column measuring

Q: Two construction methods are in use to create the stone column. Describe about these methods.

A: Stone columns are the method used for ground improvement technique. It is an alternative to pile…

Q: Explain the procedure of Lateral Pressures for Designing Bracing.

A: Lateral loads are the live loads that are applied in the horizontal direction that are parallel to…

Q: Top tie 4. Assume that the wet concrete (s.w. = 150 Ibf/ft³) behaves as a liquid. Determine the…

A: The given data is: sw=150lb/ft3 Height of concrete in form=9 ft Force on form Ft=sw×z×A

Q: The Pratt roof trusses are uniformly spaced every 4.5m. The deck, roofing material, and the purlins…

A: Average weight = 0.28 KN/m2  Snow load = 1 KN/m2  Ice load = 0.4 KN/m2  Point load at A and E =…

Q: How can the conditions of compatibility be met at the supports?

A:

Q: Problem #1 Light-grade steel channel was used as a purlin of a truss. The top chord of the truss is…

A: Given data distance between trusses = 3m purlin weight = 71 N/m Dead Load = 1200 Pa live load =…

Q: Situation #2: Given is a rectangular beam having the following parameters; fc' = 35 MPa fy = 415 MPa…

A:

Q: The gross area Ag of the column is given as 165700 mm. Assume 1.5 % of steel reinforcement, use 20…

A:

Q: H.W.11: Calculate the design bending strength for the doubly reinforced rectangular section shown…

A:

Q: A w = 40 kN/m 8 m 270 KN L Concrete: E=2.5*(10)³ N/mm² 350 mm. 550 mm

A:

Q: Gove a short description of the structures roller support and truss

A: Objective:To provide a short description of the structures roller support and truss

Q: 3.68 Determine the hydrostatic force F on the triangular gate, which is hinged at the bottom edge…

A: Width of  triangular gate=WLet d is the height of  triangular gate

Q: indeterminate? a) c) b) Hinge www

A: To check whether the structures given are indeterminate or not.   Note: As per the guidelines of…

Bars

In civil engineering, bars refer to steel reinforcement bars or rebars. These are structural members primarily used for reinforcement purposes in masonry works. A bar is characterized by its cross-sectional area, which is negligible compared to its length. Bars are usually manufactured by steel which is uniform throughout the length, or by meshing multiple steel wires. Other materials of the bar include carbon steel, glass fiber, carbon fiber, and basalt fiber. The reinforcing bars are coated with epoxy resins and other materials to enhance some of their properties including corrosion resistance.