Civil Engineering Calculate the value of a rivet in a lap joint used to connect two plates 12 mm cases: rivets, and (b) Hand driven rivets Determine the Power driven and hand d unwins formula

Q: 1. High-strength bolts are used in the construction of many steel structures. For a 24-mm-…

A:

Q: D = 875 kN L = 1450 kN SECT. 2 SECT.1 Square Tubing Pipe Fy = 290 mPa Do 4.8m So S, = outide…

A: Question is not clear. Please upload the full question so that the understanding in problem may…

Q: 6.8 Problem: A bracket shown in figure 6.8 carries an eccentric load of 80 kN at an eccentricity o…

A:

Q: 10 mm 20 mm The assembly above is comprised of a 10mm-diameter steel bolt, and a 20mm-diameter,…

A: option (d) or last option is correct  the explanation is given below

Q: Two plates are connected by fillet welds of size 10 mm and subjected to tension, as shown in the…

A: Given:Load carried by both the weldsLoad carried by each weld.Constant that depends upon the angle…

Q: The axial assembly consists of a solid 1.03-in.-diameter aluminum alloy [E = 9700 ksi, v = 0.24, a =…

A:

Q: (a) determine the average shear stress and shear strain in each of rubber blocks (b) determine the…

A:

Q: Calculate quantity of the Reinforcing for the beam shown in figure below. A 0.3 m 3.2 m 2016 08 @…

A:

Q: A steel rod of 30 mm diameter is used as a tie member in roof truss. It may be subjected to reversal…

A: Given-

Q: A double U-shaped butt weld is to connect two plates 200 mm (d) × 20 mm (b), as shown in the given…

A: Given: A double U-shaped butt weld is connecting two plates of dimension, b=20 mmd=200 mm Moment =…

Q: (1) Given A992 steel Ag = 10 in KLx KLy- 80, ry what is $Pa=? = 60 the design column strength

A:

Q: A double U-shaped butt weld is to connect two plates 200 mm (d) x 20 mm (b), as shown in the given…

A: A double U-shaped butt weld is connecting two plates of dimension,Moment =

Q: direction lead on the roof - 50%-2 (23) 3³/2/1/1000 =18.29 KN alculate Reaction support 1 22 Wisse 2…

A:

Q: Two plates are proposed to be jointed by welding as shown in the figure. Determine the size and…

A:

Electric Circuit and Components

An electrical circuit or electrical network is a pre-determined pathway to make the electrons flow in the desired direction. The flow of electrons will set up a current flow in the circuit. Normally, the flow of electrical current is opposite to the flow of electrons. An electron is a fundamental sub-atomic particle of an atom possessing a negative charge. To initiate the flow of current and achieve the desired output, the electrical circuit should necessarily be composed of closed pathways. The pathways are made-up of good conductors of electricity such as aluminium and copper.