10.8 Design and cost a crew to erect 1000 tons of steel in a midtown Manhattan site. The steel will be delivered at an approximate rate of 20 tons/day. The project must be fin- ished in 50 working days.

Q: What type of material can we use for bridge? If we using concrete then how will we improve the…

A: In construction of Bridge We can Use various Type of Material1. Steel2. Concrecte3. Stone…

Q: his is the part of the structural analysis and design process where the functional requirements of…

A: In limit state of collapse the structure is designed at ultimate load and also checked for…

Q: The quality control of concrete construction is an important part of concrete sub project.

A: CONCRETE  IS THE IMPORTANT THING IN CONSTRUCTION WORK.  CONCRETE IS PRODUCED IN BATCHES  AT SITE…

Q: Estimate the various quantity of materials required for preparation of 7m3 of set concrete (M15…

A: GradeVolume of concreteTo find: Required quantities of materials.

Q: TEN PRINCIPLES The following ten principles are taken from Abeles (Ref. 2.32) and applicable not…

A: Brief Concept Introduction- Prestressed concrete- Reinforced concrete is a structural material that…

Q: If you were a materials engineer in Ladakh, India (cold climate) and could use only one type of…

A: In cold climates like Ladakh, antifreezing admixture is to be used to reduce the freezing effect on…

Q: What is the stress in a concrete cylinder 4 inches in diameter if it is supporting a load of 20,000…

A: Load applied, P = 20000 lb Diameter of cylinder, d = 4 inch Required:Stress in cylinder

Q: According to ACI 318 determine the acceptance strength criteria based on core test and test of…

A:

Q: Propose the materials for the given problems/scenarios and support your answer. a) Type of Concrete…

A: There are many different types of concrete available. These are developed to fulfill different…

Q: 13) Welds are actually weaker than the steel members they join? T or F 14) Pumping concrete allows…

A: 13: Welding is process used to join two metal surface .  Weld are weaker than steel they join . The…

Q: Determine the flexural capacity of the following section using equations, the concrete is 40MPA, the…

A: Given:- concrete=40MPa steel=400MPa aggregate size=19mm To find:- flexural capacity

Q: Steel is often perceived to be inert and resilient. If the constructed steel is visible, it can be…

A: Solution: i) The Factors that may lead to the problem of steel is generally : 1. The corrosion of…

Q: Determine the total length of top bars from the figure shown below. Concrete cover is 40 mm. Use 16…

A: Ans - Option 1 - 11.82 m is correct.

Q: QUESTION 4 Discuss how the steel structure will contribute to sustainable development. Include the…

A: steel structure : A steel structure is a metal structure made up of structural steel* components…

Q: A young intern just joined your team on a project, he is asked to apply the following loads to…

A: Given : Types of load - Environmental load,Live load, Dead load, and Rain load. To Determine: Which…

Q: Pre-cast factory which produce different lengths of beams as follows: Length of beams 3.3 -3.7 Freq.…

A: 1)  The frequency distributation is

Q: Find the duration in days for a masonry job that has 24,000 bricks with a crew of five masons and…

A: To determine the duration of a masonry job.   Given, Number of brick unit (say N) = 24000 Number of…

Q: 30. R.C.C. was developed and first used by:

A: Rcc was developed and first used by ?

Q: A short round wood column with an actual diameter of 250 mm is to be constructed. If the failure…

A: The given data is as follows: Diameter of column=250 mmFailure stress=29.6 MPaFactor of safety=1.3

Q: Fixed buik-in or encastré beams (see Figure.2) are usually used in structure due to their high…

A: As it is not mentioned that which part is to be solved, so first three parts are solved for you.

Q: Structural Works is composed of the main construction activities:   a. Earthworks, Rebars,…

A: This question is related to Building Construction from Civil Engineering. In this question ask about…

Q: Why would you want to work on CARBON CAPTURE CONCRETE TECHNOLOGY? Why or why not? Would you…

A: Brief concept introduction- CARBON CAPTURE CONCRETE TECHNOLOGY- Up to 70% of CO2 emissions from the…

Q: Fly ash, which is among the mineral additives and used as a concrete additive; • Its use in dam…

A: The flow of fluid includes movement of an unbalanced fluid. As long as unequalled forces are in…

Q: What is double-tube core barrel ? How it is used ?

