Two plates are connected by fillet welds of size 10 mm and subjected to tension, as shown in the figure. The thickness of each plate is 12 mm. The yield stress and the ultimate stress of steel under tension are 250 MPa and 410 MPa, respectively. The welding is done in the workshop (partial safety factor, Ymw = 1.25). As per the Limit State Method of IS 800: 2007, what is the minimum length (in mm, rounded off to the nearest higher multiple of 5 mm) required of each weld to transmit a factored force P equal to 275 kN? 100 mm

Q: what is the moment at point O

A:

Q: What is the overall density? %

A: This question is related to the Soil Mechanics from Civil Engineering.

Q: Explain the Thickness of Layers.

A: Earth layer thickness:

Q: What is structural analysis

A: Structural analysis: It is the method which helps in determining the effects of loads on physical…

Q: what is the meaning of cohesion

A: Cohesion is nothing but attractive forces in molecules between the same substances Cohesion is…

Q: Differentiate between Directed Changes and Constructive Changes.

A: Directed Changes are the changes that are specifically directed by the owner which may or may not…

Q: How does measurements of angle and direction connects to civil engineering? How does is apply to the…

A: In civil engineering, there are many steps that are followed for construction. First, the survey of…

Q: Discuss  in  details coagulation

A: Coagulation is defined as the process of converting smaller dissolved solids into larger particles…

Q: Which of the following best describes fixed-feature space? O permanent space such as walls, floors,…

A: The objective of the problem is to identify and understand the different types of spaces that exist…

Q: Explain what is slurry-trench.

A: Slurry trenches are the walls which are cut – off type and these are used to control the gases and…

Types and properties of steel

Steel is an alloy of iron. It is formed by heating iron and combining carbon (0.1-1.7%) with it and minor amounts of other elements such sulfur,  chromium, manganese, nickel, etc. Thousands of steel grades have been published, registered, or regulated around the world, each with its chemical composition, and special numbering systems have been devised in various countries to classify the vast number of alloys.