = 525 N  = 74 MPa

Q: Find the centroid point of the area below given that a = 12 in. a a Solution: • The composite area…

A: Given data:- The given value of a is 12 in. After cutting the section,

Q: A lever is attached to a shaft with a square shear key as shown. The force applied to the lever is P…

A:

Q: w100 put For Beam #2 shown at left, identify the correct statement(s). a. Mux = 7200. b. VMAx = 1200…

A: For the given simply supported beam having full span WDL of 100lb/ft with a span of 24ft.

Q: Draw the strength line diagram of a 300mm square RC column section reinforced with 4N16 bars on all…

A: Strength line diagram: The diagram which represents all the resultants of the loads acting on any…

Q: Determine whether the block shown is in equilibrium and find the magnitude and direction of the…

A: Step 1: Draw the FBDStep 2: Compute for the normal…

Q: Determine whether the block shown is in equilibrium and find the magnitude and direction of the…

A: Step 1: here we have calculated all the component forces Step 2: here we have calculated the…

Q: Could you please help determine elastic center C Where the square has a  modulus of elasticity =…

A: Determine elastic center CWhere the square has a  modulus of elasticity = E_w and  the two riangle…

Q: Match the cross-sections with the appropriate object and cutting plane for the problems shown below.…

A: Engineering drawing

Q: The thin uniform plate shown has a mass of 100 kg and is subjected to a force and couple moment…

A:

Q: A beam of square cross-section is bent in the plane of its diagonal. A cut is made at top and bottom…

A: A beam of square cross-section is bent in the plane of its diagonal.A cut is made at the top and…

Q: A lever is attached to a shaft with a square shear key as shown. The force applied to the lever is P…

A:

Cables

Cables are collections of wires, alternatively referred to as a cord, connector, or plug. They are one or more wires covered in a plastic covering that allows for the transmission of power or data between devices. The earliest use of recognizable electrical cable was the early commercialized telegraph lines. These were iron-made and tedious to produce and install cabling.