A: Core Barrels Core barrels are the devices or instruments which are used for drilling in hard,…

Q: why it is important: the strength of the concrete, the consistency of the concrete, the volume of…

A: The strength of concrete depends on the materials used in the mixing of concrete. The strength of…

Q: For long spans in bridges, using prestressed concrete is usually more suitable than regular…

A: Prestressed concrete is the special form of concrete which is prestressed during its manufacturing…

Q: hy and what would the aquatic contaminants of concern be for direct reduction steel manufacturing

A: In direct reduction steel manufacturing, iron ore is converted into steel without using a blast…

Q: ot boon sT Consider an inner beam-column joint in the ground floor roof of a eight storey building…

A:

Q: Conduct an occupational risk assessment (risk analysis) of a quarry of aggregates. Identify the…

A: Given question has asked the followings:  Conduct an occupational risk assessment of a quarry of…

Q: Advantages of ready-mixed concrete * :include •increasing labour requirement •elimination of storage…

A: Answer :- None of the above Because :-  1) No need to store construction materials at the site.  2)…

Q: What is a Pre-Fabrication Building Design? Why some Buildings should be Pre-Fab, for what purpose?…

A: There are different types of designs which are used for the construction of the building. Some of…

Q: Calculate the volume per bag of the concrete given, 175 lbs of aggregate, 31 lbs of cement and 2.2…

A: Weight of aggregates = 175 lb Weight of cement = 31 lbVolume of water = 2.2 gallons

Q: how to determine unit costs for the different grades of steel (fy= 50 , 60, 70 ksi) and concrete…

A: The cost of different grade of steel is determined on the basis of weight per unit length of steel.…

Q: Majority of BRT (Bus Rapid Transit) stations are constructed from steel. Could you please explain…

A: Let us analyse the question in step 2.

Q: Write water absorption of Aggregate: 1-Introduction. 2-Procedure. 3- discussion .

A: Introduction - Water absorption of aggregate -  it is used to understand the difference of apparent…

Q: Limestone (which consists mostly of calcite) is being quarried in one location and quartzite (which…

A: Given DataLimestone and quartzite are quarried in two different locations

Q: How much would it cost to purchase the concrete necessary to construct a six-lane highway between…

A: Given Data: The highway consists of six lanes. The width of the high including shoulder is B1= 12…

Q: Please describe the requirements for the concrete transportation.

A: Transporting the concrete mix is defined as the transferring of concrete from the mixing plant to…

Q: A double storey reinforced concrete restaurant will be built near the beach in Batu Layar, Johor.…

A: In this Question , RCC IS 456: 2000 code is used and different tables of this code is used. A/c to…

Q: Trade Cost Production Productivity Hourly Cost Unit Cost Number Activity Unit Name Hourly Rates of…

A: 1. The labour unit cost of hand trimming referring to the crew calculations is: =(no of…

Pricing Concrete Work

The concrete work in a project usually holds a high-end cost in terms of cost and value of the work. It becomes an important step in calculating the cost associated with concrete while preparing the project scale. The cost of making concrete depends on the cost of building materials, mixed materials, labor, and machinery. A concrete contractor builds structures from concrete, usually managing all the steps of the process from assembling ingredients to building a holding structure and preparing the mixture. This person or team oversees the delivery and unloading of goods to ensure that they are done properly. Nowadays, most of the concrete in the United States comes from manufacturers working abroad, usually with branches and plants within the provinces. Contributions can range from pre-mixed concrete to basic ingredients, the consumer company then mixes it. Many American-based concrete companies, however, offer concrete products, such as ballads, bricks, countertop, concrete pipe, and building products, as well as concrete construction and installation materials. This article covers both types of suppliers for this set of building materials.